Over the recent years, there have been many reports of achromatic metalenses and diffractive lenses. However, very few (if any) practical applications of such achromatic flat lenses have been demonstrated, which raises questions about the potential of these lenses to provide solutions for real world cases which involve broadband illumination. A recent paper placed limits on the performance of achromatic metalenses. However, is this limit also valid for a diffractive lens? Not necessarily so. In this paper we derive the limits on the performance of achromatic diffractive lenses. In particular, we show that achromatic diffractive lenses can cover a wide spectral range, limited only by loss of efficiency caused by manufacturing limitations related to feature depth and size. On the other hand, we show that achromatic diffractive lenses can provide near diffraction limited performance only at very low Fresnel numbers, i.e. they cannot provide large focusing power and broadband response simultaneously. We then go on to compare the limits of achromatic metalenses and diffractive lenses, in attempt to understand the potential of different types of flat lenses. Our findings may set the ground for better evaluation of flat lens performance, understanding of their capabilities and limitations, and for exploring novel design concepts and applications.
Compound eyes found in insects provide intriguing sources of biological inspiration for miniaturized imaging systems. Inspired by such insect eye structures, we demonstrate an ultrathin arrayed camera enabled by a flat multilevel diffractive microlens array for super-resolution visible imaging. We experimentally demonstrated that the microlens array can achieve large fill factor (hexagonal close packing with pitch=120um), thickness of 2.6um, and diffraction-limited (strehl ratio = 0.88) achromatic performance in the visible band (450nm to 650nm). We also demonstrate super-resolution imaging wi…
We demonstrate an inverse designed achromatic, flat, polarization-insensitive diffractive optic element, i.e., multilevel diffractive lens (MDL), operating across a broadband range of UV light (250 nm - 400 nm) via numerical simulations. The simulated average on-axis focusing efficiency of the MDL is optimized to be as high as ~86%. We also investigate the off-axis focusing characteristics at different incident angles of the incoming UV radiation such that the MDL has a full field of view of 30 degrees. The simulated average off-axis focusing efficiency is ~67%, which is the highest reported t…
A plethora of metalenses and diffractive lenses (flat lenses) have been demonstrated over the years. Recently, attempts have been made to stretch their performance envelope, particularly in the direction of wide-band achromatic performance. While achromatic behavior has been demonstrated, an actual improvement in imaging performance relative to conventional (non-chromatically corrected) flat lenses has not. The reasons for this are use of inappropriate performance metrics, lack of comparison to a baseline conventional design, and lack of a performance metric that combines signal-to-noise ratio…
Recently, the multilevel diffractive lenses (MDLs) have attracted considerable attention mainly due to their superior wave focusing performance; however, efforts to correct the chromatic aberration are still in progress. Here, we demonstrate the numerical design and experimental demonstration of high-numerical aperture (NA) (${\sim}0.99$), diffraction-limited achromatic multilevel diffractive lens (AMDL) operating in microwave range $10 GHz$ - $14 GHz$. A multi-objective differential evolution (MO-DE) algorithm is incorporated with the three-dimensional finite-difference time-domain (3D FDTD) …
Achromatic super-oscillatory lenses with sub-wavelength focusing
透镜对于光驱动技术至关重要。传统的镜头已经被完善，以实现近衍射极限的分辨率和最小的色差。然而，这样的透镜体积庞大，并且不能将光聚焦到小于光的半波长的热点中。最初由Toraldo di Francia提出的瞳孔滤波器可以克服传统透镜的分辨率限制，但不能进行固有的色度校正。在这里，我们报告的单元件平面透镜，不仅提供亚波长聚焦（击败传统折射透镜的衍射极限），而且将不同颜色的光聚焦到同一热点。利用超振荡的原理，我们设计并制造了一系列二元电介质和金属透镜，用于光谱的可见光和红外部分，这些透镜在硅片、二氧化硅衬底和光纤尖端上制造。这种低成本、紧凑的透镜可用于移动设备、数据存储、监视、机器人、空间应用、成像、用光制造和空间分辨非线性显微镜。
Zoom metalens doublet exhibits unprecedented advantages over the traditional zoom lens in many aspects, like ultra-compactness, CMOS compatibility, and miniaturization. However, most of them can only work in a narrow band due to chromatic aberration. Here, we numerically demonstrate a broadband achromatic zoom metalens doublet inspired by the Moiré lens principle. This design is achieved by globally optimizing the multi-wavelength phase profiles of the metalens doublet in the visible. The doublet can achieve achromatic continuous 1-10 zoom range at wavelengths of 440 nm, 540 nm, and 640 nm, fe…
Optical systems with wide field-of-views (FOV) are crucial for many applications such as high performance imaging, optical projection, augmented/virtual reality, and miniaturized medical imaging tools. Typically, aberration-free imaging with a wide FOV is achieved by stacking multiple refractive lenses (as in a "fisheye" lens), adding to the size and weight of the optical system. Single metalenses designed to have a wide FOV have the potential to replace these bulky imaging systems and, moreover, they may be dispersion engineered for spectrally broadband operation. In this paper, we derive a f…
