A series of experiments were conducted using the STM instrument, which involves a conducting tip probe to analyse sample surfaces by measurements of a tunnelling current. In this experiment, STM was used to (1) determine the lattice constant of Highly Oriented Pyrolytic Graphite (HOPG) by acquiring atomic resolution images of its surface, (2) measure the work functions of gold (Au) and HOPG samples using the STS mode and, (3) compare the variation of the Local Density of States (LDOS) of gold, graphite and Silicon (Si) samples with respect to bias voltage V. Experimental values of the lattice constant of HOPG and work functions for gold and graphite were determined as 0.27 +/- 0.2 nm, 0.7 +/- 0.1 eV and 0.5 +/- 0.1 eV respectively. The lattice constant deviated slightly from the literature value of 0.246 nm, whereas the work functions deviated significantly from the literature values of 5.40 eV for gold and 4.62 eV for graphite. The LDOS for gold was found to be the highest, followed by graphite, then silicon. These findings will be discussed.
We investigate the electronic properties of heterostructures based on ultrathin hexagonal boron nitride (h-BN) crystalline layers sandwiched between two layers of graphene as well as other conducting materials (graphite, gold). The tunnel conductance depends exponentially on the number of h-BN atomic layers, down to a monolayer thickness. Exponential behaviour of I-V characteristics for graphene/BN/graphene and graphite/BN/graphite devices is determined mainly by the changes in the density of states with bias voltage in the electrodes. Conductive atomic force microscopy scans across h-BN terra…
Highly oriented pyrolytic graphite (HOPG) is an important substrate in many technological applications and is routinely used as a standard in Scanning Tunnelling Microscopy (STM) calibration, which makes the accurate interpretation of the HOPG STM contrast of great fundamental and applicative importance. We demonstrate by STM simulations based on electronic structure obtained from first principles that the relative local orientation of the STM-tip apex with respect to the HOPG substrate has a considerable effect on the HOPG STM contrast. Importantly for experimental STM analysis of HOPG, the s…
We study the interaction between single apex atoms in a metallic contact, using the break junction geometry. By carefully 'training' our samples, we create stable junctions in which no further atomic reorganization takes place. This allows us to study the relation between the so-called jump out of contact (from contact to tunnelling regime) and jump to contact (from tunnelling to contact regime) in detail. Our data can be fully understood within a relatively simple elastic model, where the elasticity k of the electrodes is the only free parameter. We find 5 < k < 32 N/m. Furthermore, the inter…
We have developed a method for depositing graphene monolayers and bilayers with minimum lateral dimensions of 2-10 nm by the mechanical exfoliation of graphite onto the Si(100)-2x1:H surface. Room temperature, ultra-high vacuum (UHV) tunnelling spectroscopy measurements of nanometer-sized single-layer graphene reveal a size dependent energy gap ranging from 0.1-1 eV. Furthermore, the number of graphene layers can be directly determined from scanning tunnelling microscopy (STM) topographic contours. This atomistic study provides an experimental basis for probing the electronic structure of nano…
The scaling of friction with the contact size $A$ and (in)commensurabilty of nanoscopic and mesoscopic crystals on a regular substrate are investigated analytically for triangular nanocrystals on hexagonal substrates. The crystals are assumed to be stiff, but not completely rigid. Commensurate and incommensurate configurations are identified systematically. It is shown that three distinct friction branches coexist, an incommensurate one that does not scale with the contact size ($A^0$) and two commensurate ones which scale differently (with $A^{1/2}$ and $A$) and are associated with various co…
A gated probe for scanning tunnelling microscopy (STM) has been developed. The probe extends normal STM operations by means of an additional electrode fabricated next to the tunnelling tip. The extra electrode does not make contact with the sample and can be used as a gate. We report on the recipe used for fabricating the tunnelling tip and the gate electrode on a silicon nitride cantilever. We demonstrate the functioning of the scanning gate probes by performing single-electron tunnelling spectroscopy on 20-nm gold clusters for different gate voltages.
