In many common Al-Mg-Si alloys (6000 series) intermediate storage at or near 'room temperature' after solutionising leads to pronounced changes of the precipitation kinetics during the ensuing artificial ageing step at \approx 180°C. This is not only an annoyance in production, but also a challenge for researchers. We studied the kinetics of natural 'room temperature' ageing (NA) in Al-Mg-Si alloys by means of various different techniques, namely electrical resistivity and hardness measurement, thermoanalysis and positron lifetime and Doppler broadening (DB) spectroscopy to identify the stages in which the negative effect of NA on artificial ageing might appear. Positron lifetime measurements were carried out in a fast mode, allowing us to measure average lifetimes in below 1 minute. DB measurements were carried out with a single detector and a 68Ge positron source by employing high momentum analysis. The various measurements show that NA is much more complex than anticipated and at least four different stages can be distinguished. The nature of these stages cannot be given with certainty, but a possible sequence includes vacancy diffusion to individual solute atoms, nucleation of solute clusters, Mg agglomeration to clusters and coarsening or ordering of such clusters. Positron lifetime measurements after more complex ageing treatments involving storage at 0°C, 20°C and 180°C have also been carried out and help to understand the mechanisms involved.
The effect of Mg content on the natural ageing of Al-Cu-Li-(Mg) alloys has been investigated on a compositionally graded material made by linear friction welding, allowing to probe Mg contents between 0 and 0.4 at.%. High throughput time-and space-resolved characterization of natural ageing kinetics has been achieved using small-angle X-ray scattering, supplemented by differential scanning calorimetry. Natural ageing results mainly in the formation of Cu-rich clusters whose characteristics strongly depend on the presence of Mg. Larger precipitates of 2 nm size also form to a lesser extent abov…
Ageing mechanisms of the U-7\%wtNb alloy have been investigated on samples exposed to temperatures of 150$^{o}$C for up to 5000\,hours. A variety of surface and bulk analytic techniques have been used to investigate microstructural, chemical and crystallographic changes. Characterisation of the alloy's evolving behaviour was carried out through secondary electron microscopy, energy dispersive x-ray spectroscopy, electron backscatter diffraction, transmission electron microscopy and x-ray diffraction. Vickers hardness testing showed evidence of a strong thermal hardening relationship with agein…
In this study atom probe tomography was used to investigate the microstructure of AA2198 (Al-1.35Cu-3.55Li-0.29Mg-0.08Ag) over a range of ageing conditions to examine the evolution of phases in the alloy, in particular aiming to reveal the nucleation mechanism of the strengthening T1 phase, which has been under debate for decades. T1 precursor phases were observed from early ageing, a significant number of which were connected to solute-enriched dislocations. Ag and Mg segregation to T1 interfaces was convincingly observed when the plates were oriented perpendicular to the probing direction, w…
Ageing mechanisms of the U-5\,\%wtNb system have been investigated on samples exposed to temperatures of 150$\,^{\circ}$C for up to 5000\,hours. A variety of surface and bulk analytic techniques have been used to investigate phase, chemical and crystallographic changes. Characterisation of microstructural evolution was carried out through secondary electron microscopy (SEM), energy dispersive x-ray spectroscopy (EDS), electron backscatter diffraction (EBSD), transmission electron microscopy (TEM) and x-ray diffraction (XRD). This investigation suggests crystallographic defects such as twinning…
Al-Mg-Si alloys with total solute contents ranging from 0.8 to 1.4 wt.% were solutionised, quenched and then artificially aged (AA) at 180 °C, after which positron annihilation lifetime spectroscopy was applied to obtain information about precipitation and vacancy evolution during preceding ageing. Hardness and electrical resistivity measurements were carried out to complement these measurements. AA was carried out in four different heating media, which allowed for varying the heating rate from 2.4 K/s to 170 K/s. The main result of the study is that there is a competition between vacancy loss…
Room temperature solute clustering in aluminium alloys, or natural ageing, despite its industrial relevance, is still subject to debate, mostly due to its experimentally challenging nature. To better understand the complex multi-constituents' interactions at play, we have studied ternary and quaternary subsystems based on the Al-Cu alloys, namely Al-Cu-Mg, Al-Cu-Li and Al-Cu-Li-Mg. We used a recently introduced correlative technique using small-angle neutrons and X-ray scattering (SANS and SAXS) to extract the chemically resolved kinetics of room temperature clustering in these alloys, which w…