Broadband super-resolution imaging is important in optical field. To achieve super-resolution imaging, various lenses from superlens to solid immersion lens have been designed and fabricated in recent years. However, the imaging is unsatisfactory due to low work efficiency and narrow band. In this work, we propose a solid immersion square Maxwell's fish-eye lens which realizes broadband (7-16GHz) achromatic super-resolution imaging with full width at half maximum around 0.2 wavelength based on transformation optics at microwave frequencies. In addition, a super-resolution information transmiss…
An integrated super resolution THz 3D imaging system based on a linear nonlocal achromatic freeform Bessel beam lens and high power oscillator radiator array
City University of Hong Kong（香港城市大学）；Southeast University（东南大学）
A hybrid imaging system is a simultaneous physical arrangement of a refractive lens and a multilevel phase mask (MPM) as a diffractive optical element (DOE). The favorable properties of the hybrid setup are improved extended-depth-of-field (EDoF) imaging and low chromatic aberrations. We built a fully differentiable image formation model in order to use neural network techniques to optimize imaging. At the first stage, the design framework relies on the model-based approach with numerical simulation and end-to-end joint optimization of both MPM and imaging algorithms. In the second stage, MPM …
Metalenses are ultrathin optical devices designed to replicate behavior of conventional refractive lenses, or lens arrays, utilizing nanoscale resonant structures to redirect incident light. These are often comprised of discrete meta-atoms such as nanoscale dielectric pillars. Achromatic focusing - associated with traditional multi-element refractive counterparts - is frequently attempted with single-layer metalens designs, which has proven difficult to achieve with bounded refractive indices and total lens thickness. A recent study (F.Presutti and F.Monticone, 2020) formalized this, applying …
Metasurface lenses, namely metalenses, are ultrathin planar nanostructures that are capable of manipulating the properties of incoming light and imparting lens-like wavefront to the output. Although they have shown promising potentials for the future miniaturization of optics, the chromatic aberration inherited from their diffractive nature plagues them towards many practical applications. Current solutions for creating achromatic metalenses usually require searching through a large number of meta-atoms to find designs that fulfill not only phase but phase dispersion requirements, which leads …
End-to-end optimization of diffractive optical elements (DOEs) profile through a digital differentiable model combined with computational imaging have gained an increasing attention in emerging applications due to the compactness of resultant physical setups. Despite recent works have shown the potential of this methodology to design optics, its performance in physical setups is still limited and affected by manufacturing artifacts of DOE, mismatch between simulated and resultant experimental point spread functions, and calibration errors. Additionally, the computational burden of the digital …
Recent theoretical work suggested upper bounds on the operating bandwidths of flat lenses. Here, we show how these bounds can be circumvented via a multi-level diffractive lens (MDL) of diameter = 100 mm, focal length = 200 mm, device thickness = 2.4μ m and operating bandwidth from ? = 400 nm to 800 nm. We further combine the MDL with a refractive lens to demonstrate a hybrid telescope. By appealing to coherence theory, we show that the upper bound on relative bandwidth is surprisingly independent of lens diameter or numerical aperture, but is only limited by the bandwidth of the image sensor.…
Passive mode-locking critically relies on a saturable loss mechanism to form ultrashort pulses. However, in Kerr-lens mode-locking (KLM), no actual absorption takes place, but rather losses appear due to diffraction, and actual light must escape the cavity. The Kerr-lens effect works to generate through diffraction an effective instantaneous saturable absorber that delicately depends on the interplay between the spatial and temporal profiles of the pulse. Despite the importance of KLM as a technique for generating ultrafast pulses and the fundamental role of the diffraction losses in its opera…
Multilevel diffractive lenses (MDLs) have emerged as an alternative to both conventional diffractive optical elements (DOEs) and metalenses for applications ranging from imaging to holographic and immersive displays. Recent work has shown that by harnessing structural parametric optimization of DOEs, one can design MDLs to enable multiple functionalities like achromaticity, depth of focus, wide-angle imaging, etc. with great ease in fabrication. Therefore, it becomes critical to understand how fabrication errors still do affect the performance of MDLs and numerically evaluate the trade-off bet…
