Beamforming is a widely used method of provisioning high quality wireless channels that leads to high data rates and simple decoding structures. It requires feedback of Channel State Information (CSI) from receiver to transmitter, and the accuracy of this information is limited by rate constraints on the feedback channel and by delay. It is important to understand how the performance gains associated with beamforming depend on the accuracy or currency of the Channel State Information. This paper quantifies performance degradation caused by aging of CSI. It uses outage probability to measure the currency of CSI, and to discount the performance gains associated with ideal beamforming. Outage probability is a function of the beamforming algorithm and results are presented for Transmit Antenna Selection and other widely used methods. These results are translated into effective diversity orders for Multiple Input Single Output (MISO) and Multiuser Multiple Input Multiple Output (MIMO) systems.
EM-Guided Graph Learning for Fluid Antenna Beamforming under Current-Domain Constraints
College of Artificial Intelligence, Nanjing University of Information Science and Technology（南京信息工程大学人工智能学院）；School of Cyber Science and Engineering, Southeast University（东南大学网络空间安全学院）；National Mobile Communications Research Laboratory, Southeast University（东南大学移动通信国家重点实验室）；Purple Mountain Laboratories（紫金山实验室）
Magnetic resonant coupling (MRC) is an efficient method for realizing the near-field wireless power transfer (WPT). The use of multiple transmitters (TXs) each with one coil can be applied to enhance the WPT performance by focusing the magnetic fields from all TX coils in a beam toward the receiver (RX) coil, termed as "magnetic beamforming". In this paper, we study the optimal magnetic beamforming for an MRC-WPT system with multiple TXs and a single RX. We formulate an optimization problem to jointly design the currents flowing through different TXs so as to minimize the total power drawn fro…
Three dimensional beamforming (3D) (also elevation beamforming) is now gaining a growing interest among researchers in wireless communication. The reason can be attributed to its potential to enable a variety of strategies like sector or user specific elevation beamforming and cell-splitting. Since these techniques cannot be directly supported by current LTE releases, the 3GPP is now working on defining the required technical specifications. In particular, a large effort is currently made to get accurate 3D channel models that support the elevation dimension. This step is necessary as it will …
We study distributed algorithms for adjusting beamforming vectors and receiver filters in multiple-input multiple-output (MIMO) interference networks, with the assumption that each user uses a single beam and a linear filter at the receiver. In such a setting there have been several distributed algorithms studied for maximizing the sum-rate or sum-utility assuming perfect channel state information (CSI) at the transmitters and receivers. The focus of this paper is to study adaptive algorithms for time-varying channels, without assuming any CSI at the transmitters or receivers. Specifically, we…
In this paper, we consider multigroup multicast transmissions with different types of service messages in an overloaded multicarrier system, where the number of transmitter antennas is insufficient to mitigate all inter-group interference. We show that employing a rate-splitting based multiuser beamforming approach enables a simultaneous delivery of the multiple service messages over the same time-frequency resources in a non-orthogonal fashion. Such an approach, taking into account transmission power constraints which are inevitable in practice, outperforms classic beamforming methods as well…
This paper investigates deep learning techniques to predict transmit beamforming based on only historical channel data without current channel information in the multiuser multiple-input-single-output downlink. This will significantly reduce the channel estimation overhead and improve the spectrum efficiency especially in high-mobility vehicular communications. Specifically, we propose a joint learning framework that incorporates channel prediction and power optimization, and produces prediction for transmit beamforming directly. In addition, we propose to use the attention mechanism in the Lo…
One of the important use-cases of 5G network is the vehicle to infrastructure (V2I) communication which requires accurate understanding about its dynamic propagation environment. As 5G base stations (BSs) tend to have multiple antennas, they will likely employ beamforming to steer their radiation pattern to the desired vehicle equipment (VE). Furthermore, since most wireless standards employ an OFDM system, each VE may use one or more sub-carriers. To this end, this paper proposes a joint design of adaptive channel prediction, beamforming and scheduling for 5G V2I communications. The channel p…
