In this work, we propose a deep unified (DU) encoder that embeds source information in a codeword that contains sufficient redundancy to handle both channel and source uncertainties, without enforcing an explicit pilot-data separation. At the receiver, we design a parallel flow-matching (PFM) decoder that leverages flow-based generative priors to jointly estimate the channel and the source, yielding much more efficient inference than the existing diffusion-based approaches. To benchmark performance limits, we derive the Bayesian Cramér-Rao bound (BCRB) for the joint channel and source estimation problem. Extensive simulations over block-fading MIMO-OFDM channels demonstrate that the proposed DU-PFM approach drastically outperforms the state-of-the-art methods in both channel estimation accuracy and source reconstruction quality.
This paper investigates the impact of the number of antennas (8 to 64) and the array configuration on massive MIMO channel parameters estimation for multiple propagation scenarios at 3.5 GHz. Different measurement environments are artificially created by placing several reflectors and absorbers in an anechoic chamber. Ground truth channel parameters, e.g, path angles, are obtained by geometry and trigonometric rules. Then, these are compared to the channel parameters extracted by the applying Space-Alternating Generalized Expectation-Maximization (SAGE) algorithm on the measurements. Overall, …
Consumer electronic (CE) devices increasingly rely on wireless local area networks (WLANs). Next generation WLANs will continue to exploit multiple antenna systems to satisfy the growing need for WLAN system capacity. Multiple-input multiple-output (MIMO) antenna systems improve the spectral efficiency and single user throughput. Multi-user MIMO (MU-MIMO) systems exploit the spatial separation of users for increasing the sum-throughput. In an MU-MIMO system, efficient channel sounding is essential for achieving optimal performance. The system analysis in this paper provides insights into the r…
In contrast to the state-of-the-art technology, it is envisaged that 5G systems will accommodate a broad range of services and a variety of emerging applications. In fact, the advent of the Internet of Things (IoT) and its integration with conventional human-initiated transmissions yields the need for a fundamental system redesign. Hence, the ideal waveform for the upcoming 5G radio access technology should cope with several requirements, such as low computational complexity, good time and frequency localization and straightforward extension to \emph{multiple-input multiple-output} (MIMO) syst…
This work analyzes the performance of the implementable detectors for multiple-input-multiple-output (MIMO) orthogonal frequency division multiplexing (OFDM) technique under specific and realistic operation system condi- tions, including antenna correlation and array configuration. Time-domain channel model has been used to evaluate the system performance under realistic communication channel and system scenarios, including different channel correlation, modulation order and antenna arrays configurations. A bunch of MIMO-OFDM detectors were analyzed for the purpose of achieve high performance …
Hybrid beamforming is considered a key enabler to realize millimeter wave (mmWave) multiple-input multiple-output (MIMO) communications due to its capability of considerably reducing the number of costly and power-hungry radio frequency chains in the transceiver. However, in mmWave MIMO orthogonal frequency-division multiplexing (MIMO-OFDM) systems, hybrid beamforming design is challenging because the analog precoder and combiner are required to be shared across the whole employed bandwidth. In this paper, we propose closed-form solutions to the problem of designing the analog precoder/combine…
This paper considers the problem of estimating the sparse mmWave massive multiple input - multiple output (MIMO) OFDM channel from one-bit quantized measurements. Unlike previous grid-based one-bit compressive sensing approaches, we present a gridless convex method to recover sparse channel form one-bit measurements via Binary Atomic Norm Minimization (BiANM) and Reweighted Binary Atomic Norm Minimization (ReBiANM). Simulation results verify the accuracy of the binary and reweighted binary atomic norm minimization techniques.
