arXivDaily arXiv每日学术速递 周一至周五更新
arXiv 2007.07457physics.app-ph
收藏

不同几何尺寸和流动条件下潜热储能系统的CFD分析

CFD Analysis of Latent Heat Energy Storage System with Different Geometric Configurations and Flow Conditions

Pushpendra Kumar Shukla, P. Anil Kishan

摘要:

潜热储存技术正在世界范围内被用于弥合能源供应和需求之间的差距。材料在充电过程(熔化)中储存能量,在放电过程(固化)中释放能量。尽管具有诸如高存储能量密度的各种优点,但其受到以下事实的影响:通常使用的大多数相变材料(PCM)具有非常低的热导率,因此具有非常慢的充电/放电时间。在目前的工作中,壳管式换热器与相变材料的壳侧和传热流体的管侧被认为是。研究了传热流体流量和入口温度对熔化和凝固时间的影响。在PCM的熔化中遇到的主要困难是在装料过程中固体(未熔化的)部分在底部积聚,而在卸料过程中液体部分保留在顶部,这在很大程度上降低了系统的效率。在这项研究中,试图提高系统的效率,考虑两种配置(双管和三管)的管壳式换热器,它被发现后一种情况下具有更好的性能。

英文摘要:

The Latent heat storage technology is being used worldwide to bridge the gap between supply and demand of energy. The material store energy during the charging process (melting) and releases energy during the discharging process (solidification). In spite of having various advantages such as high storage energy density, it suffers from the fact that most Phase Change Materials (PCMs) commonly used have a very low thermal conductivity, hence, very slow charging /discharging times. In the current work, a shell and tube type heat exchanger with phase change material on the shell side and heat transfer fluid on the tube side are considered. The effect of flow rate and inlet temperature of heat transfer fluid on melting and solidification times are investigated with single and double pass (counter and parallel) arrangements of Heat Transfer Fluid (HTF). The major difficulty encountered in the melting of the PCM is the accumulation of solid (unmelted) part at the bottom during the charging process, while the liquid part remains at the top during the discharging process, which decreases the efficiency of the system to quite a great extent. In this study, an attempt has been made to improve the efficiency of the system by considering two configurations (double and triple tube) of the shell and tube heat exchanger and it is found that the latter case has better performance.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