车削中的自激振动:力扭转和平均摩擦系数分析
Self-Excited Vibrations in Turning: Efforts Torsor and Average Friction Coefficient Analysis
摘要:
在车削实验装置,特别是包括一个六分量测力计被用来测量在自激振动的情况下,切削力的完整扭矩。对于测试,使用的工具是TNMA 16 04 12型硬质合金,没有覆盖(nuance carbide-SUMITIMO ELECTRIC),没有屑屑。加工材料是铬钼合金42 CrMo 24。试管为圆柱形,直径为120 mm,长度为30 mm。分析工作与力矩有关。特别是在刀尖处,随着进给量的增大,回转摩擦系数增大,轴承摩擦系数减小。对不同切削深度和进给量下的平均摩擦系数的演变提出了创新性的意见
英文摘要:
An experimental device in turning including, in particular, a six-component dynamometer is exploited to measure the complete torque of cutting forces in a case of self-excited vibrations. For the tests, the tool used is type TNMA 16 04 12 carbide not covered (nuance carbide-SUMITIMO ELECTRIC), without chip breeze. The machined material is an alloy of chrome molybdenum type 42 CrMo24. The test-tubes are cylindrical with a diameter of 120 mm and a length of 30 mm. The effort of analysis relates to the moments. In particular, to the tool tip point, when feed rate increases the friction coefficient of swivelling is increasing while that of bearing is decreasing. Innovative remarks on the evolution of the average friction coefficient for various depths of cut and feed rate are presented
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。