用于同时无线信息与功率传输的多音PSK调制设计
Multitone PSK Modulation Design for Simultaneous Wireless Information and Power Transfer
AI总结:
本文提出一种利用集成接收机非线性特性的N音多音PSK调制方案,通过减少纹波电压提升SWIPT系统的PCE与BER性能,经测量验证可有效满足低功耗IoT网络的数据与功率需求。
摘要:
基于射频(RF)波的远场无线功率传输应运而生,以满足作为5G及以后时代骨干的大型物联网(IoT)网络的功率需求。然而,RF通信信号同时携带信息和能量。因此,最近,同时无线信息和功率传输(SWIPT)引起了广泛关注,旨在为这些IoT设备进行无线充电。在本文中,我们提出了一种新颖的N音多音相移键控(PSK)调制方案,利用了集成接收机整流器架构的非线性特性。该调制方案的主要优势在于,减少了通过相位进行符号传输时引入的纹波电压。我们考虑了输出端可实现功率转换效率(PCE)和误码率(BER),以衡量所提出调制方案的有效性。仿真结果通过对所设计整流电路的测量得到了验证。本文还分析了符号相位范围、调制阶数和音数量的影响。未来,该传输方案可用于满足低功耗物联网传感器网络的数据和功率需求。
英文摘要:
Far-field wireless power transfer, based on radio frequency (RF) waves, came into the picture to fulfill the power need of large Internet of Things (IoT) networks, the backbone of the 5G and beyond era. However, RF communication signals carry both information as well as energy. Therefore, recently, simultaneous wireless information and power transfer (SWIPT) has attracted much attention in order to wirelessly charge these IoT devices. In this paper, we propose a novel N -tone multitone phase shift keying (PSK) modulation scheme, taking advantage of the non-linearity of integrated receiver rectifier architecture. The main advantage of the proposed modulation scheme is the reduction in ripple voltage, introduced by the symbol transmission through phases. Achievable power conversion efficiency (PCE) and bit error rate (BER) at the output are considered to measure the efficacy of the proposed modulation scheme. Simulation results are verified by the measurements over the designed rectifier circuitry. The effect of symbol phase range, modulation order, and the number of tones are analyzed. In the future, this transmission scheme can be utilized to satisfy the data and power requirements of low-power Internet of Things sensor networks.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。