arXivDaily arXiv每日学术速递 周一至周五更新
arXiv周末暂无论文更新,休息一下吧,周末愉快~~
arXiv 2209.02263eess.SYcs.SY
收藏

用于车辆动力学控制的双体在环(Twin-in-the-Loop)方法

The Twin-in-the-Loop approach for vehicle dynamics control

Federico Dettù, Simone Formentin, Sergio Matteo Savaresi

AI总结:

针对车辆动力学控制器设计周期长、调校成本高的问题,提出将仿真器车载化的双体在环方法,仅需调校简单偏差补偿器即可完成终端校准,在主动制动场景下精度与鲁棒性均优于现有方法。

摘要:

在车辆动力学控制领域,设计合适的调节器是一个漫长且成本高昂的过程。研发的起点通常是基于简化的面向控制的模型设计标称控制器,并在功能完备的仿真器中进行测试。随后,在终端(End-of-Line, EoL)调校阶段,需要耗费大量驾驶时长为实体车辆校准控制器。\n鉴于近期的技术进步,本文提出了一种开创性思路:将仿真器部署在车载电子控制单元中运行,从而实时计算标称控制动作。研究表明,采用该方案后,在EoL阶段仅需调校一个简单的补偿器,用于修正期望输出与实测输出之间的偏差即可。\n该方法不仅复用了已有的仿真器和标称控制器,大幅简化了设计流程,而且在一项具有挑战性的主动制动控制案例研究中,其跟踪精度和鲁棒性均优于现有最优方法。

英文摘要:

In vehicle dynamics control, engineering a suitable regulator is a long and costly process. The starting point is usually the design of a nominal controller based on a simple control-oriented model and its testing on a full-fledged simulator. Then, many driving hours are required during the End-of-Line (EoL) tuning phase to calibrate the controller for the physical vehicle. Given the recent technological advances, in this paper we consider the pioneering perspective where the simulator can be run on-board in the electronic control unit, so as to calculate the nominal control action in real-time. In this way, it can be shown that, in the EoL phase, we only need to tune a simple compensator of the mismatch between the expected and the measured outputs. The resulting approach not only exploits the already available simulator and nominal controller and significantly simplifies the design process, but also outperforms the state-of-the-art in terms of tracking accuracy and robustness within a challenging active braking control case study.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