Strain engineering, which aims to tune the bandgap of a semiconductor by the application of strain, has emerged as an interesting way to control the electrical and optical properties of two-dimensional (2D) materials. Apart from the changes in the intrinsic properties of 2D materials, the application of strain can be also used to modify the characteristics of devices based on them. In this work, we study flexible and transparent photodetectors based on single-layer MoS2 under the application of biaxial strain. We find that by controlling the level of strain, we can tune the photoresponsivity (by 2-3 orders of magnitude), the response time (from <80 ms to 1.5 s) and the spectral bandwidth (with a gauge factor of 135 meV/% or 58 nm/%) of the device.
Paper offers a low-cost and widely available substrate for electronics. It posses alternative characteristics to silicon, as it shows low density and high-flexibility, together with biodegradability. Solution processable materials, such as hybrid perovskites, also present light and flexible features, together with a huge tunability of the material composition with varying optical properties. In this study, we combine paper substrates with halide-mixed perovskites for the creation of low-cost and easy-to-fabricate perovskite-on-paper photodetectors with a broadband-tunable spectral response. Fr…
The ultrathin nature and dangling bonds free surface of two-dimensional (2D) semiconductors allow for significant modifications of their band gap through strain engineering. Here, thin InSe photodetector devices are biaxially stretched, finding, a strong band gap tunability upon strain. The applied biaxial strain is controlled through the substrate expansion upon temperature increase and the effective strain transfer from the substrate to the thin InSe is confirmed by Raman spectroscopy. The band gap change upon biaxial strain is determined through photoluminescence measurements, finding a gau…
High performance Terahertz (THz) photodetector has drawn wide attention and got great improvement due to its significant application in biomedical, astrophysics, nondestructive inspection, 6th generation communication system as well as national security application. Here we demonstrate a novel broadband photon-type THz/infrared (IR) photodetector based on the GaAs/AlxGa1-xAs ratchet structure. This kind of photodetector realizes a THz photon-response based on the electrically pumped hot hole injection and overcomes the internal workfunction related spectral response limit. An ultrabroadband ph…
In integrated photonics, specific wavelengths are preferred such as 1550 nm due to low-loss transmission and the availability of optical gain in this spectral region. For chip-based photodetectors, layered two-dimensional (2D) materials bear scientific and technologically-relevant properties leading to strong light-matter-interaction devices due to effects such as reduced coulomb screening or excitonic states. However, no efficient photodetector in the telecommunication C-band using 2D materials has been realized yet. Here, we demonstrate a MoTe2-based photodetector featuring strong photorespo…
Strain engineering has been a ubiquitous paradigm to tailor the electronic band structure and harness the associated new or enhanced fundamental properties in semiconductors. In this regard, semiconductor membranes emerged as a versatile class of nanoscale materials to control lattice strain and engineer complex heterostructures leading to the development of a variety of innovative applications. Herein we exploit this quasi-two-dimensional platform to tune simultaneously the lattice parameter and bandgap energy in group IV GeSn semiconductor alloys. As Sn content is increased to reach a direct…
Strained layer superlattice (SLS) material system is a dynamic and relatively new material for infrared detection. Large format, small-pitch and low-cost focal plane arrays (FPAs) with more pixels are in demand for different applications. For the current SLS based FPAs mesa etching are used to define the pixels. For those SLS based FPAs with scaled pixel size making the mesa structures can be challenging due to the need for deep etch, and then passivation process. One of the possible solutions to address this issue is to consider a planar structure and avoiding the mesa-isolation etching or co…
Metamaterials have recently established a new paradigm for enhanced light absorption in state-of-the-art photodetectors. Here, we demonstrate broadband, highly efficient, polarization-insensitive, and gate-tunable photodetection at room temperature in a novel metadevice based on gold/graphene Sierpinski carpet plasmonic fractals. We observed an unprecedented internal quantum efficiency up to 100% from the near-infrared to the visible range with an upper bound of optical detectivity of $10^{11}$ Jones and a gain up to $10^{6}$, which is a fingerprint of multiple hot carriers photogenerated in g…
