TMR应用中面积优化的准延迟不敏感多数表决器
Area Optimized Quasi Delay Insensitive Majority Voter for TMR Applications
摘要:
任务关键型和安全关键型应用通常倾向于结合三重模块冗余(TMR)以在其物理实现中嵌入容错。在TMR实现中,可以是电路或系统的原始功能块和功能块的两个精确副本用于成功地克服在例行操作期间任意功能块的任何临时故障或永久故障。功能块的相应输出使用3输入多数表决器进行多数表决,其输出定义TMR实现的输出。因此,3输入多数表决器形成TMR实现的重要组成部分。许多同步多数表决器和异步非延迟不敏感多数表决器已在文献中。最近,准延迟不敏感(QDI)异步多数表决器的TMR应用也在文献中讨论。在这方面,本文提出了一种新的QDI异步多数表决器的TMR应用程序,这是更好地优化面积相比,现有的QDI多数表决器。与现有的最佳QDI多数表决器相比,所提出的QDI多数表决器需要少30.2%的面积,这对于资源受限的容错应用可能是有用的。使用32/28 nm互补金属氧化物半导体(CMOS)工艺来实现示例QDI TMR电路。数据编码采用对时延不敏感的双轨码,数据通信采用四相归零和归一握手协议。
英文摘要:
Mission-critical and safety-critical applications generally tend to incorporate triple modular redundancy (TMR) to embed fault tolerance in their physical implementations. In a TMR realization, an original function block, which may be a circuit or a system, and two exact copies of the function block are used to successfully overcome any temporary fault or permanent failure of an arbitrary function block during the routine operation. The corresponding outputs of the function blocks are majority voted using 3-input majority voters whose outputs define the outputs of a TMR realization. Hence, a 3-input majority voter forms an important component of a TMR realization. Many synchronous majority voters and an asynchronous non-delay insensitive majority voter have been presented in the literature. Recently, quasi delay insensitive (QDI) asynchronous majority voters for TMR applications were also discussed in the literature. In this regard, this paper presents a new QDI asynchronous majority voter for TMR applications, which is better optimized in area compared to the existing QDI majority voters. The proposed QDI majority voter requires 30.2% less area compared to the best of the existing QDI majority voters, and this could be useful for resource-constrained fault tolerance applications. The example QDI TMR circuits were implemented using a 32/28nm complementary metal oxide semiconductor (CMOS) process. The delay insensitive dual rail code was used for data encoding, and 4-phase return-to-zero and return-to-one handshake protocols were used for data communication.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。