The chemical enrichment/ordering of solute atoms in Mg matrix are crucial to understand the formation mechanism of long-period stacking ordered (LPSO) structures. In this study, three-dimensional distribution of solute elements in an Mg-Zn-Gd alloy during ageing process is quantitatively characterized by three-dimensional atom probe (3DAP) tomography. Based on the radius distribution function, it is found that Zn-Gd solute pairs in Mg matrix appear mainly in two peaks at early stage of ageing and the separation distance between Zn and Gd atoms is well rationalized by the first-principles calcu…
The influence of hydrogen on the structural evolutions of an Al-Mg-Si alloy during natural and artificial ageing was investigated experimentally. The aim of the study was a better understanding of interactions between hydrogen and crystalline defects and especially vacancies. Experimental data demonstrate that during natural ageing in hydrogen environment, the hardening response is delayed. This is attributed to a slower recovery of excess vacancies linked to a lower mobility. To confirm and quantify the influence of hydrogen on the vacancy migration energy, artificial ageing was carried out i…
The Ni-based superalloy Alloy 718 is used in aircraft engines as high-pressure turbine discs and must endure challenging demands on high-temperature yield strength, creep-, and oxidation-resistance. Nanoscale $γ^{\prime}$- and $γ^{\prime \prime}$-precipitates commonly found in duplet and triplet co-precipitate morphologies provide high-temperature strength under these harsh operating conditions. Direct ageing of Alloy 718 is an attractive alternative manufacturing route known to increase the yield strength at 650 $^°$C by at least +10 $\%$, by both retaining high dislocation densities and chan…
We report on a quantitative investigation into the effect of size and distribution of rod-shaped β' precipitates on strength and ductility of a Mg-Zn alloy. Despite precipitation strengthening being crucial for the practical application of magnesium alloys this study represents the first systematic examination of the effect of controlled deformation on the precipitate size distribution and the resulting strength and ductility of a magnesium alloy. Pre-ageing deformation was used to obtain various distributions of rod-shaped β' precipitates through heterogeneous nucleation. Alloys were extruded…
The effects of ageing at 800 $^\circ$C on the properties of the IRIS alloy (Ti$_{49.9}$Al$_{48}$W$_2$B$_{0.1}$) are studied. The initial microstructure of this alloy densified by Spark Plasma Sintering (SPS) is mainly composed of lamellar colonies which are surrounded by $γ$ grains. The evolutions of the alloy strength and creep resistance resulting from this ageing treatment are measured by the related mechanical tests. The microstructural changes are investigated by scanning and transmission electron microscopies and by X-ray diffraction. The main structural evolutions consist in a shrinkage…
The effect of pre-ageing deformation on the size and distribution of beta-prime precipitates and subsequently on the resulting strength and ductility have been measured in a Mg-3.0at.%Zn-0.5at.%Y alloy. The alloy was extruded and then subjected to a T8 heat treatment comprised of a solution-treatment, cold-work and artificial ageing. Extrusion was used to introduce texture, ensuring that deformation occurred via slip rather than twinning. Samples were subjected to controlled uniaxial deformation and then isothermally aged to peak hardness. Precipitate length, diameter and number density were m…
The defects, the behavior of 3d electrons and the hyperfine interactions in binary Fe-Al alloys with different Al contents have been studied by the measurements of positron lifetime spectra, coincidence Doppler broadening spectra of positron annihilation radiation and Mossbauer spectra. The results show that on increasing the Al content in Fe-Al alloys, the mean positron lifetime of the alloys increase, while the mean electron density of the alloys decrease. The increase of Al content in binary Fe-Al alloys will decrease the amount of unpaired 3d electrons; as a consequence the probability of …
The consequences of hydrogen on the formation and growth of GP zones during natural ageing in an Al-5Cu alloy is investigated experimentally down to the atomic scale and numerically using ab initio calculations. As observed through scanning/transmission electron microscopy, the hardening kinetic is delayed due to a slower growth of GP zones during natural ageing when hydrogen is incorporated. According to ab initio calculations, the delayed hardening results from hydrogen trapped in vacancies that reduce significantly the diffusion coefficient of copper and the self diffusion of aluminium. Thi…
We present the results of lifetime positron annihilation spectroscopy (PALS) for the alloys Fe21Ga and Fe22.4Ga, whose defect structure is connected with annealing from 20 to 1000C along the phase diagram of Fe21Ga and Fe22.4Ga, at the L12-A2 transitions and in the sub-lattice of the D03 phase. In frames of the standard trapping model, we estimate the positron annihilation parameters for the bulk metal and for the different thermal vacancies herein. Also we define concentrations of these vacancy defects, which may be helpful for explanation of the physical properties of Ge-Ga alloys, including…
