We present a simple, and robust method for writing long period fiber gratings with low polarization dependent losses. Our method is based on utilizing mechanical vibrations of the tapered fiber while pooling it. Our method enables real-time tunability of the periodicity, efficiency and length of the grating. We also demonstrate complex grating by writing multiple gratings simultaneously. Finally, we utilized the formation of the gratings in different fiber diameters to investigate the Young's modulus of the fiber.
Ultra-broadband long-period fiber grating with 10-dB bandwidth of 155 nm and 3-dB bandwidth of 415 nm is demonstrated around 1060 nm, which has been combined with a tunable ytterbium-doped fiber laser to generate optical doughnut beams in the spectral range from 1030 nm to 1099 nm, and the vector nature of generated optical fields are observed. The long-period fiber grating has also been used to transform the amplified spontaneous emission of an ytterbium-doped fiber amplifier into a broadband optical doughnut beam.
We propose an efficient method to determine the effective refractive index of step-index optical fibers from the visible to the mid-IR and thus allowing to infer their dispersive properties over a broad spectral range. The validity of the method, based on the writing of an array of fiber Bragg gratings (FBGs) with known periods using the fs scanning phase mask technique, is first confirmed with a standard silica fiber, then applied to various fluoride glass fibers to determine their effective refractive index and dispersion over more than three octaves, i.e. from 550 to 4800 nm.
Compensation of nonlinear phase shifts with third-order dispersion: fiber stretchers can out-perform grating stretchers in short-pulse fiber amplifiers
We realize a fiber Bragg grating InGaN based laser diode emitting at 400 nm and demonstrate its high coherency. Thanks to the fabrication of a narrow band fiber Bragg grating in the near-UV, we can reach single-mode and single-frequency regimes for the self-injection locked diode. The device exhibits 44 dB side-mode-suppression-ratio and mW output power. Detailed frequency noise analysis reveals sub-MHz integrated linewidth and 16 kHz intrinsic linewidth. Such a narrow linewidth laser diode in the near-UV domain with a compact and low-cost design could find applications whenever coherency and …
The resonance wavelength, where a fiber mode converter grating written using periodic external perturbations achieves phase matching, is both a critical design parameter and a device parameter. However, a method to precisely predict the resonance wavelength for any new fiber and grating writing apparatus has been missing so far. The missing link was the lack of direct experimental methods to estimate the modified intermodal phase after writing with external perturbations. The presented method can make this estimation from a single experiment, over a broad wavelength range, based on a novel mat…
Dynamic population gratings (DPGs) in rare-earth doped fibers are prevalent devices in fiber lasers for the production of single-longitudinal-mode emission, Q-switched pulses, and wavelength self-sweeping regimes. This study presents a transition from Q-switched state to continuous wave (CW) state, accompanying irregular mode-hopping, in an erbium-doped fiber laser with a heavily-doped DPG centered at 1549.95 nm. Our results demonstrate that the transition between these two states can be achieved by adjusting the pump power. The repetition frequency of the Q-switched pulse increases monotonica…
We present here the inscription of single-mode waveguides with Bragg gratings in sapphire. The waveguide Bragg gratings have a novel multi-layer depressed cladding design in the 1550 nm telecommunications waveband. The Bragg gratings have a narrow bandwidth (<0.5 nm) and have survived annealing at 1000°C. The structures are inscribed with femtosecond laser direct writing, using adaptive beam shaping with a non-immersion objective. A single-mode sapphire fiber Bragg grating is created by writing a waveguide with a Bragg grating within a 425 μm diameter sapphire optical fiber, providing signific…
Achieving large bandwidth at strong mode conversion strengths is a central problem in few-mode optical waveguides. The most uncomplicated modification of a standard mode-converting grating is to incorporate a single extra gap. Such simple design has not been applied yet for broadening conversion spectrum between core modes of any few-mode waveguide e.g. few-mode fiber, possibly due to lacking knowledge of critical parameter control: (a) phase shift value at resonance wavelength, and (b) deterministic method for placement of the phase shift(s) accommodating the change in waveguide properties du…
State-of-the-art fiber Bragg grating interrogators utilize mature concepts and technologies like tunable lasers, optical spectrum analyzers and a combination of time, wavelength, or spatial division demultiplexing approaches. Here, we propose the use of computational compressed sensing (CS) techniques for interrogation of fiber Bragg gratings, reducing interrogator complexity by using a broadband ASE light source and single-pixel detection. We demonstrate temperature sensing using a pre-calibration approach to achieve reconstruction accuracy comparable to uncompressed measurements. We extend t…
Optical I/O plays a crucial role in the lifespan of lab-on-a-chip systems, from preliminary testing to operation in the target environment. However, due to the precise alignments required, efficient and reliable fiber-to-chip connections remain challenging, yielding inconsistent test results and unstable packaged performance. To overcome this issue, for use in single mode on-chip systems, we propose the incorporation of area-enlarged grating couplers working in conjunction with multimode fibers. This combination enables simpler, faster, and more reliable connections than the traditional small …
We provide an optimal control framework for efficiently coupling light in a bare fiber into Bragg gratings with a cubic nonlinearity. The light-grating interaction excites gap solitons, a type of localized nonlinear coherent state which propagates with a central frequency in the forbidden band gap, resulting in a dramatically slower group velocity. Due to the nature of the band gap, a substantial amount of light is back-reflected by the grating's strong reflective properties. We optimize, via a projected gradient descent method, the transmission efficiency of previously designed nonuniform gra…
The analysis of substances outside the cladding has challenged the optical fiber sensors community for decades. A common solution relies on the propagation of light in cladding modes. However, the coupling of light to/from these modes is typically based on permanent gratings in specific locations, which restrict the sensors to point measurements only. In this work, we present dynamic, random-access coupling of light between core and cladding modes of standard fibers, in arbitrarily located short sections. Coupling is based on the stimulation of Brillouin dynamic gratings by two coded pump wave…
We theoretically demonstrate mechanical tuning of the spectral response of a Mie-like resonant dielectric metasurface consisting of crossed all-dielectric strip gratings. We use two array of parallel dielectric strips superimposed on each other to mechanically alter the crossing angle between them thereby changing the position of the maximum of the spectral response in a wide frequency range. The metasurface structure is considered as a doubly-periodic system in an oblique mesh. This mechanically controllable metasurface can be perspective in developing of a flexible polarization-sensitive opt…
