arXivDaily arXiv每日学术速递 周一至周五更新
arXiv周末暂无论文更新,休息一下吧,周末愉快~~
arXiv 2603.21910cs.ET
收藏

多级CFET设计中的自加热与寄生效应

Self-Heating and Parasitic Effects in Multi-Tier CFET Design

Technical University of Munich(慕尼黑工业大学);Indian Institute of Technology (IIT) Kanpur(坎普尔印度理工学院)

Sufia Shahin, Mahdi Benkhelifa, Yogesh Singh Chauhan, Hussam Amrouch

AI总结:

本文研究多级CFET设计中自加热效应及MOL和BEOL寄生效应的影响,通过TCAD模型分析2级与4级CFET设计的温度分布和寄生RC网络,揭示寄生效应导致的延迟增加问题。

摘要:

本文研究自加热效应(SHEs)及MOL和BEOL引起的寄生效应对多级CFET设计的影响,其中多个纳米片器件垂直堆叠。通过校准到实验测量的TCAD模型,分析并比较4级CFET设计与传统2级CFET设计。此外,使用TCAD模拟来建模和分析SHE引起的热分布和温度分布,并从具有完整MOL和BEOL互连的CMOS反相器的3D模型中提取详细的寄生RC网络。在器件层面,2级CFET架构中nFET和pFET器件因SHE引起的最大温度上升分别为62 K和74 K。由于距离基底散热器的距离增加,4级设计中的上层nFET和pFET器件显示出更高的最大温度上升为83.5 K和98.5 K,并在堆叠层中存在更多的热量滞留。此外,在基于4级CFET的CMOS反相器中,BEOL引起的寄生RC分别为顶部层级比2级CFET反相器高10倍,底部层级比2级CFET反相器高2倍。最后,与无寄生效应的4级设计相比,顶部和底部层级反相器的传播延迟分别增加了10%和8.2%,由于互连寄生RC。对于传统2级反相器,寄生RC导致的延迟降级为37.25%。

英文摘要:

In this article, we study the impact of self-heating effects (SHEs) and middle of line (MOL) and back-end of line (BEOL) induced parasitics on multi-tier CFET design, where multiple nanosheet devices are vertically stacked. We analyze and compare the 4-tier CFET design with the conventional 2-tier CFET, using TCAD models calibrated to experimental measurements. Additionally, TCAD simulations are used to model and analyze SHE-induced heat distribution and temperature profiles and to extract the detailed parasitic RC network from 3D models of CMOS inverters designed with full MOL and BEOL interconnects. At the device level, the maximum temperature rise (TMAX) caused by SHE in nFET and pFET devices of the 2-tier CFET architecture is 62 K and 74 K, respectively. Due to the increased distance from the substrate heat sink, the upper-tier nFET and pFET devices in the 4-tier design show higher TMAX of 83.5 K and 98.5 K and more heat trapping in the stacked layers. Furthermore, in the 4-tier CFET-based CMOS inverters, the BEOL-induced parasitic RCs are, respectively, 10 and 6.5 times higher in the top-tier than in the 2-tier CFET-based inverters. In the bottom tier, the corresponding parasitic RC elements are 6.26 and 2 times higher, respectively, than in the 2-tier inverters. Finally, compared to the 4-tier design without parasitics, the propagation delay of the top and bottom tier inverters increases by 10% and 8.2%, respectively, due to the interconnect parasitic RCs. For the conventional 2-tier inverter, the corresponding degradation of delay with parasitic RCs is 37.25%.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