arXivDaily arXiv每日学术速递 周一至周五更新
arXiv 2301.05882cs.ROcs.SYeess.SY
收藏

壁面攀爬机器人的设计与开发

Design and Development of Wall Climbing Robot

University of Engineering & Technology(工程技术大学)

Hafiz Muhammad Bilal

摘要:

攀爬机器人正在开发的应用范围从清洁到难以到达的建筑物的检查。攀爬机器人应该能够携带轻型有效载荷,并能够在垂直表面上攀爬,并能够应对障碍物。关于对表面的粘附,它们应该能够以不同的粘附方法在不同的表面上操作,以使用消耗最小功率的轻质机构产生强大的夹持力。考虑到这些事实,本文提出了一种四足爬壁机器人,其中使用板上的抽吸泵的吸力被用作粘附技术。一个步行步态的发展,以提供一个能力的机器人爬上墙壁。机器人的运动学和运动可以被认为是模仿攀岩中常用的四肢攀爬技术。它有四条腿,每条腿都有四个自由度(4-DOF),每条腿的末端都有专门设计的吸盘,使它能够在墙上移动,并向任何方向移动。末端执行器也可以用其他末端执行器替换,这些末端执行器设计用于不同的粘附方法,以在各种表面上攀爬。

英文摘要:

Climbing Robots are being developed for applications ranging from cleaning to the inspection of difficult to reach constructions. Climbing robots should be capable of carrying a light payload and climbing on vertical surfaces with ability to cope with obstacles. Regarding adhesion to the surface, they should be able to operate on different surfaces with different adhesion methods to produce strong gripping force using light weight mechanism consuming minimum power. Bearing these facts in mind this paper presents a 4-legged Wall Climbing Robot in which suction power using on board suction pumps is used as an adhesion technique. A Walking gait was developed to provide the robot with a capability for climbing up the wall. The robot's kinematics and motion can be considered as mimicking a technique commonly used in rock-climbing using four limbs to climb. It uses four legs, each with four-degrees-of-freedom (4-DOF) and specially designed suction cups attached to the end of each leg that enable it to manoeuvre itself up the wall and to move in any direction. The end effector can also be replaced with other end effectors designed for different adhesion methods to climb on variety of surfaces.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