Ambient RF (Radio Frequency) energy harvesting technique has recently been proposed as a potential solution to provide proactive energy replenishment for wireless devices. This paper aims to analyze the performance of a battery-free wireless sensor powered by ambient RF energy harvesting using a stochastic geometry approach. Specifically, we consider the point-to-point uplink transmission of a wireless sensor in a stochastic geometry network, where ambient RF sources, such as mobile transmit devices, access points and base stations, are distributed as a Ginibre alpha-determinantal point process (DPP). The DPP is able to capture repulsion among points, and hence, it is more general than the Poisson point process (PPP). We analyze two common receiver architectures: separated receiver and time-switching architectures. For each architecture, we consider the scenarios with and without co-channel interference for information transmission. We derive the expectation of the RF energy harvesting rate in closed form and also compute its variance. Moreover, we perform a worst-case study which derives the upper bound of both power and transmission outage probabilities. Additionally, we provide guidelines on the setting of optimal time-switching coefficient in the case of the time-switching architecture. Numerical results verify the correctness of the analysis and show various tradeoffs between parameter setting. Lastly, we prove that the sensor is more efficient when the distribution of the ambient sources exhibits stronger repulsion.
In order to minimize electric grid power consumption, energy harvesting from ambient RF sources is considered as a promising technique for wireless charging of low-power devices. To illustrate the design considerations of RF-based ambient energy harvesting networks, this article first points out the primary challenges of implementing and operating such networks, including non-deterministic energy arrival patterns, energy harvesting mode selection, energy-aware cooperation among base stations (BSs), etc. A brief overview of the recent advancements and a summary of their shortcomings are then pr…
Ambient radio frequency (RF) energy harvesting (EH) technology is key to realize self-sustainable, always-on, low-power, massive Internet of Things networks. Typically, rigid (non-adaptable to channel fluctuations) multi-antenna receive architectures are proposed to support reliable EH operation. Herein, we introduce a dynamic RF combining architecture for ambient RF EH use cases, and exemplify the attainable performance gains via three simple phase shifts' exploration mechanisms, namely, brute force (BF), sequential testing (ST) and codebook based (CB). Among the proposed mechanisms, BF deman…
LoRa networks have been deployed all over the world and are a major enabling wireless technology for the Internet of Things (IoT). Massive connectivity applications such as smart metering, agriculture, and supply chain \& logistics are most suitable for LoRa deployments due to their long range, low cost, and low power features. Meanwhile, energy harvesting technologies that extract energy from ambient sources have enabled the battery-less operation of many small wireless sensors. This paper studies the merger of these two technologies and mathematically models device and network performance us…
The recent advanced wireless energy harvesting technology has enabled wireless-powered communications to accommodate wireless data services in a self-sustainable manner. However, wireless-powered communications rely on active RF signals to communicate, and result in high power consumption. On the other hand, ambient backscatter technology that passively reflects existing RF signal sources in the air to communicate has the potential to facilitate an implementation with ultra-low power consumption. In this paper, we introduce a hybrid D2D communication paradigm by integrating ambient backscatter…
Energy harvesting emerges as a potential solution for prolonging the lifetime of the energy-constrained mobile wireless devices. In this paper, we focus on Radio Frequency (RF) energy harvesting for multiuser multicarrier mobile wireless networks. Specifically, we propose joint data and energy transfer optimization frameworks for powering mobile wireless devices through RF energy harvesting. We introduce a power utility that captures the power consumption cost at the base station (BS) and the used power from the users' batteries, and determine optimal power resource allocations that meet data …
Energy harvesting (EH) is a promising technology for realizing energy efficient wireless networks. In this paper, we utilize the ambient RF energy, particularly interference from neighboring transmissions, to replenish the batteries of the EH enabled nodes. However, RF energy harvesting imposes new challenges into the analysis of wireless networks. Our objective in this work is to investigate the performance of a slotted Aloha random access wireless network consisting of two types of nodes, namely Type I which has unlimited energy supply and Type II which is solely powered by an RF energy harv…
The energy-harvested Wireless Sensor Networks (WSNs) may operate perpetually with the extra energy supply from ambient natural energy, such as solar energy. Nevertheless, the harvested energy is still limited so it's not able to support the perpetual network operation with full duty cycle. To achieve the perpetual network operation and process the data with high importance, measured by Value of Information (VoI), the network has to operate under partial duty cycle and to improve the efficiency to consume the harvested energy. The challenging problem is how to deal with the stochastic feature o…
In recent years, there have been several kinds of energy harvesting networks containing some tiny devices, such as ambient backscatter, ring and renewable sensor networks. During energy harvesting, such networks suffer from the energy heterogeneity, dynamics and prediction hardness because the access to natural resources is often spatiotemporal different and timely changing among the devices. Meanwhile, the charging efficiency is quite low especially when the power of the harvested energy is weak. It results in the energy waste to store the harvested energy indirectly. These features bring cha…
Self-sustainable communications based on advanced energy harvesting technologies have been under rapid development, which facilitate autonomous operation and energy-efficient transmission. Recently, ambient backscattering that leverages existing RF signal resources in the air has been invented to empower data communication among low-power devices. In this paper, we introduce hybrid device-to-device (D2D) communications by integrating ambient backscattering and wireless-powered communications. The hybrid D2D communications are self-sustainable, as no dedicated external power supply is required.…
