This paper investigates the initiation of a deflagration in a premixed boundary-layer stream by continuous heat deposition from a line energy source placed perpendicular to the flow on the wall surface, a planar flow configuration relevant for small-scale combustion applications, including portable rotary engines. Ignition is investigated in the constant density approximation with a one-step irreversible reaction with large activation energy adopted for the chemistry description. The ratio of the characteristic strain time, given by the inverse of the wall velocity gradient, to the characteristic deflagration residence time defines the relevant controlling Damköhler number $D$. The time-dependent evolution following the activation of the heat source is obtained by numerical integration of the energy and fuel conservation equations. For sufficiently small values of $D$, the solution is seen to evolve towards a steady flow in which the chemical reaction remains confined to a finite near-source reactive kernel. This becomes increasingly slender for increasing values of $D$, corresponding to smaller near-wall velocities, until a critical value $D_{c1}$ is reached at which the confined kernel is replaced by a steady anchored deflagration, assisted by the source heating rate, which develops indefinitely downstream. As the boundary-layer velocity gradient is further decreased, a second critical Damköhler number $D_{c2}>D_{c1}$ is reached at which the energy deposition results in a flashback deflagration propagating upstream against the incoming flow along the base of the boundary layer. The computations are extended to investigate the dependence of $D_{c1}$ and $D_{c2}$ on the fuel diffusivity as well as the additional dependence of $D_{c1}$ on the source heating rate, thereby delineating the boundaries that define the relevant regime diagram for these combustion systems.
Experimental validation of a three-dimensional heat transfer model within the scala tympani with application to magnetic cochlear implant surgery
磁引导人工耳蜗植入是一种很有前途的技术,以减少手术过程中的物理创伤的风险。在该方法中,使用磁场在鼓阶内引导附接到植入电极阵列的尖端的磁体。手术后,必须通过局部加热将磁体从植入电极阵列上拆下,并从鼓阶上移除,这可能会导致热创伤。目的:这项工作的目的是通过实验验证鼓阶的三维(3D)传热模型,该模型将能够准确预测最大安全输入功率,以避免在将磁体从植入电极阵列分离时发生局部过热。研究方法:实验是使用严格的尺度分析设计的,并通过测量3D打印的鼓阶体模中的瞬态温度来进行,该体模在其热环境中发生突然变化,并通过小热源进行局部加热。结果:温度的实测值与预测值吻合较好,误差小于6 $\%$。结论:最后应用经验证的鼓阶的3D热传递模型来评估最大安全输入功率,以避免在分离磁体时局部过热。对于除插入开口外的所有边界都是绝热的最保守情况,释放1 mm $^3$石蜡附着在植入电极阵列上的磁体所需的功率约为预测最大安全输入功率的一半。意义:这项工作将使热安全的磁性人工耳蜗植入手术程序的设计。