测量了三个标称相同的304 L不锈钢真空室的放气速率,以确定室涂层和热处理的效果。一个腔室涂覆有氮化钛(TiN),一个腔室在制造后立即涂覆有非晶硅(a-Si)。最后一个腔室首先在没有任何涂层的情况下进行测试,然后在一系列热处理之后用a-Si涂覆。在90 ° C至400 °C的温度下烘烤后,在15 ° C至30 ° C的室温下测量每个腔室的脱气速率。对裸钢的测量显示,在400 °C热处理之后,除气速率显著降低了近20倍(热处理之前为3.5x10-12 Torr L s-1 cm-2,热处理之后降低至1.7x10-13 Torr L s-1 cm-2)。涂覆有a-Si的腔室显示出随着热处理的脱气速率的最小变化,尽管在a-Si涂覆之前通过热处理降低的脱气速率在一系列烘烤中被成功地保持。TiN涂覆的腔室表现出非常低的除气速率,比未涂覆的不锈钢低多达四个数量级,但是由于旋转转子计量累积测量的灵敏度限制以及由于TiN涂层中的不均匀性导致的小泵速的可能性,这些速率的不确定性很大。出气的结果进行了讨论的扩散限制与重组限制的过程。
英文摘要:
The outgassing rates of three nominally identical 304L stainless steel vacuum chambers were measured to determine the effect of chamber coatings and heat treatments. One chamber was coated with titanium nitride (TiN) and one with amorphous silicon (a-Si) immediately following fabrication. The last chamber was first tested without any coating, and then coated with a-Si following a series of heat treatments. The outgassing rate of each chamber was measured at room temperatures between 15 and 30 °C following bakes at temperatures between 90 and 400 °C. Measurements for bare steel showed a significant reduction in the outgassing rate by nearly a factor of 20 after a 400 °C heat treatment (3.5x10-12 Torr L s-1 cm-2 prior to heat treatment, reduced to 1.7x10-13 Torr L s-1 cm-2 following heat treatment). The chambers that were coated with a-Si showed minimal change in outgassing rates with heat treatment, though an outgassing rate reduced by heat treatments prior to a-Si coating was successfully preserved throughout a series of bakes. The TiN coated chamber exhibited remarkably low outgassing rates, up to four orders of magnitude lower than the uncoated stainless steel, but the uncertainty in these rates is large due to the sensitivity limitations of the spinning rotor gauge accumulation measurement and the possibility of a small pump speed due to inhomogeneity in the TiN coating. The outgassing results are discussed in terms of diffusion-limited versus recombination-limited processes.
A large Bradbury Nielsen ion gate with flexible wire spacing based on photo-etched stainless steel grids and its characterization applying symmetric and asymmetric potentials
Realistic Detector Geometry Modeling and Its Impact on Event Reconstruction in JUNO
Institute of High Energy Physics, Chinese Academy of Sciences(中国科学院高能物理研究所);School of Physical Sciences, University of Chinese Academy of Sciences(中国科学院大学物理科学学院)