短沟道MOSFET中势垒降低和背散射提取
Barrier Lowering and Backscattering Extraction in Short-Channel MOSFETs
摘要:
在这项工作中,我们提出了一个完整的实验方法来提取势垒降低短沟道饱和MOSFET使用Lundstrom背散射输运模型在一个子带近似和载流子简并。势垒降低的知识在操作偏置点的反转制度是至关重要的设备缩放。同时,我们也得到了后向散射比和饱和反转电荷的估计。相对于以前报道的基于Lundstrom模型的输运参数提取的工作,我们的提取方法是完全一致的,而其他方法在计算饱和反转电荷时进行了一些近似,这些近似与模型不一致。所提出的实验提取方法已被验证,并适用于器件模拟和测量的结果,短沟道多晶硅/SiON栅极nMOSFET的栅极长度下降到70 nm。此外,我们提出了一个扩展的背散射模型的情况下的二维几何形状(如散装MOSFET)。我们发现,在这种情况下,背散射是由载流子传输在几个纳米接近的硅/氧化物界面和1D的方法获得的背散射比的值可以显着不同的从真正的2D值。
英文摘要:
In this work we propose a fully experimental method to extract the barrier lowering in short-channel saturated MOSFETs using the Lundstrom backscattering transport model in a one sub-band approximation and carrier degeneracy. The knowledge of the barrier lowering at the operative bias point in the inversion regime is of fundamental importance in device scaling. At the same time we obtain also an estimate of the backscattering ratio and of the saturation inversion charge. Respect to previously reported works on extraction of transport parameters based on the Lundstrom model, our extraction method is fully consistent with it, whereas other methods make a number of approximations in the calculation of the saturation inversion charge which are inconsistent with the model. The proposed experimental extraction method has been validated and applied to results from device simulation and measurements on short-channel poly-Si/SiON gate nMOSFETs with gate length down to 70 nm. Moreover we propose an extension of the backscattering model to the case of 2D geometries (e.g. bulk MOSFETs). We found that, in this case, the backscattering is governed by the carrier transport in a few nanometers close to the silicon/oxide interface and that the value of the backscattering ratio obtained with a 1D approach can be significantly different from the real 2D value.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。