We present theoretical calculations for the absorption properties of protein-coated gold nanoparticles on graphene and graphite substrates. As the substrate is far away from nanoparticles, numerical results show that the number of protein bovine serum molecules molecules aggregating on gold surfaces can be quantitatively determined for gold nanoparticles with arbitrary size by means of the Mie theory and the absorption spectra. The presence of graphitic substrate near protein-conjugated gold nanoparticles substantially enhances the red shift of the surface plasmon resonances of the nanoparticl…
Moiré patterns on Highly Oriented Pyrolytic Graphite surfaces due to dislocated graphene layers were studied. We observed that the apparent corrugations of the moiré patterns in scanning tunnelling microscopy images change as a function of tunnel junction bias. A simple geometric investigation of the atomic structure of the graphene layers generating moiré patterns revealed that different atomic arrangements due to different twist angles can result in similar geometric moiré periods such that, only a small fraction of the observed moiré periodicities may coincide with the real atomic periodici…
Graphene grown by chemical vapour deposition is transferred on top of flat gold nanoislands and characterized by scanning tunnelling microscopy (STM) and atomic force microscopy (AFM). Graphene bubbles are formed with lateral dimensions determined by the size and shape of nanoislands. These graphene bubbles can be squeezed during STM imaging using bias voltages of less than 250 mV and tunnelling currents of 1 nA. Similarly, the graphene suspended over gold nanovoids is deflected 4 - 5 nm by the STM tip when imaging at low bias voltages (U = 30 mV). Nanoindentation measurements performed by AFM…
The ability to pattern graphene at low temperatures in a scalable manner is one of the greatest challenges facing graphene industrial adoption today. We demonstrate a simple method for low-temperature gold-catalyzed etching of graphite with predictable characteristics using ambient air at $350-375^\circ$ C. The naturally occurring water vapor in ambient air is necessary for this reaction to occur. In addition, we characterize the etch characteristics as a function of process parameters. Ar annealing is required to obtain crystallographically straight etches, and $375^\circ$ C is required to ob…
We have developed a broadband scanning tunnelling microscope capable of conventional, low frequency (<10 kHz), microscopy as well spectroscopy and shot-noise detection at 1 MHz. After calibrating our AC circuit on a gold surface, we illustrate our capability to detect shot-noise at the atomic scale and at low currents (<1 nA) by simultaneously measuring the atomically resolved differential conductance and shot-noise on the high temperature superconductor Bi$_{2}$Sr$_{2}$CaCu$_{2}$O$_{8+x}$. We further show our direct sensitivity to the temperature of the tunnelling electrons at low voltages. O…
Using a scanning tunneling microscope or mechanically controllable break junctions it has been shown that it is possible to control the formation of a wire made of single gold atoms. In these experiments an interatomic distance between atoms in the chain of ~3.6 Angstrom was reported which is not consistent with recent theoretical calculations. Here, using precise calibration procedures for both techniques, we measure length of the atomic chains. Based on the distance between the peaks observed in the chain length histogram we find the mean value of the inter-atomic distance before chain ruptu…
We demonstrate that highly-ordered two-dimensional crystals of ligand-capped gold nanoparticles display a local photo-mechanical stiffness as high as that of solids such as graphite. In out-of equilibrium electron diffraction experiments, a strong temperature jump is induced in a thin film with a femtosecond laser pulse. The initial electronic excitation transfers energy to the underlying structural degrees of freedom, with a rate generally proportional to the stiffness of the material. With femtosecond small-angle electron diffraction, we observe the temporal evolution of the diffraction feat…
We have designed and built a near-field scanning microwave microscope, which has been used to measure the local microwave response and the local density-of-states (LDOS) in the area including the boundary between the gold deposited and the non-deposited region on highly-orientated pyrolytic graphite at a frequency of about 7.3 GHz. We have succeeded in measuring the spatial variation of both the LDOS and the surface resistance. It can be observed that the surface resistance in gold deposited region with the metallic tunneling spectra is smaller than that in the non-deposited region with the U-…
