arXivDaily arXiv每日学术速递 周一至周五更新
arXiv周末暂无论文更新,休息一下吧,周末愉快~~
arXiv 2209.09330cs.CE
收藏

机翼的形状与拓扑同步优化

Simultaneous shape and topology optimization of wings

Lukas C. Høghøj, Cian Conlan-Smith, Ole Sigmund, Casper Schousboe Andreasen

AI总结:

提出一种单向耦合气动面元法与结构有限元的机翼外形-内部拓扑同步优化方法,在多工况升力和柔度约束下降阻,并在小型固定翼机翼算例中验证。

摘要:

本文提出一种同步优化飞机机翼外部形状与内部拓扑的方法,目标是在多种载荷工况下满足升力和柔度约束,同时使阻力最小化。物理场通过用于气动响应的源-偶极子面元法,以及用于结构响应的线弹性有限元进行评估,二者采用单向耦合。在每次设计迭代中,采用一种映射程序,将当前机翼形状及相应压力载荷映射到覆盖设计域的非拟合有限元网格上。研究对带加强撑杆和不带加强撑杆的小型固定翼飞机机翼进行了优化。所得机翼呈现出包含撑杆与壁-桁架组合的内部拓扑,具体取决于形状优化的设计自由度。优化后机翼的升力分布表现出的模式,与在对翼根弯矩施加约束的条件下进行机翼形状优化时所得模式相似。

英文摘要:

This paper presents a method for simultaneous optimization of the outer shape and internal topology of aircraft wings, with the objective of minimizing drag subject to lift and compliance constraints for multiple load cases. The physics are evaluated by the means of a source-doublet panel method for the aerodynamic response and linear elastic finite elements for the structural response, which are one-way coupled. At each design iteration, a mapping procedure is applied to map the current wing shape and corresponding pressure loads to the unfitted finite element mesh covering the design domain. Wings of small fixed-wing airplanes both with and without a stiffening strut are optimized. The resulting wings show internal topologies with struts and wall-truss combinations, depending on the design freedom of the shape optimization. The lift distributions of the optimized wings show patterns like the ones obtained when performing optimization of wing shapes with constraints on the bending moment at the root.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