基于修正稳态热线法的微细丝对流换热热特性研究
Thermal characterization of convective heat transfer in microwires based on modified steady state "hot wire" method
摘要:
微机电系统在空气环境中工作时,对流换热起着非常重要的作用。然而,传统的对流换热系数的测量需要导热系数的知识,这使得测量复杂。本文提出了一种改进的稳态热线法,该方法可以在不知道导热系数的情况下测量微细丝的对流换热系数。为了验证MSSHW方法的有效性,在大气中测量了铂微丝的对流换热系数,其值与传统测量方法和经验公式的值吻合较好。然后,用MSSHW测量了不同材料和直径的微细丝的对流换热系数。结果表明,微细丝的对流换热系数对材料不敏感,随着微细丝直径从120 $μ$ m减小到20 $μ$ m,其对流换热系数从86 W/(m $^2$ K)增大到427 W/(m $^2$ K)。在不知道微导线导热系数的情况下,MSSHW方法提供了一种更方便的测量对流效应的方法。
英文摘要:
The convection plays a very important role in heat transfer when MEMS work under air environment. However, traditional measurements of convection heat transfer coefficient require the knowledge of thermal conductivity, which makes measurements complex. In this work, a modified steady state "hot wire" (MSSHW) method is proposed, which can measure the heat transfer coefficient of microwires' convection without the knowledge of thermal conductivity. To verify MSSHW method, the convection heat transfer coefficient of platinum microwires was measured in the atmosphere, whose value is in good agreement with values by both traditional measurement methods and empirical equations. Then, the convection heat transfer coefficient of microwires with different materials and diameters were measured by MSSHW. It is found that the convection heat transfer coefficient of microwire is not sensitive on materials, while it increases from 86 W/(m$^2$K) to 427 W/(m$^2$K) with the diameter of microwires decreasing from 120 $μ$m to 20 $μ$m. Without knowing thermal conductivity of microwires, the MSSHW method provides a more convenient way to measure the convective effect.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。