颗粒分布对20 L球形容器中粉尘爆炸的影响
Influence of the particle distribution on dust explosions in the 20 L sphere
AI总结:
本研究通过OpenFOAM欧拉-拉格朗日模拟和径向均匀性参数Phi,揭示了20 L球形容器中近壁颗粒浓度对粉尘爆炸安全特性的非单调影响:高近壁浓度增强爆炸强度,中等浓度则降低强度。
摘要:
标准化粉尘爆炸的安全特性对于减轻其在过程工业中的影响至关重要。20 L球形容器主要用于在实验室层面研究粉尘爆炸的安全特性,即爆炸压力(P_ex)和压力上升速率((dP/dt)_ex)。确保球形容器内粉尘分布均匀对于准确获取数据和实现标准化至关重要。然而,通过喷嘴进入的气流所产生的旋涡会使颗粒在点火前集中于壁面附近。本研究对20 L球形容器内的爆炸过程进行了模拟,以研究近壁颗粒浓度对安全特性的影响。基于欧拉-拉格朗日方法的OpenFOAM模型以石松子粉尘爆炸的实验数据为基准进行了验证。提出了一种新的径向均匀性参数Phi(0 <= Phi <= 1)来量化近壁颗粒浓度。参数Phi基于颗粒坐标的径向分量,利用幂律计算得出,其中Phi = 1表示均匀分布,Phi = 0表示所有颗粒均集中在壁面上。在点火前设置了不同的颗粒分布(Phi = 0.1, 0.2, ..., 1)。随着Phi从1开始减小,P_ex和(dP/dt)_ex先下降,但超过某一临界点后,两个参数均上升。当Phi = 0.1时,P_ex和(dP/dt)_ex均达到最高值,分别比均匀分布高1.75%和10.1%。最低值出现在Phi = 0.7时,与均匀分布相比分别降低了0.25%和5.6%。因此,高近壁浓度会增强爆炸强度,而中等浓度导致的爆炸强度低于均匀分布。
英文摘要:
It is essential to standardize the safety characteristics of dust explosions to mitigate their impact on the process industries. The 20 L sphere primarily investigates the safety characteristics, namely explosion pressure (P_ex) and the rate of pressure rise ((dP/dt)_ex), of dust explosions at the laboratory level. Ensuring uniform dust distribution inside the sphere is essential for accurate data acquisition and standardization. However, whirls created by the incoming flow through the nozzle yield particles to concentrate near the wall before ignition. This study simulated the explosion inside a 20 L sphere to investigate the impact of near-wall particle concentration on the safety characteristics. The OpenFOAM model based on the Euler-Lagrangian approach was benchmarked against experimental data of lycopodium dust explosions. A novel radial homogeneity parameter Phi (0 <= Phi <= 1) quantifies the near-wall particle concentration. The parameter Phi is calculated using a power law based on the radial component of particle coordinates, where Phi = 1 indicates a uniform distribution, and Phi = 0 represents all particles concentrating on the wall. Different particle distributions (Phi = 0.1, 0.2, ..., 1) are initiated before ignition. As Phi decreases from 1, P_ex and (dP/dt)_ex first decrease, but beyond a certain point, both parameters increase. At Phi = 0.1, both P_ex and (dP/dt)_ex reach their highest values, which are 1.75% and 10.1% higher than the uniform distribution, respectively. The lowest values arise at Phi = 0.7, with reductions of 0.25% and 5.6% compared to the uniform distribution. Thus, high near-wall concentrations enhance explosion intensity, while moderate concentrations result in lower intensity than the uniform distribution.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。