Accurate channel estimation is critical to the performance of orthogonal frequency-division multiplexing (OFDM) underwater acoustic (UWA) communications, especially under multiple-input multiple-output (MIMO) scenarios. In this paper, we explore Vector Approximate Message Passing (VAMP) coupled with Expected Maximum (EM) to obtain channel estimation (CE) for MIMO OFDM UWA communications. The EM-VAMP-CE scheme is developed by employing a Bernoulli-Gaussian (BG) prior distribution for the channel impulse response, and hyperparameters of the BG prior distribution are learned via the EM algorithm.…
In this paper, we analyze the performance of evolutionary heuristic-aided linear detectors deployed in Multiple-Input Multiple-Output (MIMO) Orthogonal Frequency-Division Multiplexing (OFDM) systems, considering realistic operating scenarios. Hybrid linear-heuristic detectors under different initial solutions provided by linear detectors are considered, namely differential evolution (DE) and particle swarm optimization (PSO). Numerical results demonstrated the applicability of hybrid detection approach, which can improve considerably the performance of minimum mean-square error (MMSE) and matc…
In this paper, we explore a dual-functional radar-communication (DFRC) system for achieving integrated sensing and communications (ISAC). The technique of orthogonal frequency division multiplexing (OFDM) is leveraged to overcome the frequency-selective fading of the wideband multiple-input multiple-output (MIMO) systems with one multi-antenna DFRC base station (BS) and multiple single-antenna user equipment (UEs). In order to restrain the high peak-to-average power ratio (PAPR) of OFDM signals, we aim to jointly design low-PAPR DFRC MIMO-OFDM waveforms. This is done by utilizing a weighted ob…
Herein, an atomic norm based method for accurately estimating the location and orientation of a target from millimeter-wave multi-input-multi-output (MIMO) orthogonal frequency-division multiplexing (OFDM) signals is presented. A novel virtual channel matrix is introduced and an algorithm to extract localization-relevant channel parameters from its atomic norm decomposition is designed. Then, based on the extended invariance principle, a weighted least squares problem is proposed to accurately recover the location and orientation using both line-of-sight and non-line-of-sight channel informati…
The slice-wise multiplication of two tensors is required in a variety of tensor decompositions (including PARAFAC2 and PARATUCK2) and is encountered in many applications, including the analysis of multidimensional biomedical data (EEG, MEG, etc.) or multi-carrier MIMO systems. In this paper, we propose a new tensor representation that is not based on a slice-wise (matrix) description, but can be represented by a double contraction of two tensors. Such a double contraction of two tensors can be efficiently calculated via generalized unfoldings. It leads to new tensor models of the investigated …
With a significant increase in area throughput, Massive MIMO has become an enabling technology for fifth generation (5G) wireless mobile communication systems. Although prototypes were built, an openly available dataset for channel impulse responses to verify assumptions, e.g. regarding channel sparsity, is not yet available. In this paper, we introduce a novel channel sounder architecture, capable of measuring multiantenna and multi-subcarrier channel state information (CSI) at different frequency bands, antenna geometries and propagation environments. The channel sounder has been verified by…
Recently, integrating the communication and sensing functions into a common network has attracted a great amount of attention. This paper considers the advanced signal processing techniques for enabling the radar to sense the environment via the communication signals. Since the technologies of orthogonal frequency division multiplexing (OFDM) and multiple-input multiple-output (MIMO) are widely used in the legacy cellular systems, this paper proposes a two-stage signal processing approach for radar sensing in an MIMO-OFDM system, where the scattered channels caused by various targets are estim…
We propose a novel three-stage delay-Doppler-angle estimation algorithm for a MIMO-OFDM radar in the presence of inter-carrier interference (ICI). First, leveraging the observation that spatial covariance matrix is independent of target delays and Dopplers, we perform angle estimation via the MUSIC algorithm. For each estimated angle, we next formulate the radar delay-Doppler estimation as a joint carrier frequency offset (CFO) and channel estimation problem via an APES (amplitude and phase estimation) spatial filtering approach by transforming the delay-Doppler parameterized radar channel int…
Multi-input multi-output orthogonal frequency division multiplexing (MIMO OFDM) is a key technology for mobile communication systems. However, due to the issue of high peak-to-average power ratio (PAPR), the OFDM symbols may suffer from nonlinear distortions of the power amplifier (PA) at the transmitters, which degrades the channel estimation and detection performances of the receivers. To mitigate the clipping distortions at the receivers end, we leverage deep learning (DL) and devise a DL based receiver which is aided by the traditional least square (LS) channel estimation and the zero-forc…
Digital predistortion (DPD) is a method commonly used to compensate for the nonlinear effects of power amplifiers (PAs). However, the computational complexity of most DPD algorithms becomes an issue in the downlink of massive multi-user (MU) multiple-input multiple-output (MIMO) orthogonal frequency division multiplexing (OFDM), where potentially up to several hundreds of PAs in the base station (BS) require linearization. In this paper, we propose a convolutional neural network (CNN)-based DPD in the frequency domain, taking place before the precoding, where the dimensionality of the signal s…
Massive MIMO requires a large number of antennas and the same amount of power amplifiers (PAs), one per antenna. As opposed to 4G base stations, which could afford highly linear PAs, next-generation base stations will need to use inexpensive PAs, which have a limited region of linear amplification. One of the research challenges is effectively handling signals which have high peak-to-average power ratios (PAPRs), such as orthogonal frequency division multiplexing (OFDM). This paper introduces a PAPR-aware precoding scheme that exploits the excessive spatial degrees-of-freedom of large scale mu…
