MoS_2 in its two-dimensional (2D) form is known to exhibit many fundamentally interesting and technologically important properties. One of the most popular routes to form extensive amount of such 2D samples is the chemical exfoliation route. However, the nature and origin of the specific polymorph of MoS_2 primarily responsible for such spectacular properties has remained controversial with claims of both T and T' phases as well as metallic and semiconducting natures. We show that a comprehensive scrutiny of the available literature data of Raman spectra from such samples allow little scope for such ambiguities, providing overwhelming evidence for the formation of the T' phase as the dominant metastable state in all such samples. We also explain that this small band-gap T' phase may attain substantial conductivity due to thermal and chemical doping of charge-carriers, explaining the contradictory claims of metallic and semiconducting nature of such samples, thereby attaining a consistent view of all reports available so far.
The ability to efficiently evolve hydrogen via electrocatalysis at low overpotentials holds tremendous promise for clean energy. Hydrogen evolution reaction (HER) can be easily achieved from water if a voltage above the thermodynamic potential of the HER is applied. Large overpotentials are energetically inefficient but can be lowered with expensive platinum based catalysts. Replacement of Pt with inexpensive, earth abundant electrocatalysts would be significantly beneficial for clean and efficient hydrogen evolution. Towards this end, promising HER characteristics have been reported using 2H …
Chemical exfoliation of MoS$_2$ via Li-intercalation route has led to many desirable properties and spectacular applications due to the presence of a metastable state in addition to the stable H phase. However, the nature of the specific metastable phase formed, and its basic charge conduction properties have remained controversial. Using spatially resolved Raman spectroscopy (~1 micrometer resolution) and photoelectron spectroscopy (~120 nm resolution), we probe such chemically exfoliated MoS$_2$ samples in comparison to a mechanically exfoliated H phase sample and confirm that the dominant m…
We report the realization of field-effect transistors (FETs) made with chemically synthesized multilayer 2D crystal semiconductor MoS2. Electrical properties such as the FET mobility, subthreshold swing, on/off ratio, and contact resistance of chemically synthesized (s-) MoS2 are indistinguishable from that of mechanically exfoliated (x-) MoS2, however flat-band voltages are different, possibly due to polar chemical residues originating in the transfer process. Electron diffraction studies and Raman spectroscopy show the structural similarity of s-MoS2 to x-MoS2. This initial report on the beh…
Chemically and mechanically exfoliated MoS$_2$ single-layer samples have substantially different properties. While mechanically exfoliated single-layers are mono-phase (1H polytype with Mo in trigonal prismatic coordination), the chemically exfoliated samples show coexistence of three different phases, 1H, 1T (Mo in octahedral coordination) and 1T$^{'}$ (a distorted $2\times 1$ 1T-superstructure). By using first-principles calculations, we investigate the energetics and the dynamical stability of the three phases. We show that the 1H phase is the most stable one, while the metallic 1T phase, s…
Graphene has attracted much attention due to its interesting properties and potential applications. Chemical exfoliation methods have been developed to make graphene recently, aimed at large-scale assembly and applications such as composites and Li ion batteries. Although efficient, the chemical exfoliation methods involve oxidation of graphene and introduce defects in the as-made sheets. Hydrazine reduction at 100 has shown to partially restore the structure and conductance of graphite oxide. However, the reduced GO still shows strong defect peaks in Raman spectra with higher resistivity than…
We report on the preparation of inks containing fillers derived from quasi-two-dimensional charge-density-wave materials, their application for inkjet printing, and the evaluation of their electronic properties in printed thin film form. The inks were prepared by liquid-phase exfoliation of CVT-grown 1T-TaS$_2$ crystals to produce fillers with nm-scale thickness and um-scale lateral dimensions. Exfoliated 1T-TaS$_2$ was dispersed in a mixture of isopropyl alcohol and ethylene glycol to allow fine-tuning of their thermo-physical properties for inkjet printing. The temperature-dependent electric…
Strong light-matter interactions in layered transition metal dichalcogenides (TMDs) open up vivid possibilities for novel exciton-based devices. The optical properties of TMDs are dominated mostly by the tightly bound excitons and more complex quasiparticles, the biexcitons. Instead of physically exfoliated monolayers, the solvent-mediated chemical exfoliation of these 2D crystals is a cost-effective, large-scale production method suitable for real device applications. We explore the ultrafast excitonic processes in WS$_{2}$ dispersion using broadband femtosecond pump-probe spectroscopy at roo…
