arXivDaily arXiv每日学术速递 周一至周五更新
arXiv 0810.1540cond-mat.mes-hallcond-mat.mtrl-sci
收藏

60 nm栅长III-V InGaAs HEMT的性能分析:模拟与实验

Performance Analysis of 60nm gate length III-V InGaAs HEMTs: Simulations vs. experiments

Neophytos Neophytou, Titash Rakshit, Mark S. Lundstrom

摘要:

本文分析了高性能In0.7Ga0.3As高电子迁移率晶体管(HEMT)的最新实验数据。使用一个完全量子力学,弹道模型,我们模拟In0.7Ga0.3As HEMT与LG = 60 nm,85,和135 nm的栅极长度和比较的结果测量的I-V特性,包括漏致势垒降低,亚阈值摆动,阈值电压随栅极绝缘层厚度的变化,以及导通电流性能。对于一阶,具有三种不同氧化层厚度和沟道长度的器件都可以通过我们的弹道模型与适当的寄生串联电阻值来描述。然而,对于高栅极电压,弹道模拟一致高估了测量的导通电流,并且它们没有显示实验观察到的导通电流随着栅极长度的增加而减小。在完全没有寄生串联电阻的情况下,LG = 60 nm器件的模拟导通电流约为测量电流的两倍。根据模拟,该器件的弹道载流子注入速度估计约为2.7 × 10^7 cm/s。由于半导体电容的重要性,模拟的栅极电容比绝缘体电容小约2.5倍。在这些设备中的高栅电压下观察到的dielectric退化的可能原因也进行了探讨。除了一个可能的栅极电压依赖的散射机制,有限的能力的源供应载流子的通道,和非抛物性的效果可能会发挥作用。随着栅极长度的增加,导通电流的下降表明器件在弹道极限以下工作。

英文摘要:

An analysis of recent experimental data for high-performance In0.7Ga0.3As high electron mobility transistors (HEMTs) is presented. Using a fully quantum mechanical, ballistic model, we simulate In0.7Ga0.3As HEMTs with gate lengths of LG = 60nm, 85, and 135 nm and compare the result to the measured I-V characteristics including draininduced barrier lowering, sub-threshold swing, and threshold voltage variation with gate insulator thickness, as well as on-current performance. To first order, devices with three different oxide thicknesses and channel lengths can all be described by our ballistic model with appropriate values of parasitic series resistance. For high gate voltages, however, the ballistic simulations consistently overestimate the measured on-current, and they do not show the experimentally observed decrease in on-current with increasing gate length. With no parasitic series resistance at all, the simulated on-current of the LG = 60 nm device is about twice the measured current. According to the simulation, the estimated ballistic carrier injection velocity for this device is about 2.7 x 10^7 cm/s. Because of the importance of the semiconductor capacitance, the simulated gate capacitance is about 2.5 times less than the insulator capacitance. Possible causes of the transconductance degradation observed under high gate voltages in these devices are also explored. In addition to a possible gate-voltage dependent scattering mechanism, the limited ability of the source to supply carriers to the channel, and the effect of nonparabolicity are likely to play a role. The drop in on-current with increasing gate length is an indication that the devices operate below the ballistic limit.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