Here we present a cost effective multi-channel opto-mechanical switch and software PID system for locking multiple lasers to a single channel commercial wavemeter. The switch is based on a rotating cylinder that selectively transmits one laser beam at a time to the wavemeter, the wavelength is read by the computer and an error signal is output to the lasers to correct wavelength drifts every millisecond. We use this system to stabilise 740 nm (subsequently frequency doubled to 370 nm), 399 nm and 935 nm lasers for trapping and cooling different isotopes of Yb+ ion. We characterize the frequency stability of the three lasers by using a second, more precise, commercial wavemeter. We also characterise the absolute frequency stability of the 740 nm laser using the fluorescence drift rate of a trapped 174Yb+ ion. For the 740 nm laser we demonstrate an Allan deviation, df/f, of 3 x 10^-10 (at 20 s integration time), equivalent to sub-200 KHz stability.
We demonstrate a method for accurately locking the frequency of a continuous-wave laser to an optical frequency comb in conditions where the signal-to-noise ratio is low, too low to accommodate other methods. Our method is typically orders of magnitude more accurate than conventional wavemeters and can considerably extend the usable wavelength range of a given optical frequency comb. We illustrate our method by applying it to the frequency control of a dipole lattice trap for an optical lattice clock, a representative case where our method provides significantly better accuracy than other meth…
Collective phenomena emerging from non-linear interactions between multiple oscillators, such as synchronization and frequency locking, find applications in a wide variety of fields. Optomechanical resonators, which are intrinsically non-linear, combine the scientific assets of mechanical devices with the possibility of long distance controlled interactions enabled by travelling light. Here we demonstrate light-mediated frequency locking of three distant nano-optomechanical oscillators positioned in a cascaded configuration. The oscillators, integrated on a chip along a coupling waveguide, are…
Frequency-locking and other phenomena emerging from nonlinear interactions between mechanical oscillators are of scientific and technological importance. However, existing schemes to observe such behaviour are not scalable over distance. We demonstrate a scheme to couple two independent mechanical oscillators, separated in frequency by 80kHz and situated far from each other (3.2km), via light. Using light as the coupling medium enables this scheme to have low loss and be extended over long distances. This scheme is reversible and can be generalised for arbitrary network configurations.
We experimentally study a fiber-based optical ring cavity integrated with a mechanical resonator mirror and an optical amplifier. The device exhibits a variety of intriguing nonlinear effects including synchronization and self-excited oscillation. Passively generated optical pulses are observed when the frequency of the optical ring cavity is tuned very close to the mechanical frequency of the suspended mirror. The optical power at the threshold of this process of mechanical mode locking is found to be related to quantum noise of the optical amplifier.
Optoelectronic down-conversion of a THz optical beatnote to a RF intermediate frequency is performed with a standard Mach-Zehnder modulator followed by a zero dispersion-slope fiber. The two interleaved optical spectra obtained by four-wave mixing are shown to contain more than 75 harmonics enabling to conveniently recover the phase noise of a beatnote at 770 GHz at around 500 MHz. This four-wave mixing down-conversion technique is implemented in a two-frequency solid-state laser in order to directly phase-lock its 168 GHz beatnote to a 10 MHz local oscillator.
We present a novel locking scheme for active length-stabilization and frequency detuning of a cavity optomechanical device based on the optical spring effect. The scheme can be used as an alternative to the Pound-Drever-Hall locking technique but in contrast doesn't require signal processing on time-scales of the cavity decay rate. It is therefore particularly suited for stabilizing micro cavities, where this time-scale can be extremely fast. The error signal is generated through the optical spring effect, i.e. the detuning-dependent frequency-shift of a nanomechanical oscillator that is dispe…
The techniques of cavity optomechanics have enabled significant achievements in precision sensing, including the detection of gravitational waves and the cooling of mechanical systems to their quantum ground state. Recently, the inherent non-linearity in the optomechanical interaction has been harnessed to explore synchronization effects, including the spontaneous locking of an oscillator to a reference injection signal delivered via the optical field. Here, we present the first demonstration of a radiation-pressure driven optomechanical system locking to an inertial drive, with actuation prov…
We engineer mechanical gain (loss) in system formed by two optomechanical cavities (OMCs), that are mechanically coupled. The gain (loss) is controlled by driving the resonator with laser that is blue (red) detuned. We predict analytically the existence of multiple exceptional points (EPs), a form of degeneracy where the eigenvalues of the system coalesce. At each EP, phase transition occurs, and the system switches from weak to strong coupling regimes and vice versa. In the weak coupling regime, the system locks on an intermediate frequency, resulting from coalescence at the EP. In strong cou…
