arXivDaily arXiv每日学术速递 周一至周五更新
arXiv 1806.09197physics.ins-det
收藏

用于E-XFEL飞秒同步的相位漂移补偿RF链路

Phase Drift Compensating RF Link for Femtosecond Synchronization of E-XFEL

Dominik Sikora, Krzysztof Czuba, Pawel Jatczak, Maciej Urbanski, Holger Schlarb, Frank Ludwig, Heinrich Pryschelski

摘要:

现代的高能粒子加速器和自由电子激光包含了分布在千米距离上的大量灵敏的RF和微波频率设备。这种装置需要借助沿加速器设施分布的高频信号实现极其稳定的相位和时间同步。同轴电缆通常用于在大型机器上分配参考信号以同步电子系统,并且它们是同步系统中不期望的相位漂移的主要来源。电缆中的信号相位漂移主要是由温度和湿度变化引起的,其值通常超过所需的相位同步精度一个数量级以上。有几种方法可以减少同轴电缆中的信号相位漂移。介绍了基于干涉现象的主动稳相系统的实现方法。来自发射机的锁相信号在同轴电缆链路的末端反射。沿电缆放置的定向耦合器拾取前向和反射信号并干扰它们以抵消电缆相位漂移。分布式硬件,包括干涉仪控制器/发射机和接收机模块的建立,以证明系统的概念和性能。链路输入输出设备采用带以太网接口的FPGA I/O板控制系统运行。开发了专门的固件和软件来校准和控制系统。本文介绍了干涉仪链路的概念、硬件设计、基本控制算法和性能评估结果。链路原型是通过同轴电缆分配1.3 GHz信号。测得的相位漂移抑制因子值超过100的水平。

英文摘要:

Modern high-energy particle accelerators and Free-Electron Lasers incorporate large quantities of sensitive RF and microwave frequency devices distributed over kilometer distances. Such devices require extreme stable phase and time synchronization by means of high frequency signal distributed along the accelerator facility. Coaxial cables are commonly used to distribute the reference signal over the large machine to synchronize electronic systems and they are the main source of undesirable phase drifts in the synchronization system. Signal phase drifts in cables are mainly caused by temperature and humidity variations and their values usually exceed required phase synchronization accuracy by more than order of magnitude. There are several approaches to reduce signal phase drifts in coaxial cables. This paper describes the realization of active phase stabilization system based on interference phenomenon. A phase-locked signal from the transmitter is reflected at the end of a coaxial cable link. Directional couplers placed along the cable pick up the forward and reflected signals and interfere them to cancel out the cable phase drifts. Distributed hardware including interferometer controller/transmitter and receiver modules were built to demonstrate system concept and performance. Link input and output devices used FPGA I/O boards with Ethernet interface to control system operation. Specialized firmware and software was developed to calibrate and control the system. This paper describes the concept of interferometer link, designed hardware, basic control algorithms and performance evaluation results. The link prototype was built to distribute 1.3 GHz signal through a coaxial cable. Measured phase drift suppression factor value exceeded level of 100.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