恒定气体流量下浸没于液体中的孔口气泡生成的数值研究
A Computational Study of Bubble Formation from an Orifice Submerged in Liquid with Constant Gas Flow
AI总结:
本文通过OpenFOAM数值模拟研究了恒定气体流量下孔口气泡生成规律,揭示了气泡尺寸与流量、孔口尺寸、表面张力和接触角的关系,发现临界流量下的气泡配对现象、低流量下的线性规律以及临界接触角的变化趋势,并指出亚毫米孔口生成小气泡更具挑战性。
摘要:
本文采用OpenFOAM中名为interIsoFoam的流体体积法求解器,通过数值模拟研究了恒定气体流量下从浸没于液体中的孔口生成气泡的过程。计算结果表明,脱离气泡的尺寸随气体流量、孔口尺寸、表面张力和液体接触角等的增大而增大,这与大多数先前研究者的结果定性一致。对于给定的孔口尺寸和液体物性,存在一个临界气体流量,超过该流量后,脱离的气泡将通过聚并而合并,这一现象被称为气泡配对。在低气体流量下,准静态区中脱离气泡的体积与气体流量呈线性关系,这与物理机理分析一致,但此前未被先前研究者所认识。当液体充分润湿孔口壁面时,脱离气泡的尺寸似乎对接触角不敏感;但如果接触角增大到超过某一临界值,导致接触线在孔口水平外壁上移动,气泡尺寸则会显著增大。研究发现,该临界接触角的值随孔口尺寸的增大而增大,并随气体流量的增大而减小。这些发现从逻辑上表明,对于恒定气体流量下的亚毫米级孔口,通过减小孔口尺寸来生成更小气泡可能更具挑战性。
英文摘要:
The process of bubble formation from an orifice submerged in liquid with constant gas flow is studied by numerical simulations using an OpenFOAM volume-of-fluid solver named interIsoFoam. The computed results show that the detached bubble size tends to increase with the gas flow rate, orifice size, surface tension, liquid contact angle, etc. in qualitative agreement with most previous authors. For a given orifice size and liquid properties, there exists a critical gas flow rate above which detached bubbles will combine via coalescence known as bubble pairing. At low gas flow rates, the volume of detached bubbles in the quasi-static regime is shown to depend linearly on the gas flow rate, consistent with a physical mechanistic analysis but not recognized by previous authors. The detached bubble size seems insensitive to the contact angle when the liquid adequately wets the orifice wall, but can increase substantially if the contact angle is increased beyond a critical value resulting in contact line motion on the horizontal outside wall of orifice. The value of such a critical contact angle is found to increase with the orifice size and decrease with the gas flow rate. Such revelations would logically suggest that reducing orifice size for generating smaller bubbles could be more challenging for sub-millimeter orifices with constant gas flow.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。