Observations of reconnection jets in the solar corona are emerging as a possible diagnostic to study highly elusive coronal heating. Such nanojets can be observed in coronal loops and they have been linked to nanoflares. However, while models successfully describe the bilateral post-reconnection magnetic slingshot effect that leads to the jets, observations reveal that nanojets are unidirectional, or highly asymmetric, with only the jet travelling inward with respect to the coronal loop's curvature being clearly observed. The aim of this work is to address the role of the curvature of the coronal loop in asymmetric reconnection jets. In order to do so, we first use a simplified analytical model where we estimate the post-reconnection tension forces based on the local intersection angle between the pre-reconnection magnetic field lines and on their post-reconnection retracting length towards new equilibria. Second, we use a simplified numerical magnetohydrodynamic (MHD) model to study how two opposite propagating jets evolve in curved magnetic field lines. Our analytical model demonstrates that in the post-reconnection reorganised magnetic field, the inward directed magnetic tension is inherently stronger (up to 3 orders of magnitude) than the outward directed one and that, with a large enough retracting length, a regime exists where the outward directed tension disappears, leading to no outward jet at large, observable scales. Our MHD numerical model provides support for these results proving also that in the following time evolution the inward jets are consistently more energetic. The degree of asymmetry is also found to increase for small-angle reconnection and for more localised reconnection regions. This work shows that the curvature of the coronal loops plays a role in the asymmetry of the reconnection jets and inward directed jets are more likely to occur and more energetic.
3D MHD simulations of coronal loops heated via magnetic braiding II. Automatic detection of reconnection outflows and statistical analysis of their properties
Harvard–Smithsonian Center for Astrophysics(哈佛-史密森天体物理中心);Lockheed Martin Solar and Astrophysics Laboratory(洛克希德·马丁太阳与天体物理实验室);Rosseland Centre for Solar Physics, University of Oslo(奥斯陆大学罗斯兰太阳物理学中心);Institute of Theoretical Astrophysics, University of Oslo(奥斯陆大学理论天体物理研究所);SETI Institute(搜寻地外文明研究所)
Three-dimensional Reconstruction and Propagation of an Asymmetric Flux-rope Coronal Mass Ejection
Solar-Terrestrial Centre of Excellence - SIDC, Royal Observatory of Belgium(太阳-地球卓越中心——比利时皇家天文台空间天气数据中心);Skobeltsyn Institute of Nuclear Physics, Moscow State University(莫斯科国立大学斯科别利钦核物理研究所)
Investigating Possible Stellar Coronal Mass Ejections in M-type Dwarfs Using the CARMENES DR1 Spectra
