6G operators may use millimeter wave (mmWave) and sub-terahertz (sub-THz) bands to meet the ever-increasing demand for wireless access. Sub-THz communication comes with many existing challenges of mmWave communication and adds new challenges associated with the wider bandwidths, more antennas, and harsher propagations. Notably, the frequency- and spatial-wideband (dual-wideband) effects are significant at sub-THz. This paper presents a compressed training framework to estimate the time-varying sub-THz MIMO-OFDM channels. A set of frequency-dependent array response matrices are constructed, enabling channel recovery from multiple observations across subcarriers via multiple measurement vectors (MMV). Using the temporal correlation, MMV least squares (LS) is designed to estimate the channel based on the previous beam support, and MMV compressed sensing (CS) is applied to the residual signal. We refer to this as the MMV-LS-CS framework. Two-stage (TS) and MMV FISTA-based (M-FISTA) algorithms are proposed for the MMV-LS-CS framework. Leveraging the spreading loss structure, a channel refinement algorithm is proposed to estimate the path coefficients and time delays of the dominant paths. To reduce the computational complexity and enhance the beam resolution, a sequential search method using hierarchical codebooks is developed. Numerical results demonstrate the improved channel estimation accuracy of MMV-LS-CS over state-of-the-art techniques.
Spatial wideband effects are known to affect channel estimation and localization performance in millimeter wave (mmWave) massive multiple-input multiple-output (MIMO) systems. Based on perturbation analysis, we show that the spatial wideband effect is in fact more pronounced than previously thought and significantly degrades performance, even at moderate bandwidths, if it is not properly considered in the algorithm design. We propose a novel channel estimation method based on multidimensional ESPRIT per subcarrier, combined with unsupervised learning for pairing across subcarriers, which shows…
Beamspace multi-input multi-output (MIMO) relying on lens antenna arrays can significantly reduce the number of radio-frequency chains in millimeter-wave (mmWave) communication systems through beam selection. However, the beamforming gain is actually frequency-dependent in wideband mmWave MIMO systems. This phenomenon is called beam squint, which will deteriorate the system's performance when traditional beam selection methods are used. To solve this problem, we propose a wideband beam selection method for mmWave MIMO systems relying on lens antenna arrays. Firstly, we select one beam with the…
Reconfigurable Intelligent Surfaces (RIS) are passive or semi-passive heterogeneous metasurfaces and consist of many tunable elements. RIS is gaining momentum as a promising new technology to enable transforming the propagation environment into controllable parameters. In this paper, we investigate the co-design of per-subcarrier power allocation matrices and multielement RIS phase shifts in downlink wideband MIMO transmission using 28 GHz frequency bands. Our contributions in improving RIS-aided links include (1) enhanced system modeling with pathloss and blockage modeling, and uniform rectan…
A new low-profile planar Eleven antenna is designed for optimal MIMO performance as a wideband MIMO antenna for micro base-stations in future wireless communication systems. The design objective has been to optimize both the reflection coefficient at the input port of the antenna and the 1-bitstream and 2-bitstream MIMO efficiency of the antenna at the same time, in both the Rich Isotropic MultiPath (RIMP) and Random Line-of-Sight (Random-LOS) environments. The planar Eleven antenna can be operated in 2-, 4-, and 8-port modes with slight modifications. The optimization is performed using genet…
When using ultra-wideband (UWB) signaling on massive multiple-input multiple-output (mMIMO) systems, the electromagnetic wave at each array element incurs an extra propagation delay comparable to (or larger than) the symbol duration, producing a shift in beam direction known as beam squint. The beam squinting problem degrades the array gain and reduces the system capacity. This letter proposes a novel transceiver design based on lens antenna subarray (LAS) and analog subband filters to compensate for the beam squinting effect. In particular, the proposed design aims to divide the UWB signal in…
In this paper, we present a three-dimensional (3D) non-wide-sense stationary (non-WSS) wideband geometry-based channel model for vehicle-to-vehicle (V2V) communication environments. We introduce a two-cylinder model to describe moving vehicles as well as multiple confocal semi-ellipsoid models to depict stationary roadside scenarios. The received signal is constructed as a sum of the line-of-sight (LoS), single-, and double-bounced rays with different energies. Accordingly, the proposed channel model is sufficient for depicting a wide variety of V2V environments, such as macro-, micro-, and pi…
In the area of near-field millimeter-wave imaging, the generalized sparse array synthesis (SAS) method is in great demand. The traditional methods usually employ the greedy algorithms, which may have the convergence problem. This paper proposes a convex optimization model for the multiple-input multiple-output (MIMO) array design based on the compressive sensing (CS) approach. We generate a block shaped reference pattern, to be used as an optimizing target. The pattern occupies the entire imaging area of interest in order to involve the effect of each pixel into the optimization model. In MIMO…
