Recently, monolayer SnS, a two-dimensional group IV monochalcogenide, was grown on a mica substrate at the micrometer-size scale by the simple physical vapor deposition (PVD), resulting in the successful demonstration of its in-plane room temperature ferroelectricity. However, the reason behind the monolayer growth remains unclear because it had been considered that the SnS growth inevitably results in a multilayer thickness due to the strong interlayer interaction arising from lone pair electrons. Here, we investigate the PVD growth of monolayer SnS from two different feed powders, highly purified SnS and commercial phase-impure SnS. Contrary to expectations, it is suggested that the mica substrate surface is modified by sulfur evaporated from the Sn2S3 contaminant in the as-purchased powder and the lateral growth of monolayer SnS is facilitated due to the enhanced surface diffusion of SnS precursor molecules, unlike the growth from the highly purified powder. This insight provides a guide to identify further controllable growth conditions.
We demonstrated that chemical vapor deposition of graphene on Cu films strongly enhances their thermal diffusivity and thermal conductivity. Deposition of graphene increases the thermal conductivity of 9 micrometer (25 micrometer) thick Cu films by up to 24% (16%) near room temperature. Interestingly, the observed improvement of thermal properties of graphene coated Cu films is primarily due to changes in Cu morphology during graphene deposition and associated with it temperature treatment rather than graphene's action as an additional heat conducting channel. Enhancement of thermal properties…
2D van der Waals ferroelectric semiconductors have emerged as an attractive building block with immense potential to provide multifunctionality in nanoelectronics. Although several accomplishments have been reported in ferroelectric resistive switching for out-of-plane 2D ferroelectrics down to the monolayer, a purely in-plane ferroelectric has not been experimentally validated at the monolayer thickness. Herein, a micrometer-size monolayer SnS is grown on mica by physical vapor deposition, and in-plane ferroelectric switching is demonstrated with a two-terminal device at room temperature (RT)…
NaCl-Assisted Growth of Ferroelectric SnSe Nanosheets with Spin Glass-like Behavior
Beijing Key Laboratory of Optoelectronic Functional Materials & Micro-nano Devices, School of Physics, Renmin University of China（中国人民大学物理学院光电功能材料与微纳器件北京市重点实验室）；Key Laboratory of Quantum State Construction and Manipulation (Ministry of Education), Renmin University of China（中国人民大学量子态构建与操控教育部重点实验室）
Tin Selenide (SnSe) thin films were grown onto glass and alumina substrates by Chemical Vapor Deposition (CVD) method. The structural, micro-structural and morphological characterizations of the as grown thin films were investigated using XRD, SEM and Raman spectroscopy which reveals that the films on glass are phase pure oriented SnSe while those on Alumina are polycrystalline SnSe with SnSe2 impurity phase. The optical properties of the films grown onto glass substrate were studied by UV-vis spectroscopy. The optical band gap calculated is 1 to 1.3 eV for indirect and direct transition in fi…
Direct growth of flat micrometer-sized bilayer graphene islands in between molybdenum disulfide sheets is achieved by chemical vapor deposition of ethylene at about 800 °C. The temperature assisted decomposition of ethylene takes place mainly at molybdenum disulfide step edges. The carbon atoms intercalate at this high temperature, and during the deposition process, through defects of the molybdenum disulfide surface such as steps and wrinkles. Post growth atomic force microscopy images reveal that circular flat graphene islands have grown at a high yield. They consist of two graphene layers s…
The growth of graphene on copper by atmospheric pressure chemical vapor deposition in a system free of pumping equipment is investigated. The emphasis is put on the necessity of hydrogen presence during graphene synthesis and cooling. In the absence of hydrogen during the growth step or cooling at slow rate, weak carbon coverage, consisting mostly of oxidized and amorphous carbon, is obtained on the copper catalyst. The oxidation originates from the inevitable occurrence of residual oxidizing impurities in the reactor's atmosphere. Graphene with appreciable coverage can be grown within the vac…
The success of isolating small flakes of atomically thin layers through mechanical exfoliation has triggered enormous research interest in graphene and other two-dimensional materials. For device applications, however, controlled large-area synthesis of highly crystalline monolayers with a low density of electronically active defects is imperative. Here, we demonstrate the electrical imaging of dendritic ad-layers and grain boundaries in monolayer molybdenum disulfide (MoS2) grown by vapor transport technique using microwave impedance microscopy. The micrometer-sized precipitates in our films,…