We demonstrate a low noise short wavelength infrared (SWIR) Sb based type II superlattice (T2SL) avalanche photodiodes (APD). The SWIR GaSb/(AlAsSb/GaSb) APD structure was designed based on impact ionization engineering and grown by molecular beam epitaxy on GaSb substrate. At room temperature, the device exhibits a 50 % cut-off wavelength of 1.74 micron. The device revealed to have electron dominated avalanching mechanism with a gain value of 48 at room temperature. The electron and hole impact ionization coefficients were calculated and compared to give better prospect of the performance of …
Visible and infrared photons can be detected with a broadband response via the internal photoeffect. By using plasmonic nanostructures, i.e. nanoantennas, wavelength selectivity can be introduced to such detectors through geometry-dependent resonances. Also, additional functionality, like electronic responsivity switching and polarization detection have been realized. However, previous devices consisted of large arrays of nanostructures to achieve detectable photocurrents. Here we show that this concept can be scaled down to a single antenna level, resulting in detector dimensions well below t…
In two-dimensional materials research, oxidation is usually considered as a common source for the degradation of electronic and optoelectronic devices or even device failure. However, in some cases a controlled oxidation can open the possibility to widely tune the band structure of 2D materials. In particular, we demonstrate the controlled oxidation of titanium trisulfide (TiS$_3$), a layered semiconductor that has attracted much attention recently thanks to its quasi-1D electronic and optoelectronic properties and its direct bandgap of 1.1 eV. Heating TiS$_3$ in air above 300 °C gradually con…
Photogalvanic effect (PGE) occurring in noncentrosymmetric materials enables the generation of the open-circuit voltage that is much larger than the bandgap, making it rather attractive in solar cells. However, the magnitude of the PGE photocurrent is usually small, which severely hampers its practical application. Here we propose a mechanism to largely enhance the PGE photocurrent by mechanical strain based on the quantum transport simulations for the two-dimensional nickel-phosphorene-nickel photodetector. Broadband PGE photocurrent governed by the Cs noncentrosymmetry is generated at zero b…
There are a number of theoretical proposals based on strain engineering of graphene and other two-dimensional materials, however purely mechanical control of strain fields in these systems has remained a major challenge. The two approaches mostly used so far either couple the electrical and mechanical properties of the system simultaneously or introduce some unwanted disturbances due to the substrate. Here, we report on silicon micro-machined comb-drive actuators to controllably and reproducibly induce strain in a suspended graphene sheet, in an entirely mechanical way. We use spatially resolv…
We present a study of GaN single-nanowire ultraviolet photodetectors with an embedded GaN/AlN superlattice. The heterostructure dimensions and doping profile were designed in such a way that the application of positive or negative bias leads to an enhancement of the collection of photogenerated carriers from the GaN/AlN superlattice or from the GaN base, respectively, as confirmed by electron beam-induced current measurements. The devices display enhanced response in the ultraviolet A ($\approx$ 330-360 nm) / B ($\approx$ 280-330 nm) spectral windows under positive/negative bias. The result is…
Response to uniaxial stress has become a major probe of electronic materials. Tuneable uniaxial stress may be applied using piezoelectric actuators, and so far two methods have been developed to couple samples to actuators. In one, actuators apply force along the length of a free, beam-like sample, allowing very large strains to be achieved. In the other, samples are affixed directly to piezoelectric actuators, allowing study of mechanically delicate materials. Here, we describe an approach that merges the two: thin samples are affixed to a substrate, that is then pressurized uniaxially using …
Local strain engineering is an exciting approach to tune the optoelectronic properties of materials. Two dimensional (2D) materials such as 2D transition metal dichalcogenides (TMDs) are particularly well suited for this purpose because they have high flexibility and they can withstand high deformations before rupture. Local strain engineering in 2D TMDs is achieved via strained wrinkles. Wrinkles on thick layers of TMDs are reported to show interesting photoluminescence enhancement due to bandgap modulation and funneling effect. However, the wrinkles in ultrathin TMDs have not been investigat…
This paper presents an electromechanical analysis of the nonlinear static response and the superimposed small-amplitude wave characteristics in an infinite periodic compressible dielectric elastomer (DE) laminate subjected to electrostatic excitations and prestress in the thickness direction. The enriched Gent material model is employed to account for the effects of strain stiffening and electrostriction of the DE laminate. The theory of nonlinear electroelasticity and related linearized incremental theory are exploited to derive the governing equations of nonlinear response and the dispersion…
