Recent years have seen the emergence of programmable metasurfaces, where the user can modify the EM response of the device via software. Adding reconfigurability to the already powerful EM capabilities of metasurfaces opens the door to novel cyber-physical systems with exciting applications in domains such as holography, cloaking, or wireless communications. This paradigm shift, however, comes with a non-trivial increase of the complexity of the metasurfaces that will pose new reliability challenges stemming from the need to integrate tuning, control, and communication resources to implement the programmability. While metasurfaces will become prone to failures, little is known about their tolerance to errors. To bridge this gap, this paper examines the reliability problem in programmable metamaterials by proposing an error model and a general methodology for error analysis. To derive the error model, the causes and potential impact of faults are identified and discussed qualitatively. The methodology is presented and exemplified for beam steering, which constitutes a relevant case for programmable metasurfaces. Results show that performance degradation depends on the type of error and its spatial distribution and that, in beam steering, error rates over 20% can still be considered acceptable.
Metasurfaces have drawn significant attentions due to their superior capability in tailoring electromagnetic waves with a wide frequency range, from microwave to visible light. Recently, programmable metasurfaces have demonstrated the ability of manipulating the amplitude or phase of electromagnetic waves in a programmable manner in real time, which renders them especially appealing in the applications of wireless communications. To practically demonstrate the feasibility of programmable metasurfaces in future communication systems, in this paper, we design and realize a novel metasurface-base…
In this letter, a wireless transmitter using the new architecture of programmable metasurface is presented. The proposed transmitter does not require any filter, nor wideband mixer or wideband power amplifier, thereby making it a promising hardware architecture for cost-effective wireless communications systems in the future. Using experimental results, we demonstrate that a programmable metasurface-based 8-phase shift-keying (8PSK) transmitter with 8*32 phase adjustable unit cells can achieve 6.144 Mbps data rate over the air at 4.25 GHz with a comparable bit error rate (BER) performance as t…
The large scale reflector array of programmable metasurfaces is capable of increasing the power efficiency of backscatter communications via passive beamforming and thus has the potential to revolutionize the low-data-rate nature of backscatter communications. In this paper, we propose to design the power-efficient higher-order constellation and reflection pattern under the amplitude constraint brought by backscatter communications. For the constellation design, we adopt the amplitude and phase-shift keying (APSK) constellation and optimize the parameters of APSK such as ring number, ring radi…
Metamaterials and metasurfaces have given possibilities for manipulating electromagnetic (EM) waves that in the past would have seemed impossible. The majority of metasurface designs are suitable for a particular frequency and angle of incidence. One long-sought objective is the design of programmable metasurfaces to dynamically manipulate a variety of incoming EM frequencies and angles. In order to do this, a large-scale mesh of networked chips are required below the metasurface, which apart from adapting electrical impedance properties, also communicate with each other, thus relaying informa…
A tunable metasurface absorber is presented in this work using an optically-programmable capacitor as the tuning element. The tuning element does not employ conventional semiconductor technologies to operate but rather a bases its tuning by changing the optomechanical properties of its dielectric, poly disperse red 1 acrylate (PDR1A). Doing so there are no conventional semiconductor devices in the RF signal path. The metasurface operates at a design frequency of 5.5 GHz and it achieves an optically-tuned bandwidth of 150 MHz, from 5.50 GHz to 5.65 GHz.
Many emerging technologies, such as ultra-massive multiple-input multiple-output (UM-MIMO), terahertz (THz) communications are under active discussion as promising technologies to support the extremely high access rate and superior network capacity in the future sixth-generation (6G) mobile communication systems. However, such technologies are still facing many challenges for practical implementation. In particular, UM-MIMO and THz communication require extremely large number of radio frequency (RF) chains, and hence suffering from prohibitive hardware cost and complexity. In this article, we …
Small, low-cost IoT devices are typically equipped with only a single, low-quality antenna, significantly limiting communication range and link quality. In particular, these antennas are typically linearly polarized and therefore susceptible to polarization mismatch, which can easily cause 10-15 dBm of link loss on communication to and from such devices. In this work, we highlight this under-appreciated issue and propose the augmentation of IoT deployment environments with programmable, RF-sensitive surfaces made of metamaterials. Our smart meta-surface mitigates polarization mismatch by rotat…
Programmable wireless environments (PWEs) utilize electromagnetic metasurfaces to transform wireless propagation into a software-controlled resource. In this work we study the effects of user device mobility on the efficiency of PWEs. An analytical model is proposed, which describes the potential misalignment between user-emitted waves and the active PWE configuration, and can constitute the basis for studying queuing problems in PWEs. Subsequently, a novel, beam steering approach is proposed which can effectively mitigate the misalignment effects. Ray-tracing-based simulations evaluate the pr…
We introduce the concept of smart radio environments, currently intensely studied for wireless communication in metasurface-programmable meter-scaled environments (e.g., inside rooms), on the chip scale. Wireless networks-on-chips (WNoCs) are a candidate technology to improve inter-core communication on chips but current proposals are plagued by a dilemma: either the received signal is weak, or it is significantly reverberated such that the on-off-keying modulation speed must be throttled. Here, we overcome this vexing problem by endowing the wireless on-chip environment with in situ programma…
This paper considers a multi-antenna multicast system with programmable metasurface (PMS) based transmitter. Taking into account of the finite-resolution phase shifts of PMSs, a novel beam training approach is proposed, which achieves comparable performance as the exhaustive beam searching method but with much lower time overhead. Then, a closed-form expression for the achievable multicast rate is presented, which is valid for arbitrary system configurations. In addition, for certain asymptotic scenario, simple approximated expressions for the multicase rate are derived. Closed-form solutions …
A Survey on Stacked Intelligent Metasurfaces: Fundamentals, Recent Advances, and Challenges
University of Luxembourg（卢森堡大学）；National Institute of Technology Warangal（瓦朗加尔国立技术学院）；National and Kapodistrian University of Athens（雅典国家与卡波迪斯特里阿斯大学）；University of Illinois Chicago（伊利诺伊大学芝加哥分校）
The limited radio-frequency spectrum is a fundamental factor in the design of wireless communication systems. The ever increasing number of wireless devices and systems has led to a crowded spectrum and increased the demand for versatile and multi-functional full-duplex wireless apparatuses. Recently, dynamic and intelligent metasurfaces are explored as a prominent technological solution to the current paradigm of spectrum scarcity by opportunistically sharing the spectrum with various users. In general, intelligent metasurfaces are dynamic, ultra-compact, multi-functional and programmable str…
Metasurfaces-Enabled Wave Computing for Future Wireless Systems: Opportunities and Challenges
Institute for Communication Systems, University of Surrey（萨里大学通信系统研究所）；Universidad de Oviedo（奥维耶多大学）；National and Kapodistrian University of Athens（雅典国立卡波迪斯特里亚斯大学）；University of Illinois Chicago（伊利诺伊大学芝加哥分校）；Centre for Wireless Innovation, Queen’s University Belfast（贝尔法斯特女王大学无线创新中心）