This paper examines the performance of a 2x2 Line of Sight (LoS) Multiple Input Multiple Output (MIMO) channel at three terahertz frequencies-340 GHz, 410 Ghz, and 460 GHz. While theoretical models predict very high channel capacities, we observe lower capacity which is explained by asymmetric transmit-to-receive signal strengths as well as due to signal attenuation over longer distances. Overall, however, we note that at 460 Ghz, channel capacity of higher than 12 bps/hz is possible even at sub-optimal inter-antenna spacings (for different distances). An important observation is also that we …
A major source of difficulty when operating with large arrays at mmWave frequencies is to estimate the wideband channel, since the use of hybrid architectures acts as a compression stage for the received signal. Moreover, the channel has to be tracked and the antenna arrays regularly reconfigured to obtain appropriate beamforming gains when a mobile setting is considered. In this paper, we focus on the problem of channel tracking for frequency-selective mmWave channels, and propose two novel channel tracking algorithms that leverage prior statistical information on the angles-of-arrival and an…
Intelligent reflecting surface (IRS) is envisioned as a revolutionary technology for future wireless communication systems since it can intelligently change radio environment and integrate it into wireless communication optimization. However, most existing works adopted an ideal IRS reflection model, which is impractical and can cause significant performance degradation in realistic wideband systems. To address this issue, we first study the dual phase- and amplitude-squint effect of reflected signals and present a simplified practical IRS reflection model for wideband signals. Then, an IRS en…
In this paper, in order to tackle major challenges of spectrum exploration \& allocation in Cognitive Radio (CR) networks, we apply the general framework of Decision Fusion (DF) to wideband collaborative spectrum sensing based on Orthogonal Frequency Division Multiplexing (OFDM) reporting. At the transmitter side, we employ OFDM without Cyclic Prefix (CP) in order to improve overall bandwidth efficiency of the reporting phase in networks with high user density. On the other hand, at the receiver side (of the reporting channel) we device the Time-Reversal Widely Linear (TR-WL), Time-Reversal Ma…
In this letter, we investigate time-domain channel estimation for wideband millimeter wave (mmWave) MIMO OFDM system. By transmitting frequency-domain pilot symbols as well as different beamforming vectors, we observe that the time-domain mmWave MIMO channels exhibit channel delay sparsity and especially block sparsity among different spatial directions. Then we propose a time-domain channel estimation exploiting block sparsity (TDCEBS) scheme, which always aims at finding the best nonzero block achieving the largest projection of the residue at each iterations. In particular, we evaluate the …
Extremely large-scale multiple-input-multiple-output (XL-MIMO) at millimeter-wave (mmWave) and terahertz (THz) bands plays an important role in supporting extreme high beamforming gain as well as ultra-wideband spectrum resources. Unfortunately, accurate wideband XL-MIMO channel estimation suffers from the new challenge called as the near-field beam split effect. Prior works either neglect the accurate near-field channel model or fail to exploit the beam split effect, resulting in poor channel estimation accuracy for wideband XL-MIMO. To tackle this problem, this paper proposes a bilinear patt…
We propose novel hybrid beamforming schemes for the terahertz (THz) wireless system where a multi-antenna base station (BS) communicates with a multi-antenna user over frequency selective fading. Here, we assume that the BS employs sub-connected hybrid beamforming and multi-carrier modulation to deliver ultra high data rate. We consider a three-dimensional wideband THz channel by incorporating the joint effect of molecular absorption, high sparsity, and multi-path fading, and consider the carrier frequency offset in multi-carrier systems. With this model, we first propose a two-stage wideband …
Terahertz (THz)-band communications are currently being celebrated as a key technology that could fulfill the increasing demands for wireless data traffic in the upcoming sixth-generation (6G) of wireless communications. Many challenges, such as high propagation losses and power limitations, which result in short communication distances, have yet to be addressed for this technology to be realized. Ultra-massive multiple-input, multiple-output (UM-MIMO) antenna systems have emerged as practical means for combatting this distance problem, thereby increasing system capacity. Towards that end, gra…
Photonics-assisted analog wideband self-interference cancellation for in-band full-duplex MIMO systems with adaptive digital amplitude and delay pre-matching
Millimeter-wave (mmW)/Terahertz (THz) wideband communication employing a large-scale antenna array is a promising technique of the sixth-generation (6G) wireless network for realizing massive machine-type communications (mMTC). To reduce the access latency and the signaling overhead, we design a grant-free random access scheme based on joint active device detection and channel estimation (JADCE) for mmW/THz wideband massive access. In particular, by exploiting the simultaneously sparse and low-rank structure of mmW/THz channels with spreads in the delay-angular domain, we propose two multi-ran…
