3D-IC嵌入式通道液体冷却的数值分析
Numerical Analysis of Liquid Cooling of 3D-ICs Using Embedded Channels
摘要:
热点被认为是3D-IC的高集成密度的不可避免的后果之一。消除热点需要采用有效的冷却技术。使用嵌入式通道,液体冷却系统可以设计为向芯片的每个点提供适量的冷却剂。在这项研究中,数值分析是用来研究一个20 W的热点使用嵌入式通道采用三种冷却剂:水,氟利昂(R22),液氮(LN)的冷却。热管理和应力的调查表明,虽然LN提供最低的工作温度(164 K),它会导致最高的应力(355 MPa)在100 mm/s的入口速度。研究还表明,冷却剂输送使用平行通道的结果在很大程度上的局部温度和应力的变化。这种应力变化可能形成高应力点,这可能导致电路故障、性能退化或产量降低。因此,冷却系统和芯片制造的设计应确保消除高应力热点。
英文摘要:
Hot-spots are considered among the unavoidable consequences of the high integration density of 3D-ICs. Eliminating hot spots requires employing efficient cooling techniques. Using embedded channels, liquid cooling systems can be designed to deliver the right amount of coolant to each spot of the chip. In this study, numerical analysis is used to investigate the cooling of a 20 W hot spot using embedded channels employing three coolants: water, Freon (R22), and liquid nitrogen (LN). The investigation of thermal management and stress show that, although LN provides the lowest operating temperature (164 K), it causes the highest stress (355 MPa) at 100 mm/s inlet velocity. The study also shows that, coolant delivery using parallel channels results in a wide variation of local temperatures and stress. This stress variation may form high-stress spots, which may cause circuit failure, performance degradation, or yield reduction. Therefore, cooling systems and chip fabrication should be designed to ensure the elimination of high-stress hot spots.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。