In this paper, the required amount of feedback overhead for multiple-input multiple-output (MIMO) beamforming over time-varying channels is presented in terms of the entropy of the feedback messages. In the case that each transmit antenna has its own power amplifier which has individual power limit, it has been known that only phase steering information is necessary to form the optimal transmit beamforming vector. Since temporal correlation exists for wireless fading channels, one can utilize the previous reported feedback messages as prior information to efficiently encode the current feedbac…
The use of large-scale antenna systems in future commercial wireless communications is an emerging technology that uses an excess of transmit antennas to realize high spectral efficiency. Achieving potential gains with large-scale antenna arrays in practice hinges on sufficient channel estimation accuracy. Much prior work focuses on TDD based networks, relying on reciprocity between the uplink and downlink channels. However, most currently deployed commercial wireless systems are FDD based, making it difficult to exploit channel reciprocity. In massive MIMO FDD systems, the problem of channel …
In magnetic resonant coupling (MRC) enabled multiple-input multiple-output (MIMO) wireless power transfer (WPT) systems, multiple transmitters (TXs) each with one single coil are used to enhance the efficiency of simultaneous power transfer to multiple single-coil receivers (RXs) by constructively combining their induced magnetic fields at the RXs, a technique termed "magnetic beamforming". In this paper, we study the optimal magnetic beamforming design in a multi-user MIMO MRC-WPT system. We introduce the multi-user power region that constitutes all the achievable power tuples for all RXs, su…
This paper considers the so-called multiple-input-multiple-output interference channel (MIMO-IC) which has relevance in applications such as multi-cell coordination in cellular networks as well as spectrum sharing in cognitive radio networks among others. We consider a beamforming design framework based on striking a compromise between beamforming gain at the intended receiver (Egoism) and the mitigation of interference created towards other receivers (Altruism). Combining egoistic and altruistic beamforming has been shown previously in several papers to be instrumental to optimizing the rates…
Linear precoding exploits the spatial degrees of freedom offered by multi-antenna transmitters to serve multiple users over the same frequency resources. The present work focuses on simultaneously serving multiple groups of users, each with its own channel, by transmitting a stream of common symbols to each group. This scenario is known as physical layer multicasting to multiple co-channel groups. Extending the current state of the art in multigroup multicasting, the practical constraint of a maximum permitted power level radiated by each antenna is tackled herein. The considered per antenna p…
Scaling the number of antennas up is a key characteristic of current and future wireless communication systems. The hardware cost and power consumption, however, motivate large-scale MIMO systems, especially at millimeter wave (mmWave) bands, to rely on analog-only or hybrid analog/digital transceiver architectures. With these architectures, mmWave base stations normally use pre-defined beamforming codebooks for both initial access and data transmissions. Current beam codebooks, however, generally adopt single-lobe narrow beams and scan the entire angular space. This leads to high beam trainin…
Duzce University（迪兹杰大学）；University of Luxembourg（卢森堡大学）
Hybrid analog and digital beamforming transceivers are instrumental in addressing the challenge of expensive hardware and high training overheads in the next generation millimeter-wave (mm-Wave) massive MIMO (multiple-input multiple-output) systems. However, lack of fully digital beamforming in hybrid architectures and short coherence times at mm-Wave impose additional constraints on the channel estimation. Prior works on addressing these challenges have focused largely on narrowband channels wherein optimization-based or greedy algorithms were employed to derive hybrid beamformers. In this pa…
The current literature on intelligent reflecting surface (IRS) focuses on optimizing the IRS phase shifts to yield coherent beamforming gains, under the assumption of perfect channel state information (CSI) of individual IRS-assisted links, which is highly impractical. This work, instead, considers the random rotations scheme at the IRS in which the reflecting elements only employ random phase rotations without requiring any CSI. The only CSI then needed is at the base station (BS) of the overall channel to implement the beamforming transmission scheme. Under this framework, we derive the sum-…
We consider multi-antenna base stations using orthogonal frequency division multiple access and space division multiple access techniques to serve single-antenna users. Some users, called real-time users, have minimum rate requirements and must be served in the current time slot while others, called non real-time users, do not have strict timing constraints and are served on a best-effort basis. The resource allocation problem is to find the assignment of users to subcarriers and the transmit beamforming vectors that maximize the total user rates subject to power and minimum rate constraints. …