Chemical vapor deposition (CVD) of two-dimensional (2D) materials such as monolayer MoS2 typically involves the conversion of vapor-phase precursors to a solid product in a process that may be described as a vapor-solid-solid (VSS) mode. Here, we report the first demonstration of vapor-liquid-solid (VLS) growth of monolayer MoS2 yielding highly crystalline ribbon-shaped structures with a width of a few tens of nanometers to a few micrometers. The VLS growth mode is triggered by the reaction between molybdenum oxide and sodium chloride, which results in the formation of molten Na-Mo-O droplets.…
We show that atomically thin molybdenum disulfide (MoS2) crystals can grow without any underlying substrates into free-standing atomically-thin layers, maintaining their planar 2D form. Using this property, we present a new mechanism for 2D crystal synthesis, i.e. reagent-limited nucleation near an aperture edge followed by reactions that allow crystal growth into the free-space of the aperture. Such an approach enables us, for the first time, the direct and selective growth of freestanding membranes of atomically thin MoS2 layers across micrometer-scale pre-fabricated solid-state apertures in…
Rhombohedral-stacked few-layer graphene (FLG) has been receiving an ever-increasing attention owing to its peculiar electronic properties that could lead to enticing phenomena such as superconductivity and magnetic ordering. Up to now, experimental studies on such material have been mainly limited by the difficulty in isolating it in thickness exceeding 3 atomic layers with device-compatible size. In this work, rhombohedral graphene with thickness up to 9 layers and areas up to ~50 micrometers square is grown via chemical vapor deposition (CVD) on suspended Cu foils and transferred onto target…
The ability to synthesize high-quality samples over large areas and at low cost is one of the biggest challenges during the developmental stage of any novel material. While chemical vapor deposition (CVD) methods provide a promising low-cost route for CMOS compatible, large-scale growth of materials, it often falls short of the high-quality demands in nanoelectronics and optoelectronics. We present large-scale CVD synthesis of single- and few- layered MoS2 using direct vapor-phase sulfurization of MoO2, which enables us to obtain extremely high-quality single-crystal monolayer MoS2 samples wit…
Molybdenum disulfide (MoS2) is a particularly interesting member of the family of two-dimensional (2D) materials due to its semiconducting and tunable electronic properties. Currently, the most reliable method for obtaining high-quality industrial scale amounts of 2D materials is chemical vapor deposition (CVD), which results in polycrystalline samples. As grain boundaries (GBs) are intrinsic defect lines within CVD-grown 2D materials, their atomic structure is of paramount importance. Here, through atomic-scale analysis of micrometer-long GBs, we show that covalently bound boundaries in 2D Mo…
Nanobelts, nanoribbons and other quasi-one-dimensional nanostructures formed from layered, so-called, van der Waals semiconductors have garnered much attention due to their high-performance, tunable optoelectronic properties. For layered alloys made from the gallium monochalcogenides GaS, GaSe, and GaTe, near-continuous tuning of the energy bandgap across the full composition range has been achieved in GaSe1-xSx and GaSe1-xTex alloys. Gold-catalyzed vapor-liquid-solid (VLS) growth of these alloys yields predominantly nanobelts, nanoribbons and other nanostructures for which the fast crystal gr…
Nominally undoped silicon nanowires (NW) were grown by catalytic chemical vapor deposition. The growth process was optimized to control the NWs diameters by using different Au catalyst thicknesses on amorphous SiO2, Si3N4, or crystalline-Si substrates. For SiO2 substrates an Ar plasma treatment was used to homogenize the catalyst coalescence, and thus the NWs diameter. Furthermore, planar field effect transistors (FETs) were fabricated by implementing 10 to 30 nm thin nominally undoped Si-NWs as the active region. Various silicides were investigated as Schottky-barrier source and drain contact…
Chemical vapor deposition synthesis of large domain hexagonal boron nitride (h-BN) with uniform thickness on Cu foils is of great challenge, originating from the extremely high nucleation densities and the reverse hydrogen etching competition reaction. We report herein the successful growth of wafer-scale high-quality h-BN monolayer film with the largest single crystalline domain sizes up to 72 micrometer in edge length using a folded Cu enclosure approach. The highly-confined growth space with this facile and unique approach enables the drastic decrease of nucleation centers together with the…
Transition metal dichalcogenides (TMDs) are materials that can exhibit intriguing optical properties like a change of the bandgap from indirect to direct when being thinned down to a monolayer. Well-resolved narrow excitonic resonances can be observed for such monolayers, however only for materials of sufficient crystalline quality, so far mostly available in the form of micrometer-sized flakes. A further significant improvement of optical and electrical properties can be achieved by transferring the TMD on hexagonal boron nitride (hBN). To exploit the full potential of TMDs in future applicat…
