确定用于框架的仅输出结构识别的所需加速度计的最小数目
Determining minimum number of required accelerometer for output-only structural identification of frames
摘要:
工作模态分析(OMA)的目的是根据结构在环境激励下的响应数据识别结构的模态特性。环境振动结构的模态参数包括固有频率、振型和模态阻尼比。本文采用有限元软件ANSYS对一典型框架在任意荷载作用下进行了建模,得到了框架的响应(节点加速度)。利用这些数据和MATLAB编写的程序,采用频域分解(FDD)和峰值拾取(PP)方法识别梁的模态参数(固有频率、振型),并与模态分析确定的输入输出法的结果进行对比。结果表明,三种确定框架动力特性的方法具有较好的一致性。然后,确定了所需加速度计的最小数量,记录该位置的加速度导致识别框架的所有固有频率。
英文摘要:
Operational modal analysis (OMA) aims at identifying the modal properties of a structure based on response data of the structure excited by ambient sources. Modal parameters of the ambient vibration structures consist of natural frequencies, mode shapes, and modal damping ratios. In this paper, a typical frame with arbitrary loading has been modeled in finite element software, ANSYS, and the responses (accelerations of nodes) have been achieved. By using these data and the codes written in MATLAB, the modal parameters (natural frequencies, mode shapes) of the beams are identified with FDD (Frequency Domain Decomposition) and PP (Peak Picking) methods and then justified with the results of input-output method which was determined by modal analysis. The results indicate that there is a good agreement between three methods for determining the dynamic characteristics of frames. Then, the minimum number of required accelerometer has been determined that recording the acceleration in that location leads to identifying all the natural frequencies of the frame.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。