While cognitive radio enables spectrum-efficient wireless communication, radio frequency (RF) energy harvesting from ambient interference is an enabler for energy-efficient wireless communication. In this paper, we model and analyze cognitive and energy harvesting-based D2D communication in cellular networks. The cognitive D2D transmitters harvest energy from ambient interference and use one of the channels allocated to cellular users (in uplink or downlink), which is referred to as the D2D channel, to communicate with the corresponding receivers. We investigate two spectrum access policies fo…
Wireless networks can be self-sustaining by harvesting energy from ambient radio-frequency (RF) signals. Recently, researchers have made progress on designing efficient circuits and devices for RF energy harvesting suitable for low-power wireless applications. Motivated by this and building upon the classic cognitive radio (CR) network model, this paper proposes a novel method for wireless networks coexisting where low-power mobiles in a secondary network, called secondary transmitters (STs), harvest ambient RF energy from transmissions by nearby active transmitters in a primary network, calle…
Ambient backscatter (AB) communication is an emerging wireless communication technology that enables wireless devices (WDs) to communicate without requiring active radio transmission. In an AB communication system, a WD switches between communication and energy harvesting modes. The harvested energy is used to power the devices operations, e.g., circuit power consumption and sensing operation. In this paper, we focus on maximizing the throughput performance of AB communication system by adaptively selecting the operating mode under fading channel environment. We model the problem as an infinit…
In this paper, we consider a wireless cooperative network with an energy harvesting relay which is powered by the energy harvested from ambient RF waves, such as that of a data packet. At any given time, the relay operates either in the energy harvesting (EH) mode or the data decoding (DD) mode, but not both. Separate energy and data buffers are kept at the relay to store the harvested energy and decoded data packets, respectively. In this paper, we optimize a time switching policy that switches between the EH mode and DD mode to maximize the system throughput or minimize the average transmiss…
Internet of Things (IoT) devices can apply mobile-edge computing (MEC) and energy harvesting (EH) to provide the satisfactory quality of experiences for computation intensive applications and prolong the battery lifetime. In this article, we investigate the computation offloading for IoT devices with energy harvesting in wireless networks with multiple MEC devices such as base stations and access points, each with different computation resource and radio communication capability. We propose a reinforcement learning based computation offloading framework for an IoT device to choose the MEC devi…
We consider a distributed user association problem in the downlink of a small cell network, where small cells obtain the required energy for providing wireless services to users through ambient energy harvesting. Since energy harvesting is opportunistic in nature, the amount of harvested energy is a random variable, without a priori known characteristics. We model the network as a competitive market with uncertainty, where self-interested small cells, modeled as consumers, are willing to maximize their utility scores by selecting users, represented by commodities. The utility scores of small c…
Age of Information in Non-Terrestrial Networks with Energy Harvesting
ZJU-UIUC Institute, Zhejiang University（浙江大学中法联合学院）；Department of Computer and Information Science, Linkoping University（林雪平大学计算机与信息科学系）；National Mobile Communications Research Laboratory, Southeast University（东南大学移动通信国家重点实验室）
Backscattering assisted wireless-powered communication combines ultralow-power backscatter transmitters with energy harvesting devices. This paper investigates the transmission mode selection problem of a hybrid relay that forwards data by switching between the active wireless-powered transmission and the passive ambient backscattering. It first presents a hybrid relay system model and derives its end-to-end success probability under theoretically optimal, but practically unrealistic, conditions. The transmission mode selection is then formulated as a stochastic two-armed bandit problem in a v…
As of today, large-scale wireless sensor networks are adopted for smart building applications as they are easy and flexible to deploy. Low-power wireless nodes can achieve multi-year lifetimes with an AA battery using Bluetooth Low Energy (BLE) and Zig-Bee. However, replacing these batteries at scale is a non-trivial, labor-intensive task. Energy harvesting has emerged as a potential solution to avoid battery replacement but requires compromises such as application specific sensor node design, simplified communication protocol or reduced quality of service. We show the design of a battery-free…
The emerging Internet of Things (IoT)-driven ultra-dense small cell networks (UD-SCNs) will need to combat a variety of challenges. On one hand, massive number of devices sharing the limited wireless resources will render centralized control mechanisms infeasible due to the excessive cost of information acquisition and computations. On the other hand, to reduce energy consumption from fixed power grid and/or battery, many IoT devices may need to depend on the energy harvested from the ambient environment (e.g., from RF transmissions, environmental sources). However, due to the opportunistic na…
Towards Battery-Free Wireless Sensing via Radio-Frequency Energy Harvesting
City University of Hong Kong（香港城市大学）；Shandong University（山东大学）；Delft University of Technology（代尔夫特理工大学）；University at Buffalo, SUNY（纽约州立大学布法罗分校）；Macquarie University（麦考瑞大学）
We investigate an energy-harvesting wireless sensor transmitting latency-sensitive data over a fading channel. The sensor injects captured data packets into its transmission queue and relies on ambient energy harvested from the environment to transmit them. We aim to find the optimal scheduling policy that decides whether or not to transmit the queue's head-of-line packet at each transmission opportunity such that the expected packet queuing delay is minimized given the available harvested energy. No prior knowledge of the stochastic processes that govern the channel, captured data, or harvest…
CTTC/CERCA（加泰罗尼亚电信技术中心）；Imperial College London（伦敦帝国理工学院）
To meet the growing quest for enhanced network capacity, mobile network operators (MNOs) are deploying dense infrastructures of small cells. This, in turn, increases the power consumption of mobile networks, thus impacting the environment. As a result, we have seen a recent trend of powering mobile networks with harvested ambient energy to achieve both environmental and cost benefits. In this paper, we consider a network of virtualized small cells (vSCs) powered by energy harvesters and equipped with rechargeable batteries, which can opportunistically offload baseband (BB) functions to a grid-…
