Bates直线加速器发射机相位和幅度监测系统
The Bates Linear Accelerator Transmitter Phase and Amplitude Monitoring System
摘要:
Bates直线加速器使用6个4 MW 2.856GHz射频发射器。发射器12速调管之间大于0.5度的相位漂移或任何幅度漂移损害射束递送并且是常见的。在相位和振幅监测系统“PAM”之前的几年里,机器操作员无法分辨哪个速调管影响射束,并采取实验性地移动每个速调管的相位。PAM系统已证明是一种可行的监测器,便于相位重新调整。PAM由现成的RF幅度和相位检测器、移相器、分路器和EPICS下的VME硬件组成。检测到的信号被放大并通过EPICS驱动的定制视频开关矩阵化到控制室,进行采样/保持,然后由VME 12位ADC数字化。14个通道中的每一个都采用移相器和代码,可以自动调零显示的相位。相位漂移是明显的。幅度设定点也可以自动调零,漂移显示为功率偏差。为了确保可重复性小于0.25度,采用连续校准序列器,该序列器已被证明可以独立于幅度偏移测量相位漂移。正在研究的是60 Hz源和慢相位反馈和校正的可行性。
英文摘要:
The Bates Linear Accelerator uses six 4MW 2.856GHz RF transmitters. Phase drifts between the transmitters 12 klystrons of greater than 0.5 degree or any amplitude drifts compromise beam delivery and are a common occurrence. Machine operators in years previous to the Phase and Amplitude Monitoring system "PAM" were unable to tell which klystron was affecting beam and resorted to shifting the phases of each klystron experimentally. The PAM system has proven itself as a viable monitor, easing phase re-adjustment. PAM is comprised of off-the-shelf RF amplitude and phase detectors, phase shifters, splitters, and VME hardware under EPICS . The detected signals are amplified and matrixed to the control room via an EPICS driven custom video switch, are sample/held, then digitized by a VME 12bit ADC. Each of the 14 channels employ phase shifters and code that can auto zero the displayed phase. Phase drift is then apparent. Amplitude setpoints can also be auto zeroed with drift displayed as power deviations. To ensure repeatability to less than 0.25 degree a continuous calibration sequencer is employed that has been shown to measure phase drift independent of amplitude shifts. Under investigation is the viability of 60Hz sourced and slow phase feedback and correction.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。