Yunnan Observatories, Chinese Academy of Sciences(中国科学院云南天文台);Key Laboratory for the Structure and Evolution of Celestial Objects, Chinese Academy of Sciences(中国科学院天体结构与演化重点实验室);International Centre of Supernovae, Yunnan Key Laboratory(云南省超新星国际研究中心);School of Astronomy and Space Science, University of Chinese Academy of Sciences(中国科学院大学天文与空间科学学院)
Study of Failed CME Core Associated with Asymmetric Filament Eruption
我们介绍了2012年6月17-18日20:00-05:00 UT期间的非对称暗条喷发、相关CME和日冕下降流的多波长观测结果。我们使用SDO/AIA,STEREO-B/SECCHI的观测来了解暗条爆发的情况和它的运动学。LASCO C2观测资料被用来研究日冕物质抛射的运动学和相关的下行流。SDO/AIA临边观测表明,暗条表现出鞭状的不对称喷发。STEREO/EUVI盘观测揭示了暗条东南部下方的两条带状耀斑,这很可能是暗条爆发后日冕磁场重联过程造成的。在LASCO C2日冕仪上观测到的鞭状暗条爆发后,前缘和核心分别以$\approx$ 540 km s $^{-1}$和$\approx$ 126 km s $^{-1}$的平均速率传播。由爆发流绳形成的CME核显示出外冕下流,其平均速率为$\approx$ 56 km s $^{-1}$,最高达$\approx$ 4.33 $R_{\sun}$。最初,核心以$\approx$ 48 m s $^{-2}$减速。等离子体首先逐渐减速到$\approx$ 4.33 $ R_{\sun}$的高度,然后开始向下加速。我们提出了一个自洽的磁通量绳模型来描述CME核心的磁结构,该核心是由喷发的暗条在到达临界高度时失去了先前的稳定平衡。在合理的参数和固有的物理条件下,模型描述了日冕中磁绳的非径向上升运动,在一定高度停止,然后下降,与观测结果符合较好…
The Equilibrium of Coronal Loops Near Separatrices
我们提出了一个高度不对称的封闭的日冕环与近奇异的膨胀因子的场对齐的流体动力学和辐射代码(HYDRAD)的数值模型。选择这个回路来模拟一个日冕磁通量管,它靠近零点通过,就像在日冕喷流或伪流光的扇形表面下的最后一组闭合回路一样。这个环在日冕零附近有一个非常大的横截面。日冕加热被认为是均匀和稳定的。虹吸流在4小时的模拟时间内建立,从较小面积的足点流动到较大面积的足点,随着等离子体接近零区域,高初始速度迅速下降。从观测上看,这将转化为从扎根于局部少数极性的足点开始的10 km s $^{-1}$量级的强上升流,以及从几km s $^{-1}$量级的扇面足点开始的弱下降流,以及零区附近的近静止等离子体。我们提出了两个加热速率的模型结果。此外,我们分析了类似的Hinode EIS观测的零点拓扑结构,这表明相关的多普勒频移在等离子体中,以及与模拟结果在两个方向和幅度的整体速度。我们讨论的影响,我们的研究结果确定观测的拓扑结构的日冕磁场。
Sigmoid Formation Through Slippage of A Single J-shaped Coronal Loop
一个众所周知的即将到来的太阳爆发的前兆是在活动区(AR)出现一个热的S形环,也称为S形环。传统上,这种S形环的形成被设想为通过两个相反取向的J形环的磁重联来实现。然而,重联的细节是难以捉摸的,由于微弱的发射和微妙的演化在喷发前阶段。在本文中,我们研究了一个单一的J形环如何转变为S形的一个通过滑动的一个脚点在NOAA AR 11719在2013年4月11日。在约16 min的时间间隔内,J形环以爆发式的方式滑过强电流密度的低电晕区,在滑移足点处达到超过1000 km s $^{-1}$的峰值视速度。非线性无力场模拟结果表明,电流密度的增加表明日冕等离子体的“非理想性”在局部变得重要,这可能有助于磁重联。经历滑动运动的环段被加热;同时,在固定的足点上方,由于环的延长和加热的组合效应,日冕发射变暗,后者表现为变暗斜率和发射测量的时间变化。这些特征共同支持通过单个J形环的滑动重连形成S形的不对称场景,这与涉及双J形环系统的标准系绳切割场景不同。
Chromospheric and Transition Region Responses of activities at the base of Coronal Plumes
Inter University Centre for Astronomy and Astrophysics(大学天文与天体物理中心);SETI Institute(SETI研究所);Lockheed Martin Solar and Astrophysics Laboratory(洛马太阳与天体物理实验室)
Thermomagnetic Ettingshausen-Nernst effect in tachocline, magnetic reconnection phenomenon in lower layers, axion mechanism of solar luminosity variations, coronal heating problem solution and mechanism of ADM variations around BH
Direct Observations of Plasma Upflows and Condensation in a Catastrophically Cooling Solar Transition Region Loop
最小的观测证据存在的快速过渡区(TR)的冷环的存在下,上升流。这种现象的观测挑战了标准太阳大气加热模型的概念,以及它们对明亮TR发射的描述。使用{\it Hinode}上的{\it EUV成像光谱仪}(EIS),我们在冷却环路($\log T$\,$\le$\,6.0)的足点位置处观察到多个TR温度(5.8\,$\le$\,$\log T$ \,$\le$ 6.0)上的快速上升流($v_λ$\,$\le$ \,$-$ 10 km s $^{-1}$)。在冷回路通电之前,在足点位置观察到$+$\,5 km s $^{-1}$和$-$\,60 km s $^{-1}$的不对称流动。这些流动速度和模式与从{ \it Solar Dynamics Observatory}(SDO){ \it Helioseismic Magnetic Imager}(HMI)的视线磁象图得出的磁通量抵消(仅在上升流的位置)和日冕高度30%的质量通量同时发生。冷却回路的非平衡结构导致灾难性的冷却事件,随后的等离子体蒸发指示TR为加热部位。从磁通量的演变,我们得出结论,磁重联之间的足点和背景场是负责观察到的快速TR等离子体上升流。