arXivDaily arXiv每日学术速递 周一至周五更新
arXiv 1611.02404cond-mat.dis-nn
收藏

缺陷对线性$k$ -聚体在正方晶格上随机顺序吸附单分子膜有效电导率的影响

Influence of defects on the effective electrical conductivity of a monolayer produced by random sequential adsorption of linear $k$-mers onto a square lattice

Yu. Yu. Tarasevich, V. V. Laptev, V. A. Goltseva, N. I. Lebovka

摘要:

用Monte Carlo模拟方法研究了线性$k$ -mer(占据$k$相邻位置的粒子)在正方形晶格上随机顺序吸附所产生的单层膜中缺陷对电导行为的影响。将$k$ -聚体沉积在基底上,直到达到堵塞状态,即由于存在的空隙太小或形状不合适而不能放置一个附加颗粒的状态。假设晶格中存在缺陷(杂质)以及$k$ -聚体中存在缺陷,浓度分别为$d_l$和$d_k$。晶格中的缺陷在沉积之前随机分布,并且这些晶格位置对于$k$ -mer的沉积是禁止的。$k$ -mer上的缺陷是随机分布的。填充有$k$ -聚体的位点具有高电导率,而空位点和由任一类型缺陷填充的位点具有低电导率,即,假设高对比度。我们研究了各向同性(粒子的两种可能取向是等概率的)和各向异性(所有粒子沿一个给定方向排列,$y$)沉积。为了计算有效电导率,单分子层被描述为随机电阻网络(RRN),并使用Frank-Lobb算法。研究了缺陷$d_l$和$d_k$的浓度对$k = 2^n$(其中$n =1,2,\dots, 5$)值的电导率的影响。$d_l$和$d_k$参数值的增加导致$σ$值的降低和渗流的抑制。此外,对于各向异性沉积,沿$y$方向的电导率明显大于沿垂直方向的电导率$x$。获得了不同$k$值的($d_l, d_k$)平面相图。

英文摘要:

The effect of defects on the behavior of electrical conductivity in a monolayer produced by the random sequential adsorption of linear $k$-mers (particles occupying $k$ adjacent sites) onto a square lattice is studied by means of a Monte Carlo simulation. The $k$-mers are deposited on the substrate until a jamming state is reached, i.e. a state where no one additional particle can be placed because the presented voids are too small or of inappropriate shapes. The presence of defects in the lattice (impurities) and of defects in the $k$-mers with concentrations of $d_l$ and $d_k$, respectively, is assumed. The defects in the lattice are distributed randomly before deposition and these lattice sites are forbidden for the deposition of $k$-mers. The defects on the $k$-mers are distributed randomly. The sites filled with $k$-mers have high electrical conductivity whereas the empty sites, and the sites filled by either types of defect have a low electrical conductivity, i.e., a high-contrast is assumed. We examined isotropic (both the possible orientations of a particle are equiprobable) and anisotropic (all particles are aligned along one given direction, $y$) deposition. To calculate the effective electrical conductivity, the monolayer was presented as a random resistor network (RRN) and the Frank--Lobb algorithm was used. The effects of the concentrations of defects $d_l$ and $d_k$ on the electrical conductivity for the values of $k = 2^n$, where $n =1,2,\dots, 5$, were studied. Increase of both the $d_l$ and $d_k$ parameters values resulted in decreases in the value of $σ$ and the suppression of percolation. Moreover, for anisotropic deposition the electrical conductivity along the $y$ direction was noticeably larger than in the perpendicular direction, $x$. Phase diagrams in the ($d_l, d_k$)-plane for different values of $k$ were obtained.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