Extremely large-scale multiple-input multiple-output (XL-MIMO) communication aims to further boost the antenna size significantly than current massive MIMO systems, for which conventional far-field assumption with uniform plane wave (UPW) model may become invalid. This paper studies the modelling and performance analysis for multi-user XL-MIMO communication. With the spherical wavefront phase modelling, and also by taking into account the variations of signal amplitude and projected aperture across array elements, the performance of the three typical beamforming schemes are analyzed, namely th…
Hybrid Knowledge-Data Driven Channel Semantic Acquisition and Beamforming for Cell-Free Massive MIMO
Beijing Institute of Technology（北京理工大学）；Yangtze Delta Region Academy, Beijing Institute of Technology (Jiaxing)（北京理工大学长三角研究院（嘉兴））；Advanced Technology Research Institute, Beijing Institute of Technology（北京理工大学前沿技术研究院）；China Mobile (Chengdu) Institute of Research and Development（中国移动（成都）研究院）
Rutgers, The State University of New Jersey（罗格斯新泽西州立大学）；University of Pennsylvania（宾夕法尼亚大学）
While millimeter wave (mmWave) communications promise high data rates, their sensitivity to blockage and severe signal attenuation presents challenges in their deployment in urban settings. To overcome these effects, we consider a distributed cooperative beamforming system, which relies on static relays deployed in clusters with similar channel characteristics, and where, at every time instance, only one relay from each cluster is selected to participate in beamforming to the destination. To meet the quality-of-service guarantees of the network, a key prerequisite for beamforming is relay sele…
In this paper, we study multibeam satellite secure communication through physical (PHY) layer security techniques, i.e., joint power control and beamforming. By first assuming that the Channel State Information (CSI) is available and the beamforming weights are fixed, a novel secure satellite system design is investigated to minimize the transmit power with individual secrecy rate constraints. An iterative algorithm is proposed to obtain an optimized power allocation strategy. Moreover, sub-optimal beamforming weights are obtained by completely eliminating the co-channel interference and nulli…
Benefiting from huge bandwidth resources, millimeter-wave (mmWave) communications provide one of the most promising technologies for next-generation wireless networks. To compensate for the high pathloss of mmWave signals, large-scale antenna arrays are required both at the base stations and user equipment to establish directional beamforming, where beam-management is adopted to acquire and track the optimal beam pair having the maximum received power. Naturally, narrow beams are required for achieving high beamforming gain, but they impose enormous training overhead and high sensitivity to bl…
DJSCC-Enabled Multi-User Semantic CSI Feedback for Hybrid Beamforming in Dual-Polarized cmWave Massive MIMO
Beijing Institute of Technology（北京理工大学）；Yangtze Delta Region Academy, BIT (Jiaxing)（北京理工大学长三角研究院（嘉兴））；University of the Witwatersrand（威特沃特斯兰德大学）；Harbin Institute of Technology（哈尔滨工业大学）
We consider the time correlated multiple-input single-output (MISO) broadcast channel where the transmitter has imperfect knowledge on the current channel state, in addition to delayed channel state information. By representing the quality of the current channel state information as P^-α for the signal-to-noise ratio P and some constant α \geq 0, we characterize the optimal degree of freedom region for this more general two-user MISO broadcast correlated channel. The essential ingredients of the proposed scheme lie in the quantization and multicasting of the overheard interferences, while broa…
In order to cope with the large path-loss exponent of mm-Wave channels, a high beamforming gain is needed. This can be achieved with small hardware complexity and high hardware power efficiency by Hybrid Digital-Analog (HDA) beamforming, where a very large number $M\gg 1$ of antenna array elements requires only a relatively small $m\ll M$ number of A/D converters and modulators/demodulators. As such, the estimation of mm-Wave MIMO channels must deal with two specific problems: 1) high Doppler, due to the large carrier frequency; 2) impossibility of observing directly the M-dimensional channel …
We investigate Gaussian widely linear precoding known as improper Gaussian signaling for the cellular uplink with inter-cell interference, known as interference multiple access channel (IMAC). This transmission scheme provides extra degrees of freedom by treating the real and imaginary components of the complex Gaussian signal differently. Since current standards mainly utilize linear beamforming for waveform generation, we highlight the benefits of widely linear beamforming over multiple temporal dimensions (symbol extension in time) in the IMAC. This scheme achieves significantly higher info…
