arXivDaily arXiv每日学术速递 周一至周五更新
arXiv 1802.05982eess.SPcs.ARcs.CEcs.NAmath.NA
收藏

基于残差的检测与大规模MIMO上行统一架构

Residual-Based Detections and Unified Architecture for Massive MIMO Uplink

Shanghai University(上海大学);Southeast University(东南大学)

Chuan Zhang, Yufeng Yang, Shunqing Zhang, Zaichen Zhang, Xiaohu You

AI总结:

本文提出基于残差的检测算法,用于大规模MIMO上行通信,通过减少残差范数提升性能,相比传统方法在复杂度和精度上取得平衡,提出统一硬件架构以实现低复杂度实现。

摘要:

大规模多输入多输出(M-MIMO)技术虽然能提高能效和覆盖范围,但计算复杂度更高。对于线性检测如最小均方误差(MMSE),解决大规模线性方程组的复杂性很高。为在比特误码率(BER)性能和计算复杂性之间取得更好的平衡,近年来应用了迭代线性算法如共轭梯度(CG)。本文提出基于残差的检测(RBD)算法,包括最小残差(MINRES)算法、广义最小残差(GMRES)算法和共轭残差(CR)算法。RBD算法关注每次迭代的残差范数最小化,而大多数现有算法关注信号的近似。数值结果表明,对于64-QAM 128×8 MIMO,RBD算法在BER=10^-4时仅比精确矩阵求逆方法低0.13 dB。RBD算法在各种相关条件下也已验证了稳定性。复杂度比较显示,CR算法在128×60 MIMO中比传统方法复杂度低87%。提出统一的硬件架构,具有灵活性,保证了RBD M-MIMO检测器的低复杂度实现。

英文摘要:

Massive multiple-input multiple-output (M-MIMO) technique brings better energy efficiency and coverage but higher computational complexity than small-scale MIMO. For linear detections such as minimum mean square error (MMSE), prohibitive complexity lies in solving large-scale linear equations. For a better trade-off between bit-error-rate (BER) performance and computational complexity, iterative linear algorithms like conjugate gradient (CG) have been applied and have shown their feasibility in recent years. In this paper, residual-based detection (RBD) algorithms are proposed for M-MIMO detection, including minimal residual (MINRES) algorithm, generalized minimal residual (GMRES) algorithm, and conjugate residual (CR) algorithm. RBD algorithms focus on the minimization of residual norm per iteration, whereas most existing algorithms focus on the approximation of exact signal. Numerical results have shown that, for $64$-QAM $128\times 8$ MIMO, RBD algorithms are only $0.13$ dB away from the exact matrix inversion method when BER$=10^{-4}$. Stability of RBD algorithms has also been verified in various correlation conditions. Complexity comparison has shown that, CR algorithm require $87\%$ less complexity than the traditional method for $128\times 60$ MIMO. The unified hardware architecture is proposed with flexibility, which guarantees a low-complexity implementation for a family of RBD M-MIMO detectors.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