In this work, we propose a new diffractive trifocal intraocular lens design with focus extension, conceived to provide a high visual performance at intermediate distances. This design is based on a fractal structure known as the "Devil's staircase". To assess its optical performance, numerical simulations have been performed with a ray tracing program using the Liou-Brennan model eye under polychromatic illumination. The simulated through the focus visual acuity was the merit function employed to test its pupil-dependence and its behavior against decentering. A qualitative assessment of the mu…
The power-balanced hybrid optical imaging system is a special design of a diffractive computational camera, introduced in this paper, with image formation by a refractive lens and Multilevel Phase Mask (MPM). This system provides a long focal depth with low chromatic aberrations thanks to MPM and a high energy light concentration due to the refractive lens. We introduce the concept of optical power balance between the lens and MPM which controls the contribution of each element to modulate the incoming light. Additional unique features of our MPM design are the inclusion of quantization of the…
Thick diffractive optical elements offer a promising way to achieve focusing or imaging at a resolution approaching 1 nm for X-ray wavelengths shorter than about 0.1 nm. Efficient focusing requires that these are fabricated with structures that vary in period and orientation so that rays obey Bragg's law over the entire lens aperture and give rise to constructive interference at the focus. Here the analysis method of ray-tracing of thick diffractive optical elements is applied to such lenses to optimise their designs and to investigate their operating and manufacturing tolerances. Expressions …
In the absence of separate apertures, the size and focal length of a lens determines both its resolution and light-collection ability defined by numerical-aperture (NA) and f/#, respectively. We utilize free-form broadband-diffractive-optical elements (BDOEs) to create flat lenses that decouple NA from f#, whereby the resolution of the lens may be chosen independently from its light-collection ability. Specifically, we designed, fabricated and characterized three BDOE lenses operating in the visible band (450nm-750nm), each with f/11.25, but with NAs of 0.00075, 0.0067 and 0.054, respectively.…
We designed, fabricated and characterized a flat multi-level diffractive lens (MDL) comprised of only silicon with diameter = 15.2mm, focal length of 19mm, and operating over the longwave infrared (LWIR) spectrum of 8um to 14um. We experimentally demonstrated field of view of 46deg, depth of focus >7mm and wavelength-averaged Strehl ratio of 0.46. All these metrics were comparable to those of a conventional refractive lens. The active device thickness is only 8um and its weight (including the silicon substrate) is less than 0.2g.
We analyze the dispersion property of low-index thin lenses by using scalar diffraction and finite difference time domain (FDTD) methods. We compare the dispersion results obtained by using these methods with reported experimental results, and the well-known analytical formula for focal length (f) of diffractive lenses as a function of wavelength (λ),f(λ)=(f_0 λ_0)/λ,where f_0 is the designed focal length for wavelength λ_0. We show that when the analytical formula is applied to thin flat lenses with low-refractive index, the results are accurate for small numerical aperture (NA) up to 0.2. Fo…
Wide field-of-view (FOV) optics are widely used in various imaging, display, and sensing applications. While conventional wide FOV optics rely on cascading multiple elements to suppress coma and other aberrations, it has recently been demonstrated that diffraction-limited, near-180 degree FOV operation can be achieved with a single-piece flat fisheye lens designed via iterative numerical optimization [Nano Lett. 20, 7429(2020)]. Here we derive an analytical solution to enable computationally efficient design of flat wide FOV lenses based on metasurfaces or diffractive optical elements (DOEs). …
We experimentally demonstrate imaging in the longwave-infrared (LWIR) spectral band (8um to 12um) using a single polymer flat lens based upon multi-level diffractive optics. The device thickness is only 10μm, and chromatic aberrations are corrected over the entire LWIR band with one surface. Due to the drastic reduction in device thickness, we are able to utilize polymers with absorption in the LWIR, allowing for inexpensive manufacturing via imprint lithography. The weight of our lens is less than 100 times those of comparable refractive lenses. We fabricated and characterized two different f…
In principle, diffractive optics, particularly Phase Fresnel Lenses (PFLs), offer the ability to construct large, diffraction-limited, and highly efficient X-ray/$γ$-ray telescopes, leading to dramatic improvement in angular resolution and photon flux sensitivity. As the diffraction limit improves with increasing photon energy, gamma-ray astronomy would offer the best angular resolution over the entire electromagnetic spectrum. A major improvement in source sensitivity would be achieved if meter-size PFLs can be constructed, as the entire area of these optics focuses photons. We have fabricate…
