液冷3D-IC的热应力分析
Thermal Stress Analysis of Liquid-Cooled 3D-ICs
摘要:
已知的是,如果3D-IC没有被冷却到合理的操作温度,则3D-IC遭受可以达到数千度的热点温度。热点问题不仅限于IC的高温;即使在冷却芯片后,热应力也会造成严重的问题。本研究探讨热应力所造成的3D-IC热点与20 W的功耗。使用SiO2和金刚石冷却块冷却IC。该研究使用三种冷却液体进行:水、氟利昂(R22)和液氮(LN)。正如预期的那样,该研究表明,由于芯片温度升高到高于室温的值,芯片上的金属层受到高热应力的影响。还注意到,如果使用LN进行冷却,则应力变得更严重。事实上,应力超过了铝的最大抗拉强度,这意味着芯片失效。这表明冷却3D-IC可能无法确保可接受的操作或可靠性。必须在高温和低温下研究热应力,以确保高性能和可接受的可靠性。
英文摘要:
It is known that 3D-ICs suffer from hot spot temperatures that can reach thousands of degrees, if they are not cooled to reasonable operating temperatures. The problem of hot spots is not limited to the high temperatures of the IC; thermal stress can also pose severe problems, even after cooling the chip. This study investigates thermal stress resulting from a 3D-IC hot spot with 20 W power dissipation. The IC is cooled using SiO2 and diamond cooling blocks. The study is performed using three cooling liquids: water, Freon (R22), and Liquid Nitrogen (LN). As expected, the study shows that metal layers on the chip suffer from high thermal stress due to rising the chip temperature to values higher than the room temperature. It is also noticed that the stress becomes more severe, if cooling is done using LN. In fact, the stress exceeded the maximum tensile strength of aluminum, which means failure of the chip. This indicates that cooling 3D-IC may not ensure acceptable operation or reliability. Thermal stress must be investigated at both high and low temperatures to ensure high performance and acceptable reliability.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。