Distributed phased arrays based multiple-input multiple-output (DPA-MIMO) is a recently proposed highly reconfigurable architecture enabling both spatial multiplexing and beamforming in millimeter-wave (mmWave) systems. In this work, we focus on coping with the hybrid precoding for the wideband DPA-MIMO system with orthogonal frequency division multiplexing (OFDM) modulation. More specifically, we propose an alternating direction method of multipliers (ADMM) enabled hybrid precoding approach based on an alternating optimization framework, abbreviated to ADMM-AltMin, for such cooperative array-…
In this article, we investigate channel estimation for wideband millimeter-wave (mmWave) massive multiple-input multiple-output (MIMO) under hybrid architecture with lowprecision analog-to-digital converters (ADCs). To design channel estimation for the hybrid structure, both analog processing components and frequency-selective digital combiners need to be optimized. The proposed channel estimator follows the typical linear-minimum-mean-square-error (LMMSE) structure and applies for an arbitrary channel model. Moreover, for sparsity channels as in mmWave, the proposed estimator performs more ef…
In this paper, we propose a wideband Full Duplex (FD) Multiple-Input Multiple-Output (MIMO) communication system comprising of an FD MIMO node simultaneously communicating with two multi-antenna UpLink (UL) and DownLink (DL) nodes utilizing the same time and frequency resources. To suppress the strong Self-Interference (SI) signal due to simultaneous transmission and reception in FD MIMO systems, we propose a joint design of Analog and Digital (A/D) cancellation as well as transmit and receive beamforming capitalizing on baseband Orthogonal Frequency-Division Multiplexing (OFDM) signal modelin…
Millimeter-wave (30-300 GHz) and Terahertz-band communications (0.3-10 THz) are envisioned as key wireless technologies to satisfy the demand for Terabit-per-second (Tbps) links in the 5G and beyond eras. The very large available bandwidth in this ultra-broadband frequency range comes at the cost of a very high propagation loss, which combined with the low power of mm-wave and THz-band transceivers limits the communication distance and data-rates. In this paper, the concept of intelligent communication environments enabled by Ultra-Massive MIMO platforms is proposed to increase the communicati…
In this paper, a channel estimator for wideband millimeter wave (mmWave) massive multiple-input multiple-output (MIMO) systems with hybrid architectures and low-resolution analog-to-digital converters (ADCs) is proposed. To account for the propagation delay across the antenna array, which cannot be neglected in wideband mmWave massive MIMO systems, the discrete time channel that models the spatial wideband effect is developed. Also, the training signal design that addresses inter-frame, inter-user, and inter-symbol interferences is investigated when the spatial wideband effect is not negligibl…
Millimeter-wave (mmWave) and Terahertz (THz)-band communications exploit the abundant bandwidth to fulfill the increasing data rate demands of 6G wireless communications. To compensate for the high propagation loss with reduced hardware costs, ultra-massive multiple-input multiple-output (UM-MIMO) with a hybrid beamforming structure is a promising technology in the mmWave and THz bands. However, channel estimation (CE) is challenging for hybrid UM-MIMO systems, which requires recovering the high-dimensional channels from severely few channel observations. In this paper, a Pruned Approximate Me…
Terahertz (THz) band communication has been widely studied to meet the future demand for ultra-high capacity. In addition, multi-input multi-output (MIMO) technique and non-orthogonal multiple access (NOMA) technique with multi-antenna also enable the network to carry more users and provide multiplexing gain. In this paper, we study the maximization of energy efficiency (EE) problem in THz-NOMA-MIMO systems for the first time. And the original optimization problem is divided into user clustering, hybrid precoding and power optimization. Based on channel correlation characteristics, a fast conv…
In this paper, we propose an intelligent analog beam selection strategy in a terahertz (THz) band beamspace multiple-input multiple-output (MIMO) system. First inspired by transfer learning, we fine-tune the pre-trained off-the-shelf GoogleNet classifier, to learn analog beam selection as a multi-class mapping problem. Simulation results show 83% accuracy for the analog beam selection, which subsequently results in 12% spectral efficiency (SE) gain, upon the existing counterparts. Towards a more accurate classifier, we replace the conventional rectified linear unit (ReLU) activation function o…
Numerous linear and non-linear data-detection and precoding algorithms for wideband massive multi-user (MU) multiple-input multiple-output (MIMO) wireless systems that rely on orthogonal frequency-division multiplexing (OFDM) or single-carrier frequency-division multiple access (SC-FDMA) require the computation of the Gram matrix for each active subcarrier. Computing the Gram matrix for each active subcarrier, however, results in excessively high computational complexity. In this paper, we propose novel, approximate algorithms that significantly reduce the complexity of Gram-matrix computation…