The formation and rupture of atomic-sized contacts is modelled by means of molecular dynamics simulations. Such nano-contacts are realized in scanning tunnelling microscope and mechanically controlled break junction experiments. These instruments routinely measure the conductance across the nano-sized electrodes as they are brought into contact and separated, permitting conductance traces to be recorded that are plots of conductance versus the distance between the electrodes. One interesting feature of the conductance traces is that for some metals and geometric configurations a jump in the va…
The development of functional composite nanomaterials based on graphene and metal nanoparticles (NPs) is currently the subject of intense research interest. In this study we report the preparation of novel type of graphene/Sn and graphene/SnOx (1 < x < 2) hybrid nanostructures and their investigation by scanning probe methods. First, we prepare Sn NPs by evaporating 7 - 8 nm tin on highly oriented pyrolytic graphite substrates. Graphene/Sn nanostructures are obtained by transferring graphene on top of the tin NPs immediately after evaporation. We show by scanning tunnelling microscopy (STM) an…
We review the development of ultrafast electron nanocrystallography as a method for investigating structural dynamics for nanoscale materials and interfaces. Its sensitivity and resolution are demonstrated in the studies of surface melting of gold nanocrystals, nonequilibrium transformation of graphite into reversible diamond-like intermediates, and molecular scale charge dynamics, showing a versatility for not only determining the structures, but also the charge and energy redistribution at interfaces. A quantitative scheme for three-dimensional retrieval of atomic structures is demonstrated …
In this study nanoscale structure and associated energy dissipation behavior of nanoparticulates of tungsten disulphide (WS2) and nanoparticles of gold (Au) were investigated by advanced scanning probe and electron microscopy techniques. WS2 nanoparticulates were deposited on silicon substrate by van der Waals adhesion transfer-deposition mechanisms. The templates of three size variants of Au nanoparticles, close packed (4-6nm), well dispersed (120-150nm) and clusters of (120-150 nm) nanoparticles were prepared on silicon substrates. Nano-microstructure, morphology, topography and phase shift …
Room temperature conductance-elongation curves of gold atomic wires are measured using a Scanning Tunnelling Microscope Break Junction technique. Landauer's conductance plateaus are individually identified and statistically analysed. Both the probabilities to observe, and the lengths of the two last plateaus (at conductance values close to 2e2/h and 4e2/h) are studied. All results converge to show that the occurrence of these two conductance plateaus on a conductance-elongation curve are statistically independent events.
C58 fullerenes were adsorbed onto room temperature Au(111) surface by low-energy (~6 eV) cluster ion beam deposition under ultrahigh vacuum conditions. The topographic and electronic properties of the deposits were monitored by means of scanning tunnelling microscopy (STM at 4.2 K). Topographic images reveal that at low coverages fullerene cages are pinned by point dislocation defects on the herringbone reconstructed gold terraces (as well as by step edges). At intermediate coverages, pinned monomers, act as nucleation centres for the formation of oligomeric C58 chains and 2D islands. At the l…
The wavefunction of massless Dirac fermions is a two-component spinor. In graphene, a one-atom-thick film showing two-dimensional Dirac-like electronic excitations, the two-component representation reflects the amplitude of the electron wavefunction on the A and B sublattices. This unique property provides unprecedented opportunities to image the two components of massless Dirac fermions spatially. Here we report atomic resolution imaging of the two-component Dirac-Landau levels in a gapped graphene monolayer by scanning tunnelling microscopy and spectroscopy. A gap of about 20 meV, driven by …
We report room temperature scanning tunneling microscopy and spectroscopy study of bilayer graphene prepared by mechanical exfoliation on SiO$_2$/Si surface and electrically contacted with gold pads using a mechanical mask. The bulk conductivity shows contribution from regions of varying electron density indicating significant charge inhomogeneity. Large scale topographic images show ripple like structures with a roughness of $\sim$1nm while the small scale atomic resolution images show graphite-like triangular lattice. Local dI/dV-V tunnel spectra have an asymmetric V-shape with the minima lo…