A novel dual-function radar communication (DFRC) system is proposed, that achieves high target resolution and high communication rate. It consists of a multiple-input multiple-output (MIMO) radar, where only a small number of antennas are active in each channel use. The probing waveforms are orthogonal frequency division multiplexing (OFDM) type. The OFDM carriers are divided into two groups, one that is used by the active antennas in a shared fashion, and another one, where each subcarrier is assigned to an active antenna in an exclusive fashion (private subcarriers). Target estimation is car…
Energy-Efficient Power Control in Single-User M-MIMO-OFDM System with PA Nonlinearity
Institute of Communications Technology Technische Universität Braunschweig（不伦瑞克工业大学通信技术研究）；Institute of Radiocommunications Poznan University of Technology（波兹南理工大学无线电通信研究所）
In this work, we consider the design of hybrid analog-digital (HAD) multi-carrier MIMO-OFDM two-way relaying systems, where the relay station is equipped with a HAD amplify-and-forward architecture and every mobile station is equipped with a fully-digital beamforming architecture. We propose a sub-optimal solution by reformulating the original non-convex problem as a constrained Tucker2 decomposition with the objective of minimizing the sum Euclidean-norm between the HAD amplification matrices and their fully-digital counterparts. For the fully-digital amplification matrix design, we use a Fro…
Herein, an atomic norm based method for accurately estimating the location and orientation of a target from millimeter-wave multi-input-multi-output (MIMO) orthogonal frequency-division multiplexing (OFDM) signals is presented. A novel virtual channel matrix is introduced and an algorithm to extract localization-relevant channel parameters from its atomic norm decomposition is designed. Then, based on the extended invariance principle, a weighted least squares problem is proposed to accurately recover the location and orientation using both line-of-sight and non-line-of-sight channel informati…
Deep learning is playing an instrumental role in the design of the next generation of communication systems. In this letter, we address the massive MIMO interconnect's bandwidth constraint relaxation using autoencoders. The autoencoder is trained to learn the received signal structure so that a low dimension latent variable is transferred as opposed to the original high dimension signal. For an efficient implementation, the approach suggests to separately deploy the autoencoder components, namely the encoder and the decoder, in massive MIMO radio head and central processing units respectively.…
Fine-grained indoor localization has attracted attention recently because of the rapidly growing demand for indoor location-based services (ILBS). Specifically, massive (large-scale) multiple-input and multiple-output (MIMO) systems have received increasing attention due to high angular resolution. This paper presents an indoor localization testbed based on a massive MIMO orthogonal frequency-division multiplexing (OFDM) system, which supports physical-layer channel measurements. Instead of exploiting channel state information (CSI) directly for localization, we focus on positioning from the p…
Movable Antenna-Enhanced MIMO-OFDM ISAC: Ambiguity Function Analysis, Waveform Design and Antenna Position Optimization
Beijing Institute of Technology（北京理工大学）；School of Information and Electronic Engineering, Beijing University of Posts and Telecommunications（北京邮电大学信息工程学院）
Virginia Tech（弗吉尼亚理工大学）；Samsung Research America（三星美国研究院）
In this paper, we investigate learning-based MIMO-OFDM symbol detection strategies focusing on a special recurrent neural network (RNN) -- reservoir computing (RC). We first introduce the Time-Frequency RC to take advantage of the structural information inherent in OFDM signals. Using the time domain RC and the time-frequency RC as the building blocks, we provide two extensions of the shallow RC to RCNet: 1) Stacking multiple time domain RCs; 2) Stacking multiple time-frequency RCs into a deep structure. The combination of RNN dynamics, the time-frequency structure of MIMO-OFDM signals, and th…
Adopting one-bit analog-to-digital convertors (ADCs) for massive multiple-input multiple-output (MIMO) implementations has great potential in reducing the hardware cost and power consumption. However, distortions caused by quantization raise great challenges. In MIMO orthogonal frequency-division modulation (OFDM) detection, coarse quantization renders the orthogonal separation among subcarriers inapplicable, forcing us to deal with a problem that has a very large problem size. In this paper we study the expectation-maximization (EM) approach for one-bit MIMO-OFDM detection. The idea is to ite…
In this letter, a novel synchronization method for MIMO-OFDM systems is proposed. The new approach has an accurate estimate of both symbol timing and large frequency offest. Simulation results show the excellent robustness of our method in double-selective channel even if the strongest multipath component arrives behind the first path.
This letter presents and analyzes orthogonal frequency-division multiplexing (OFDM)-based multi-carrier transmission for cell-free massive multi-input multi-output (CFmMIMO) over frequency-selective fading channels. Frequency-domain conjugate beamforming, pilot assignment, and user-specific resource allocation are proposed. CFmMIMO-OFDM is scalable to serve a massive number of users and is flexible to offer diverse data rates for heterogeneous applications.
Large-scale deployment of connected vehicles with cooperative sensing and maneuvering technologies increases the demand for vehicle-to-everything communication (V2X) band in 5.9 GHz. Besides the V2X spectrum, the under-utilized millimeter-wave (mmWave) bands at 24 and 77 GHz can be leveraged to supplement V2X communication and support high data rates for emerging broadband applications. For this purpose, joint radar-communication (JRC) systems have been proposed in the literature to perform both functions using the same waveform and hardware. In this work, we present a software-defined multipl…
