In high dimensional quantum communication networks, quantum frequency convertor (QFC) is indispensable as an interface in the frequency domain. For example, many QFCs have been built to link atomic memories and fiber channels. However, almost all of QFCs work in a two-dimensional space. It is still a pivotal challenge to construct a high-quality QFC for some complex quantum states, e.g., a high dimensional single-photon state that refers to a qudit. Here, we firstly propose a high-dimensional QFC for an orbital angular momentum qudit via sum frequency conversion with a flat top beam pump. As a proof-of-principle demonstration, we realize quantum frequency conversions for a qudit from infrared to visible range. Based on the qudit quantum state tomography, the fidelities of converted state are 98.29(95.02)\%, 97.42(91.74)\%, and 86.75(67.04)\% for a qudit without (with) dark counts in 2,3, and 5 dimensions, respectively. The demonstration is very promising for constructing a high capacity quantum communication network.
We experimentally demonstrate a mode-selective quantum frequency converter over a compound spatio-temporal Hilbert space. We show that our method can achieve high-extinction for high-dimensional quantum state tomography by selectively upconverting the signal modes with a modulated and delayed pump. By preparing the pump in optimized modes through adaptive feedback control, selective frequency conversion is demonstrated with up to 30 dB extinction. The simultaneous operations over high-dimensional degrees of freedom in both spatial and temporal domains can serve as a viable resource for photon-…
We propose a single-photon frequency converter via a one-dimensional waveguide coupled to a $V$-type atom. The on-demand classical field allows the atom to absorb a photon with a given frequency, then emit a photon with a carried frequency different from the absorbed one. The absorption and re-emission process is formulated as a two-channel scattering process. We study the single-photon frequency conversion mechanism in two kinds of realistic physical system: coupled resonator waveguide with cosine dispersion relation and an optical waveguide with linear dispersion relation respectively. We fi…
We show that an interacting two-spin model subjected to two circularly polarized drives enables a feasible realization of a correlated topological phase in synthetic dimensions. The topological observable is given by a quantized frequency conversion between the dynamical drives, which is why we coin it the interacting topological frequency converter (ITFC). The ITFC is characterized by the interplay of interaction and synthetic dimension. This gives rise to striking topological phenomena that have no counterpart in the noninteracting regime. By calculating the topological phase diagrams as a f…
We propose to construct a nonreciprocal single-photon frequency converter via multiple semi-infinite coupled-resonator waveguides (CRWs). We first demonstrate that the frequency of a single photon can be converted nonreciprocally through two CRWs, which are coupled indirectly by optomechanical interactions with two nondegenerate mechanical modes. Based on such nonreciprocity, two different single-photon circulators are proposed in the T-shaped waveguides consisting of three semi-infinite CRWs, which are coupled in pairwise by optomechanical interactions. One circulator is proposed by using two…
Capabilities of quantum optical SFG-gate seeded by squeezed light are investigated in the frame of frequency Schmidt modes. Methods to manage and manipulate extensively the properties and mode content of squeezed light are developed. Possibilities to block and select any certain Schmidt mode of squeezed light with conservation of non-classical properties are demonstrated. The significant phase sensitivity of the gate is shown and the ways to manage the spectral distribution of the output light due to the phase effects and variable coupling between modes in the gate are demonstrated. The effect…
We report a detailed study of the noise properties of a visible-to-telecom photon frequency converter based on difference frequency generation (DFG). The device converts 580 nm photons to 1541 nm using a strong pump laser at 930 nm, in a periodically poled lithium niobate ridge waveguide. The converter reaches a maximum device efficiency of 46 % (internal efficiency of 67 %) at a pump power of 250 mW. The noise produced by the pump laser is investigated in detail by recording the noise spectra both in the telecom and visible regimes, and measuring the power dependence of the noise rates. The n…
The ability to coherently convert the frequency and temporal waveform of single and entangled photons will be crucial to interconnect the various elements of future quantum information networks. Of particular importance in this context is the quantum frequency conversion of photons emitted by material systems able to store quantum information, so called quantum memories. There have been significant efforts to implement quantum frequency conversion using non linear crystals, with non classical light from broadband photon pair sources and solid state emitters. However, so far, solid state quantu…