Spontaneous locking of the phase of a coherent phonon source to an external reference is demonstrated in an optomechanical oscillator based on a self-triggered free-carrier/temperature limit cycle. Synchronization is observed when the pump laser driving the mechanical oscillator to a self-sustained state is modulated by a radiofrequency tone. We employ a pump-probe phonon detection scheme based on an independent optical cavity to observe only the mechanical oscillator dynamics. The lock range of the oscillation frequency, i.e., the Arnold tongue, is experimentally determined over a range of ex…
We study self-excited oscillation (SEO) in an on-fiber optomechanical cavity. While the phase of SEO randomly diffuses in time when the laser power that is injected into the cavity is kept constant, phase locking may occur when the laser power is periodically modulated in time. We investigate the dependence of phase locking on the amplitude and frequency of the laser power modulation. We find that phase locking can be induced with a relatively low modulation amplitude provided that the ratio between the modulation frequency and the frequency of SEO is tuned close to a rational number of relati…
We present a simple, robust, narrow-linewidth, frequency-doubled semiconductor laser source suitable for laser cooling and repumping of $^9$Be$^+$ ions. A distributed Bragg reflector (DBR) laser diode operating at 626 nm is self-injection-locked to a frequency doubling cavity via phase-stabilised optical feedback when the laser is resonant with the cavity mode. The short-term laser instability is reduced from the MHz-level to approximately 20 kHz by the injection process, thus eliminating the need for a high-bandwidth feedback loop to suppress the otherwise troublesome high-frequency laser noi…
A driven opto-RF oscillator, consisting of a dual-frequency laser (DFL) submitted to frequency-shifted feedback, is studied experimentally and numerically in a chaotic regime. Precise control of the reinjection strength and detuning permits to isolate a parameter region of bounded-phase chaos, where the opto-RF oscillator is frequency-locked to the master oscillator, in spite of chaotic phase and intensity oscillations. Robust experimental evidence of this synchronization regime is found and phase noise spectra allows to compare phase-locking and bounded-phase chaos regimes. In particular, it …
We demonstrate a combination of optical and electronic feedback that significantly narrows the linewidth of distributed Bragg reflector lasers (DBRs). We use optical feedback from a long external fiber path to reduce the high-frequency noise of the laser. An electro-optic modulator placed inside the optical feedback path allows us to apply electronic feedback to the laser frequency with very large bandwidth, enabling robust and stable locking to a reference cavity that suppresses low-frequency components of laser noise. The combination of optical and electronic feedback allows us to significan…
High-order frequency locking phenomena were recently observed using semiconductor lasers subject to large delayed feedbacks [B. Tykalewicz, et al., Opt. Express 24, 4239 (2016); B. Kelleher, et al., Chaos 27, 114325 (2017)]. Specifically, the relaxation oscillation (RO) frequency and a harmonic of the feedback-loop round-trip frequency coincided with the ratios 1:5 to 1:11. By analyzing the rate equations for the dynamical degrees of freedom in a laser subject to a delayed optoelectronic feedback, we show that the onset of a two-frequency train of pulses occurs through two successive bifurcati…
Wide passband interdigital transducers are employed to establish a stable phase-lock between a train of laser pulses emitted by a mode-locked laser and a surface acoustic wave generated electrically by the transducer. The transducer design is based on a multi-harmonic split-finger architecture for the excitation of a fundamental surface acoustic wave and a discrete number of its overtones. Simply by introducing a variation of the transducer's periodicity $p$, a frequency chirp is added. This combination results in wide frequency bands for each harmonic. The transducer's conversion efficiency f…
Staircase mechanical energy growth in optomechanical systems of median mechanical frequencies
Fujian Key Laboratory of Light Propagation and Transformation & Institute of Systems Science, College of Information Science and Engineering, Huaqiao University（华侨大学信息科学与工程学院系统科学研究所福建省光传播与变换重点实验室）；Shanghai United Imaging Healthcare Co., Ltd.（上海联影医疗科技股份有限公司）；Multidisciplinary Center for Physics, Universidad Mayor（智利 mayor 大学多学科物理中心）
Coherent Control of a Polariton Continuous Time Crystal
Centro Atómico Bariloche and Instituto Balseiro, Comisión Nacional de Energía Atómica (CNEA)–Universidad Nacional de Cuyo (UNCUYO)（巴里洛切原子中心与巴尔塞罗研究所，阿根廷国家原子能委员会（CNEA）-门多萨国立大学（UNCUYO)）；Instituto de Nanociencia y Nanotecnología (INN-Bariloche), Consejo Nacional de Investigaciones Científicas y Técnicas (CONICET)（纳米科学与技术研究所（INN-巴里洛切），阿根廷国家科学研究委员会（CONICET)）；Paul-Drude-Institut für Festkörperelektronik, Leibniz-Institut im Forschungsverbund Berlin e.V.（保罗·德鲁德固体电子学研究所，柏林研究联盟莱布尼茨协会）
Precise measurement of multi-parameters of ultrafast lasers is vital both in scientific investigations and technical applications, such as, optical field manipulation, pulse shaping, sample characteristics test, and biomedical imaging. Tremendous progress in parameter measurement of ultrafast laser has been made, including single-shot spectra acquired by time-stretch dispersive Fourier transform in spectral domain, and pulse magnification or compression realized by time lens in temporal domain. Nevertheless, single-shot measurement of frequency-resolved states of polarization (SOPs) of ultrafa…