Functionalization of atomically thin nanomaterials enables the tailoring of their chemical, optical, and electronic properties. Exfoliated black phosphorus, a layered two-dimensional semiconductor exhibiting favorable charge carrier mobility, tunable bandgap, and highly anisotropic properties, is chemically reactive and degrades rapidly in ambient conditions. In contrast, here we show that covalent aryl diazonium functionalization suppresses the chemical degradation of exfoliated black phosphorus even following weeks of ambient exposure. This chemical modification scheme spontaneously forms ph…
We study the vibrational, magnetic and transport properties of Few Layer Graphene (FLG) using Raman and electron spin resonance spectroscopy and microwave conductivity measurements. FLG samples were produced using wet chemical exfoliation with different post-processing, namely ultrasound treatment, shear mixing, and magnetic stirring. Raman spectroscopy shows a low intensity D mode which attests a high sample quality. The G mode is present at $1580$ cm$^{-1}$ as expected for graphene. The 2D mode consists of 2 components with varying intensities among the different samples. This is assigned to…
A trigonal phase existing only as small patches on chemically exfoliated few layer, thermodynamically stable 1H phase of MoS2 is believed to influence critically properties of MoS2 based devices. This phase has been most often attributed to the metallic 1T phase. We investigate the electronic structure of chemically exfoliated MoS2 few layered systems using spatially resolved (lesser than 120 nm resolution) photoemission spectroscopy and Raman spectroscopy in conjunction with state-of-the-art electronic structure calculations. On the basis of these results, we establish that the ground state o…
The emerging Au-assisted exfoliation technique provides a wealth of large-area and high-quality ultrathin two-dimensional (2D) materials compared with traditional tape-based exfoliation. Fast, damage-free, and reliable determination of the layer number of such 2D films is essential to study layer-dependent physics and promote device applications. Here, an optical method has been developed for simple, high throughput, and accurate determination of the layer number for Au-assisted exfoliated MoS$_2$ and WS$_2$ films in a broad thickness range. The method is based on quantitative analysis of laye…
The excitonic homogeneous linewidth of an exfoliated monolayer MoSe$_2$ encapsulated in hexagonal boron nitride is directly measured using multidimensional coherent spectroscopy with micron spatial resolution. The linewidth is 0.26 $\pm$ 0.02 meV, corresponding to a dephasing time $T_2 \approx$ 2.5 ps, which is almost half the narrowest reported values for non-encapsulated MoSe$_2$ flakes. We attribute the narrowed linewidth to Coulomb screening by the encapsulated material and suppression of non-radiative processes. Through direct measurements of encapsulated and non-encapsulated monolayers, …
Detailed high pressure Resonance Raman ($RR$) Spectroscopy and X-ray diffraction ($XRD$) studies are carried out on 3-4 layered $MoSe_2$ obtained by liquid exfoliation. Analysis of ambient $XRD$ pattern and $RR$ spectra indicate the presence of a triclinic phase along with its parent hexagonal phase. Pressure evolution of prominent Raman modes and their full width at half maximum ($FWHM$) show slope changes at about 13 GPa and 33 GPa, respectively. Slope change in the linear behavior of reduced pressure ($H$) with respect to Eulerian strain ($f_E$) is observed at about 13 GPa. A minimum in the…
Gold-assisted mechanical exfoliation currently represents a promising method to separate ultra-large (cm-scale) transition metal dichalcogenides (TMDs) monolayers (1L) with excellent electronic and optical properties from the parent van der Waals (vdW) crystals. The strong interaction between $Au$ and chalcogen atoms is the key to achieve this nearly perfect 1L exfoliation yield. On the other hand, it may affect significantly the doping and strain of 1L TMDs in contact with Au. In this paper, we systematically investigated the morphology, strain, doping, and electrical properties of large area…
MoS2 is a highly interesting material system, which exhibits a crossover from an indirect band gap in the bulk crystal to a direct gap for single layers. Here, we perform a direct comparison between large-area MoS$_2$ films grown by chemical vapor deposition (CVD) and MoS$_2$ flakes prepared by mechanical exfoliation from natural bulk crystal. Raman spectroscopy measurements show differences between the in-plane and out-of-plane phonon mode positions in CVD-grown and exfoliated MoS$_2$. Photoluminescence (PL) mapping reveals large regions in the CVD-grown films that emit strong PL at room temp…
Exciton intervalley scattering, annihilation and relaxation dynamics, and diffusive transport in a monolayer transition metal dichalcogenides are central to the functionality of devices based on them. This motivated us to investigate these properties in exfoliated high-quality monolayer MoSe2 using heterodyned nonlinear four-wave-mixing transient grating spectroscopy. While free exciton excitations are found to be long-lived (~230 ps), an extremely fast intervalley scattering ( less than 120 fs) is observed leading to a negligible valley polarization, consistent with steady state photoluminesc…
We investigate the thermal properties of these Zirconium based materials using confocal Raman spectroscopy. We observed 2 different and distinctive Raman signatures for exfoliated ZrX2 (where X = S or Se). These Raman modes generally depend on the shape of the exfoliated nanosheets, regardless of the incident laser polarization. These 2 shapes are divided into 2D- ZrX2 and quasi 1D- ZrX2. For 2D- ZrX2, Raman modes are in alignment with those reported in literature. However, for quasi 1D-ZrX2, we show that Raman modes are identical to exfoliated ZrX3 nanosheets, indicating a major lattice trans…
In this paper we demonstrated the thermal Atomic Layer Deposition (ALD) growth at 250 °C of highly homogeneous and ultra-thin ($\approx$ 3.6 nm) $Al_2O_3$ films with excellent insulating properties directly onto a monolayer (1L) $MoS_2$ membrane exfoliated on gold. Differently than in the case of 1L $MoS_2$ supported by a common insulating substrate ($Al_2O_3/Si$), a better nucleation process of the high-k film was observed on the 1L $MoS_2/Au$ system since the ALD early stages. Atomic force microscopy analyses showed a $\approx 50\%$ $Al_2O_3$ surface coverage just after 10 ALD cycles, its in…
Innovative applications based on two-dimensional solids require cost-effective fabrication processes resulting in large areas of high quality materials. Chemical vapour deposition is among the most promising methods to fulfill these requirements. However, for 2D materials prepared in this way it is generally assumed that they are of inferior quality in comparison to the exfoliated 2D materials commonly used in basic research. In this work we challenge this assumption and aim to quantify the differences in quality for the prototypical transition metal dichalcogenide MoS$_2$. To this end single …
Liquid-phase exfoliation is one of the most promising routes for large scale production of multilayer graphene dispersions. These dispersions, which may be used in coatings, composites or paints, are believed to contain disorder-free graphene multilayers. Here we address the nature of defects in such samples obtained by liquid-phase exfoliation of graphite powder in N-methyl--2--pyrrolidone. Our Raman spectroscopy data challenges the assumption that these multilayers are free of bulk defects, revealing that defect localization strongly depends on the sonication time. For short ultrasound times…
We present results of atomic-force-microscopy-based friction measurements on Re-doped molybdenum disulfide (MoS2). In stark contrast to the widespread observation of decreasing friction with increasing number of layers on two-dimensional (2D) materials, friction on Re-doped MoS2 exhibits an anomalous, i.e., inverse dependence on the number of layers. Raman spectroscopy measurements combined with ab initio calculations reveal signatures of Re intercalation. Calculations suggest an increase in out-of-plane stiffness that inversely correlates with the number of layers as the physical mechanism be…
The ability to synthesize high-quality samples over large areas and at low cost is one of the biggest challenges during the developmental stage of any novel material. While chemical vapor deposition (CVD) methods provide a promising low-cost route for CMOS compatible, large-scale growth of materials, it often falls short of the high-quality demands in nanoelectronics and optoelectronics. We present large-scale CVD synthesis of single- and few- layered MoS2 using direct vapor-phase sulfurization of MoO2, which enables us to obtain extremely high-quality single-crystal monolayer MoS2 samples wit…
The discovery of graphene, a single layer of covalently bonded carbon atoms, has attracted intense interests. Initial studies using mechanically exfoliated graphene unveiled its remarkable electronic, mechanical and thermal properties. There has been a growing need and rapid development in large-area deposition of graphene film and its applications. Chemical vapour deposition on copper has emerged as one of the most promising methods in obtaining large-scale graphene films with quality comparable to exfoliated graphene. In this chapter, we review the synthesis and characterizations of graphene…
We fabricate ion-gated field-effect transistors (iFET) on mechanically exfoliated multilayer MoS$_2$. We encapsulate the flake by Al$_2$O$_3$, leaving the device channel exposed at the edges only. A stable Li$^+$ intercalation in the MoS$_2$ lattice is induced by gating the samples with a Li-based polymeric electrolyte above $\sim$ 330 K and the doping state is fixed by quenching the device to $\sim$ 300 K. This intercalation process induces the emergence of anomalies in the temperature dependence of the sheet resistance and its first derivative, which are typically associated with structural/…