Based on photon-phonon nonlinear interaction, a scheme is proposed to realize a controllable multi-path photon-phonon converter at single-quantum level in a composed quadratically coupled optomechanical system. Considering the realization of the scheme, an associated mechanical oscillator is introduced to enhance the effective nonlinear effect. Thus, the single-photon state can be converted to the phonon state with high fidelity even under the current experimental condition that the single-photon coupling rate is much smaller than mechanical frequency ($g\llω_m$). The state transfer protocols …
The conversion between microwave photons and optical photons with quantum coherence is important for quantum communication and computation. In this paper, we report a proposal using an ensemble of atoms coupled to microwave and optical resonators. Input photons to one resonator are converted into output photons in the other resonator without active operation. Usually the conversion is only optimized at certain frequency. In our proposal, we find that the efficiency is almost a constant and can be close to 100% in a large interval of frequency, i.e. a high-bandwidth conversion can be realized w…
Converting low-frequency electrical signals into much higher frequency optical signals has enabled modern communications networks to leverage both the strengths of microfabricated electrical circuits and optical fiber transmission, allowing information networks to grow in size and complexity. A microwave-to-optical converter in a quantum information network could provide similar gains by linking quantum processors via low-loss optical fibers and enabling a large-scale quantum network. However, no current technology can convert low-frequency microwave signals into high-frequency optical signals…
We report the observation of efficient and low-noise frequency conversion between two microwave modes, mediated by the motion of a mechanical resonator subjected to radiation pressure. We achieve coherent conversion of more than $10^{12}~\mathrm{photons/s}$ with a $95\mathrm{\%}$ efficiency and a $14~\mathrm{kHz}$ bandwidth. With less than $10^{-1}~\mathrm{photons \cdot s^{-1}\cdot Hz^{-1}}$ of added noise, this optomechanical frequency converter is suitable for quantum state transduction. We show the ability to operate this converter as a tunable beam splitter, with direct applications for ph…
High-dimensional entanglement offers a variety of advantages for both fundamental and applied applications in quantum information science. A central building block for such applications is a programmable processor of entangled states, which is crucial for the certification, manipulation and distribution of high-dimensional entanglement. The leading technology for processing photons is integrated multiport interferometers. However, such devices are incompatible with structured light, and their scaling is challenging. Here, we unlock these limitations by demonstrating a reconfigurable processor …
Superconducting microwave circuits form a versatile platform for storing and manipulating quantum information. A major challenge to further scalability is to find approaches for connecting these systems over long distances and at high rates. One approach is to convert the quantum state of a microwave circuit to optical photons that can be transmitted over kilometers at room temperature with little loss. Many proposals for electro-optic conversion between microwave and optics use optical driving of a weak three-wave mixing nonlinearity to convert the frequency of an excitation. Residual absorpt…
We study a model of isothermal steady-state work-to-work converter, where a single quantum two-level system (TLS) driven by time-dependent periodic external fields acts as the working medium and is permanently put in contact with a thermal reservoir at fixed temperature $T$. By combining Short-Iterative Lanczos (SIL) method and analytic approaches, we study the converter performance in the linear response regime and in a wide range of driving frequencies, from weak to strong dissipation. We show that for our ideal quantum machine several parameter ranges exist where a violation of Thermodynami…
We report on the implementation of quantum frequency conversion (QFC) between infrared (IR) and ultraviolet (UV) wavelengths by using single-stage upconversion in a periodically poled KTP waveguide. Due to the monolithic waveguide design, we manage to transfer a telecommunication band input photon to the wavelength of the ionic dipole transition of Yb${}^{+}$ at 369.5 nm. The external (internal) conversion efficiency is around 5\% (10\%). The high energy pump used in this converter introduces a spontaneous parametric downconversion (SPDC) process, which is a cause for noise in the UV mode. Usi…
Real-time sensing of ultra-wideband radio-frequency signal with high frequency resolution is challenging, which is confined by the sampling rate of electronic analog-to-digital converter and the capability of digital signal processing. By combining quantum mechanics with compressed sensing, quantum compressed sensing is proposed for wideband radio-frequency signal frequency measurement. By using an electro-optical crystal as a sensor which modulates the wave function of the coherent photons with the signal to be measured. The frequency spectrum could be recovered by detecting the modulated spa…
