Sensitive magnetometers that can operate in high magnetic fields are essential for detecting magnetic resonance signals originating from small ensembles of quantum spins. Such devices have potential applications in quantum technologies, in particular quantum computing. We present a novel experimental setup implementing a differential flux measurement using two DC-SQUID magnetometers. The differential measurement allows for cancellation of background flux signals while enhancing sample signal. The developed protocol uses pulsed readout which minimizes on-chip heating since sub-Kelvin temperatures are needed to preserve quantum spin coherence. Results of a proof of concept experiment are shown as well.
We report a low temperature measurement technique and magnetization data of a quantum molecular spin, by implementing an on-chip SQUID technique. This technique enables the SQUID magnetometery in high magnetic fields, up to 7 Tesla. The main challenges and the calibration process are detailed. The measurement protocol is used to observe quantum tunneling jumps of the S=10 molecular magnet, Mn12-tBuAc. The effect of transverse field on the tunneling splitting for this molecular system is addressed as well.
Precise detection of spin resonance is of paramount importance to achieve coherent spin control in quantum computing. We present a novel setup for spin resonance measurements, which uses a dc-SQUID flux detector coupled to an antenna from a coplanar waveguide. The SQUID and the waveguide are fabricated from 20~nm Nb thin film, allowing high magnetic field operation with the field applied parallel to the chip. We observe a resonance signal between the first and third excited states of Gd spins $S=7/2$ in a CaWO$_4$ crystal, relevant for state control in multi-level systems.
Scanning superconducting quantum interference device microscopy (sSQUID) is currently one of the most effective methods for direct and sensitive magnetic flux imaging on the mesoscopic scale. A SQUID-on-chip design allows integration of field coils for susceptometry in a gradiometer setup which is very desirable for measuring magnetic responses of quantum matter. However, the spatial resolution of such a design has largely been limited to micrometers due to the difficulty in approaching the sample. Here, we used electron beam lithography technology in the fabrication of the 3D nano-bridge-base…
We present a magnetic study of the Gd$_3$N@C$_{80}$ molecule, consisting of a Gd-trimer via a Nitrogen atom, encapsulated in a C$_{80}$ cage. This molecular system can be an efficient contrast agent for Magnetic Resonance Imaging (MRI) applications. We used a low-temperature technique able to detect small magnetic signals by placing the sample in the vicinity of an on-chip SQUID. The technique implemented at NHMFL has the particularity to operate in high magnetic fields of up to 7 T. The Gd$_3$N@C$_{80}$ shows a paramagnetic behavior and we find a spin transition of the Gd$_3$N structure at 1.…
We report measurements of transfer functions and flux shifts of 20 on-chip high T$_C$ DC SQUIDs half of which were made purposely geometrically asymmetric. All of these SQUIDs were fabricated using standard high T$_C$ thin film technology and they were single layer ones, having 140 nm thickness of YBa$_2$Cu$_3$O$_{7-x}$ film deposited by laser ablation onto MgO bicrystal substrates with 24$^0$ misorientation angle. For every SQUID the parameters of its intrinsic asymmetry, i. e., the density of critical current and resistivity of every junction, were measured directly and independently. We sho…
We report the fabrication and characterization of superconducting quantum interference devices (SQUIDs) based on InAs nanowires and vanadium superconducting electrodes. These mesoscopic devices are found to be extremely robust against thermal cycling and to operate up to temperatures of $\sim2.5$~K with reduced power dissipation. We show that our geometry allows to obtain nearly-symmetric devices with very large magnetic-field modulation of the critical current. All these properties make these devices attractive for on-chip quantum-circuit implementation.
A practical strategy for synchronizing the properties of compound Josephson junction rf-SQUID qubits on a multiqubit chip has been demonstrated. The impacts of small ($\sim1%$) fabrication variations in qubit inductance and critical current can be minimized by the application of a custom tuned flux offset to the CJJ structure of each qubit. This strategy allows for simultaneous synchronization of the qubit persistent current and tunnel splitting over a range of external bias parameters that is relevant for the implementation of an adiabatic quantum processor.