The influence of initial heat treatment on anomalous Cr precipitation within high temperature solubility region in Fe-9Cr alloy has been investigated using positron lifetime studies. Air-quenched samples with pre-existing dislocations exhibited a distinct annealing stage in positron lifetime between 800 and 1100 K corresponding to Cr-precipitation. During this stage, Transmission Electron Microscopy showed fine precipitates of average size 4 nm, dispersed throughout the sample and from EDS analysis they are found to be Cr-enriched. The existence of dislocations is found to be responsible for C…
Electron-positron momentum distributions measured by the coincidence Doppler broadening method can be used in the chemical analysis of the annihilation environment, typically a vacancy-impurity complex in a solid. In the present work, we study possibilities for a quantitative analysis, i.e., for distinguishing the average numbers of different atomic species around the defect. First-principles electronic structure calculations self-consistently determining electron and positron densities and ion positions are performed for vacancy-solute complexes in Al-Cu, Al-Mg-Cu, and Al-Mg-Cu-Ag alloys. The…
This work presents a detailed investigation into the effect of a low Cu addition (0.01 at.%) on precipitation in an Al-0.80Mg-0.85Si alloy during ageing. The precipitate crystal structures were assessed by scanning transmission electron microscopy combined with a novel scanning precession electron diffraction approach, which includes machine learning. The combination of techniques enabled evaluation of the atomic arrangement within individual precipitates, as well as an improved estimate of precipitate phase fractions at each ageing condition, through analysis of a statistically significant nu…
The transitional state of ordering in the long-period stacking ordered (LPSO) structure in Mg-Al-Gd alloy has been investigated by scanning transmission electron microscopy. It is found that the domains are the origin of observed transitional state. Three new patterns of clusters at this state can be fully explained by the superimposition of L12 type clusters located in different domains. The domains are further verified by different tilted views. Growth of preferred domains during ageing process will result in final ordered LPSO structure. Based on the idea of domains, less ordered LPSO struc…
The process of natural aging in pure ternary Al-Mg-Si alloys was studied by positron annihilation lifetime spectroscopy in real time in order to clarify the sequence and kinetics of clustering and precipitation. It was found that natural aging takes place in at least five stages in these alloys, four of which were directly observed. This is interpreted as the result of complex interactions between vacancies and solute atoms or clusters. One of the early stages of positron lifetime evolution coincides with a clustering process observed by differential scanning calorimetry (DSC) and involves the…
The close-range interaction of dislocations and solute clusters in the Al-Mg binary system is studied by means of atomistic simulations. We evaluate the binding energy of dislocations to the thermodynamically stable solute atmospheres that form around their cores, at various temperatures and average solid solution concentrations. A measure of the cluster size that renders linear the relationship between the binding energy and the cluster size is identified. It is shown that as the temperature increases the representative cluster dissolves following an Arrhenius law. The corresponding activatio…
Co-evolution of point defects and Cr-rich nano-phase in binary Fe-20 at.% Cr alloy: A comprehensive investigation using positron annihilation spectroscopy and atom probe tomography
The kinetics of coherent Cu rich precipitation in Fe-Cu and Fe-Cu-Ni alloys during thermal ageing have been modeled by Atomic Kinetic Monte Carlo method (AKMC). The AKMC is parameterized by existing ab-inito data to treat vacancy mediated diffusion which is depend on local atomic environment. A nonlinear semi-empirical time adjusting method is proposed to rescaled the MC time. The combining AKMC and time adjusting method give a good agreement with experiments and other simulations, including advancement factor and the Cu cluster mobility. Simulations of ternary alloys reveal Ni has a temporal …
Challenges in predicting positron annihilation lifetimes in lead halide perovskites: correlation functionals and polymorphism
Université Paris-Saclay（巴黎萨克雷大学）；CEA（法国原子能和替代能源委员会）；Service de Recherches en Corrosion et Comportement des Matériaux, SRMP（腐蚀与材料行为研究服务，SRMP）；Department of Physics, IriG, Univ. Grenoble-Alpes and CEA（格勒诺布尔阿尔卑斯大学物理系，IriG 及 CEA）；CEA/DRF/IRAMIS；University Paris-Saclay（巴黎萨克雷大学）；Department of Physics, University of Helsinki（赫尔辛基大学物理系）
Understanding the nature and behavior of vacancy-like defects in epitaxial GeSn metastable alloys is crucial to elucidate the structural and optoelectronic properties of these emerging semiconductors. The formation of vacancies and their complexes is expected to be promoted by the relatively low substrate temperature required for the epitaxial growth of GeSn layers with Sn contents significantly above the equilibrium solubility of 1 at.%. These defects can impact both the microstructure and charge carrier lifetime. Herein, to identify the vacancy-related complexes and probe their evolution as …
