Photodetectors are key optoelectronic building blocks performing the essential optical-to-electrical signal conversion, and unlike solar cells, operate at a specific wavelength and at high signal or sensory speeds. Towards achieving high detector performance, device physics, however, places a fundamental limit of the achievable detector sensitivity, such as responsivity and gain, when simultaneously aimed to increasing the detectors temporal response, speed, known as the gain-bandwidth product (GBP). While detectors GBP has been increasing in recent years, the average GBP is still relatively modest (~10^6-10^7 Hz-A/W). Here we discuss photodetector performance limits and opportunities based on arguments from scaling length theory relating photocarrier channel length, mobility, electrical resistance with optical waveguide mode constrains. We show that short-channel detectors are synergistic with slot-waveguide approaches, and when combined, offer a high-degree of detector design synergy especially for the class of nanometer-thin materials. Indeed, we find that two dimensional material-based detectors are not limited by their low mobility and can, in principle, allow for 100 GHz fast response rates. However, contact resistance is still a challenge for such thin materials, a research topic that is still not addressed yet. An interim solution is to utilize heterojunction approaches for functionality separation. Nonetheless, atomistically- and nanometer-thin materials used in such next-generation scaling length theory based detectors also demand high material quality and monolithic integration strategies into photonic circuits including foundry-near processes. As it stands, this letter aims to guide the community if achieving the next generation photodetectors aiming for a performance target of GBP = 10^12 Hz-A/W.
Roadmap on UV-C photodetectors: materials, applications and industry perspectives
University of Strathclyde(斯特拉斯克莱德大学);Swansea University(斯旺西大学);sglux GmbH(sglux有限公司);Jaypee Institute of Information Technology(贾伊皮信息理工学院);National Institute for Materials Science(国家材料研究所);Université Grenoble Alpes(格勒诺布尔阿尔卑斯大学);Jilin University(吉林大学);Dalian University of Technology(大连理工大学);Fudan University(复旦大学);Nanjing University of Posts and Telecommunication (NJUPT)(南京邮电大学);Lanzhou University(兰州大学);National Physical Laboratory(国家物理实验室);The Open University(开放大学);Heriot Watt University(赫瑞-瓦特大学);Scottish Water(苏格兰水务);Badger Meter UK Ltd(百得计器英国有限公司);Badger Meter Austria GmbH(百得计器奥地利有限公司);Universidad Complutense de Madrid(马德里康普顿斯大学);Berdyansk State Pedagogical University(别尔江斯克国立师范学院);Institute of Solid State Physics, University of Latvia(拉脱维亚大学固体物理研究所);Federal University of São Carlos(圣卡洛斯联邦大学)
Fast and Highly Sensitive Ionic Polymer Gated WS$_2$-Graphene Photodetectors
石墨烯与异质结构光电探测器中的半导体材料的组合使得能够使用微米级电子器件放大检测飞秒瓦光信号。目前,这种检测器的速度受到长寿命电荷陷阱和不切实际的策略(例如,使用大的栅极电压脉冲)的限制,已经采用这些策略来实现适合于诸如视频帧速率成像的应用的带宽。在这里,我们报告了封装在离子聚合物中的原子薄石墨烯-WS $_2$异质结构光电探测器,它独特地能够在高达1.5 kHz的带宽下工作,同时保持与$10^6$一样大的内部增益。高度移动的离子和纳米级德拜长度的离子聚合物用于筛选电荷陷阱,并在与WS $_2$的界面处在前所未有的范围内调节石墨烯的费米能级。我们观察到一个响应度$R=10^6$ A W $^{-1}$和探测度$D^*=3.8\times10^{11}$ Jones,接近单光子计数器。高响应度和快速响应时间的组合使这些光电探测器适合视频帧速率成像应用。
Growth of Highly Conductive PtSe2 Films Controlled by Raman Metrics for High-Frequency Photodetectors and Optoelectronic Mixers at 1.55 μm
Thales Research & Technology(泰雷兹研究与技术);Laboratoire de Physique de l'École Normale Supérieure(巴黎高等师范学校物理实验室);CEA Grenoble(法国原子能和替代能源委员会格勒诺布尔中心);Center for Nanoscience and Nanotechnology(纳米科学与技术中心);Ecole Polytechnique(巴黎综合理工学院)