One of the major challenges in performing SQUID-detected Magnetic Resonance Force Microscopy (MRFM) at milliKelvin temperatures is the crosstalk between the radiofrequency (RF) pulses used for the spin manipulation and the SQUID-based detection mechanism. Here we present an approach based on balancing the flux crosstalk using an on-chip feedback coil coupled to the SQUID. This approach does not require any additional components near the location of the sample, and can therefore be applied to any SQUID-based detection scheme to cancel predictable RF interference. We demonstrate the effectivenes…
We replace the Josephson junction defining a three-junction flux qubit's properties with a tunable direct current superconducting quantum interference devices (DC-SQUID) in order to tune the qubit gap during the experiment. We observe different gaps as a function of the external magnetic pre-biasing field and the local magnetic field through the DC-SQUID controlled by high-bandwidth on chip control lines. The persistent current and gap behavior correspond to numerical simulation results. We set the sensitivity of the gap on the control lines during the sample design stage. With a tuning range …
We propose to directly and quantum-coherently couple a superconducting transmon qubit to magnons - the quanta of the collective spin excitations, in a nearby magnetic particle. The magnet's stray field couples to the qubit via a superconducting quantum interference device (SQUID). We predict a resonant qubit-magnon exchange and a nonlinear radiation-pressure interaction that are both stronger than dissipation rates and tunable by an external flux bias. We additionally demonstrate a quantum control scheme that generates qubit-magnon entanglement and magnonic Schrödinger cat states with high fid…
For gradiometric three-Josephson-junction flux qubits, we perform a systematic study on the tuning of the minimal transition frequency, the so-called qubit gap. By replacing one of the qubit's Josephson junctions by a dc SQUID, the critical current of this SQUID and, in turn, the qubit gap can be tuned in situ by a control flux threading the SQUID loop. We present spectroscopic measurements demonstrating a well-defined controllability of the qubit gap between zero and more than 10 GHz. In the future, this enables one to tune the qubit into and out of resonance with other superconducting quantu…
We have developed and tested a doubly tunable resonator, with the intention to simulate fast motion of the resonator boundaries in real space. Our device is a superconducting coplanar-waveguide half-wavelength microwave resonator, with fundamental resonant frequency ~5 GHz. Both of its ends are terminated by dc-SQUIDs, which serve as magnetic-flux-controlled inductances. Applying a flux to either SQUID allows tuning of the resonant frequency by approximately 700 MHz. By using two separate on-chip magnetic-flux lines, we modulate the SQUIDs with two tones of equal frequency, close to twice that…
We present a measurement protocol for a flux qubit coupled to a dc-Superconducting QUantum Interference Device (SQUID), representative of any two-state system with a controllable coupling to an harmonic oscillator quadrature, which consists of two steps. First, the qubit state is imprinted onto the SQUID via a very short and strong interaction. We show that at the end of this step the qubit dephases completely, although the perturbation of the measured qubit observable during this step is weak. In the second step, information about the qubit is extracted by measuring the SQUID. This step can h…
We describe an approach to the high-fidelity measurement of a superconducting qubit using an on-chip microwave photon counter. The protocol relies on the transient response of a dispersively coupled measurement resonator to map the state of the qubit to "bright" and "dark" cavity pointer states that are characterized by a large differential photon occupation. Following this mapping, we photodetect the resonator using the Josephson Photomultipler (JPM), which transitions between classically distinguishable flux states when cavity photon occupation exceeds a certain threshold. Our technique prov…
High-dimensional entangled states of light provide novel possibilities for quantum information, from fundamental tests of quantum mechanics to enhanced computation and communication protocols. In this context, the frequency degree of freedom combines the assets of robustness to propagation and easy handling with standard telecommunication components. Here we use an integrated semiconductor chip to engineer the wavefunction and exchange statistics of frequency-entangled photon pairs directly at the generation stage, without post-manipulation. Tuning the spatial properties of the pump beam allow…
We report measurements of the low temperature magnetic response of a line of 16 GaAs/GaAlAs \emph{connected} mesoscopic rings whose total length is much larger than $l_ϕ$. Using an on-chip micro-\textsc{squid} technology, we have measured a periodic response, with period $h/e$, corresponding to persistent currents in the rings of typical amplitude $0.40\pm 0.08 nA$ per ring. Direct comparison with measurements on the same rings but \emph{isolated} is presented.
We propose and analyze an all-magnetic scheme to perform a Young's double slit experiment with a micron-sized superconducting sphere of mass $\gtrsim {10}^{13}$ amu. We show that its center of mass could be prepared in a spatial quantum superposition state with an extent of the order of half a micrometer. The scheme is based on magnetically levitating the sphere above a superconducting chip and letting it skate through a static magnetic potential landscape where it interacts for short intervals with quantum circuits. In this way, a protocol for fast quantum interferometry using quantum magneto…
Spin qubits and superconducting qubits are among the promising candidates for a solid state quantum computer. For the implementation of a hybrid architecture which can profit from the advantages of either world, a coherent long-distance link is necessary that integrates and couples both qubit types on the same chip. We realize such a link with a frequency-tunable high impedance SQUID array resonator. The spin qubit is a resonant exchange qubit hosted in a GaAs triple quantum dot. It can be operated at zero magnetic field, allowing it to coexist with superconducting qubits on the same chip. We …
University of the Basque Country UPV/EHU（巴斯克大学（UPV/EHU））；IKERBASQUE, Basque Foundation for Science（巴斯克科学基金会（IKERBASQUE））；Shanghai University（上海大学）；International Center of Quantum Artificial Intelligence for Science and Technology (QuArtist)（国际科学技术量子人工智能中心（QuArtist））；IQM（IQM公司）；Universidad de Sevilla（塞维利亚大学）
We present an experimental realization of a measurement-based adaptation protocol with quantum reinforcement learning in a Rigetti cloud quantum computer. The experiment in this few-qubit superconducting chip faithfully reproduces the theoretical proposal, setting the first steps towards a semiautonomous quantum agent. This experiment paves the way towards quantum reinforcement learning with superconducting circuits.
Quantum sensing has developed into a main branch of quantum science and technology. It aims at measuring physical quantities with high resolution, sensitivity, and dynamic range. Electron spins in diamond are powerful magnetic field sensors, but their sensitivity in the microwave regime is limited to a narrow band around their resonance frequency. Here, we realize broadband microwave detection using spins in diamond interfaced with a thin-film magnet. A pump field locally converts target microwave signals to the sensor-spin frequency via the non-linear spin-wave dynamics of the magnet. Two com…
Many of the envisioned quantum photonic technologies, e.g. a quantum repeater, rely on an energy- (wavelength-) tunable source of polarization entangled photon pairs. The energy tunability is a fundamental requirement to perform two-photon-interference between different sources and to swap the entanglement. Parametric-down-conversion and four-wave-mixing sources of entangled photons have shown energy tunability, however the probabilistic nature of the sources limits their applications in complex quantum protocols. Here we report a silicon-based hybrid photonic chip where energy-tunable polariz…
