arXivDaily arXiv每日学术速递 周一至周五更新
arXiv周末暂无论文更新,休息一下吧,周末愉快~~
arXiv 2202.10708cond-mat.mtrl-sciphysics.app-ph
收藏

通过调整Cu(In,Ga)S2中的(Zn,Mg)O组分消除电势垒:实现14%以上功率转换效率的系统方法

Electrical barriers and their elimination by tuning (Zn,Mg)O composition in Cu(In,Ga)S2: Systematic approach to achieve over 14% power conversion efficiency

Mohit Sood, Poorani Gnanasambandan, Damilola Adeleye, Sudhanshu Shukla, Noureddine Adjeroud, Renaud Leturcq, Susanne Siebentritt

摘要:

传统的CdS缓冲层在无硒Cu(In,Ga)S2太阳能电池中由于在Cu(In,Ga)S2/CdS界面处的负导带偏移而导致开路电压降低。减少这种损失需要用替代缓冲层代替CdS。然而,替代缓冲层可能会在器件中引入电势垒,这是由于在其他界面处(例如缓冲层/ZnO i层之间)的不利能带对准。本研究的目的是减少界面复合和消除电势垒的Cu(In,Ga)S2太阳能电池使用的Zn 1-xMgxO和Al掺杂的Zn 1-xMgxO缓冲和i层的组合,分别使用原子层沉积和磁控溅射沉积。用这些层制备的器件的特征在于通过电流-电压和光致发光测量。数值模拟进行理解的电势垒上的器件特性的影响。确定了Zn 1 xMgxOx = 0.27的最佳组合物,用于与带隙为~1.6 eV的Cu(In,Ga)S2进行合适的导带对准,抑制界面复合并避免势垒。优化的缓冲剂组合物与合适的i层一起导致具有14%效率和943 mV开路电压的器件。用ZnO和Al:(Zn,Mg)O制备的器件的光电测量的比较表明,对于高效率器件,用Al:(Zn,Mg)O i层代替ZnO i层是必要的。

英文摘要:

Traditional CdS buffer layer in selenium-free Cu(In,Ga)S2 solar cells leads to reduced open-circuit voltage because of a negative conduction band offset at the Cu(In,Ga)S2/CdS interface. Reducing this loss necessitates the substitution of CdS by an alternative buffer layer. However, the substitute buffer layer may introduce electrical barriers in the device due to unfavorable band alignment at the other interfaces such as between buffer/ZnO i-layer. This study aims to reduce interface recombinations and eliminate electrical barriers in Cu(In,Ga)S2 solar cells using a combination of Zn1-xMgxO and Al-doped Zn1-xMgxO buffer and i-layer combination deposited using atomic layer deposition and magnetron sputtering, respectively. The devices prepared with these layers are characterized by current-voltage and photoluminescence measurements. Numerical simulations are performed to comprehend the influence of electrical barriers on the device characteristics. An optimal composition of Zn1 xMgxO x = 0.27 is identified for a suitable conduction band alignment with Cu(In,Ga)S2 with a bandgap of ~1.6 eV, suppressing interface recombination and avoiding barriers. Optimized buffer composition together with a suitable i-layer led to a device with 14 % efficiency and an open-circuit voltage of 943 mV. A comparison of optoelectronic measurements for devices prepared with ZnO and Al:(Zn,Mg)O shows the necessity to replace the ZnO i-layer with Al:(Zn,Mg)O i-layer for a high-efficiency device.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