Er$_2$Ti$_2$O$_7$高压斜锆石相中更高配位Er的实现
Realization of higher coordinated Er in high-pressure cotunnite phase of Er$_2$Ti$_2$O$_7$
AI总结:
本文通过多种实验表征和第一性原理计算,揭示了Er$_2$Ti$_2$O$_7$在约40 GPa开始向斜锆石相转变,并在卸压后保留高压相且使未转变烧绿石非晶化,同时Er配位数由八增至九。
摘要:
本文利用X射线衍射、拉曼光谱、光致发光、X射线吸收和从头计算,报道了Er$_2$Ti$_2$O$_7$立方烧绿石在压力下的结构稳定性。我们的研究确立了Er$_2$Ti$_2$O$_7$从常压立方相到高压正交(斜锆石)相的相变,该相变在约40 GPa时开始。该转变过程缓慢,即使在本研究测量的最高压力约60.0 GPa下也未完成。第一性原理计算进一步支持了这一结果,计算表明在约53 GPa以上,斜锆石相在能量上比常压相更稳定。在完全卸压后,高压斜锆石相被保留下来,而未转变的烧绿石相部分变为非晶态。此外,回收样品在Er3+离子L3边的EXAFS数据表明,阳离子的配位数从常压下的八增加到高压相中的九。结构转变机制被解释为阳离子反位缺陷的积累以及随后阳离子和阴离子在各自亚晶格中的无序化。卸压后烧绿石相的非晶化被解释为在常压条件下无法容纳压缩过程中在烧绿石晶格中形成的点缺陷。
英文摘要:
In this article we report the structural stability of Er$_2$Ti$_2$O$_7$ cubic pyrochlore with pressure using x-ray diffraction, Raman spectroscopy, photoluminescence, x-ray absorption and ab-initio calculations. Our studies establish a phase transformation in Er$_2$Ti$_2$O$_7$ from ambient cubic phase to high-pressure orthorhombic (cotunnite) phase, initiated at ~40 GPa. The transformation is sluggish and it does not complete even at the highest measured pressure in our study i.e. ~60.0 GPa. This is further supported by the first principle calculations which reveal that cotunnite phase is energetically more stable than the ambient phase above ~53 GPa. After complete release of pressure, the high-pressure cotunnite phase is retained while the fraction of untransformed pyrochlore phase becomes amorphous. Furthermore, the EXAFS data of the recovered sample at L3 edge of Er3+ ion show an increase in the coordination number of cations from eight at ambient to nine in the high-pressure phase. The mechanism of structural transformation is explained in terms of accumulation of cation antisite defects and subsequent disordering of cations and anions in their respective sublattice. The amorphization of the pyrochlore phase upon release is interpreted as the inability of accommodating the point defects at ambient conditions, which are formed in the pyrochlore lattice under compression.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。