非对称臂使热电子干涉仪的可见度最大化
Asymmetric arms maximise visibility in hot-electron interferometers
摘要:
从理论上考虑了由量子霍尔边缘通道和量子点接触构成的电子马赫-曾德尔干涉仪,该干涉仪由动态量子点源提供单电子。通过考虑边缘通道引导中心的能量依赖性,我们给出了在这种设置中的相位平均的帐户,这对于由这种类型的电子源注入的短的高能量波包是特别相关的。我们提出的能量依赖的电子到达时间分布的解析和数值结果,也给出了与量子点接触的延迟时间及其对干涉图案的影响的分析。一个关键的发现是,与预期相反,最大的可见度要求干涉仪臂的长度不同,典型参数的偏移量高达一微米。通过设计在其几何结构中包含这种不对称性的干涉仪,可以克服相位平均效应,使得可见度仅受其他非相干机制的限制。
英文摘要:
We consider theoretically an electronic Mach-Zehnder interferometer constructed from quantum Hall edge channels and quantum point contacts, fed with single electrons from a dynamic quantum dot source. By considering the energy dependence of the edge-channel guide centres, we give an account of the phase averaging in this set up that is particularly relevant for the short, high-energy wavepackets injected by this type of electron source. We present both analytic and numerical results for the energy-dependent arrival time distributions of the electrons and also give an analysis of the delay times associated with the quantum point contacts and their effects on the interference patterns. A key finding is that, contrary to expectation, maximum visibility requires the interferometer arms to be different in length, with an offset of up to a micron for typical parameters. By designing interferometers that incorporate this asymmetry in their geometry, phase-averaging effects can be overcome such that visibility is only limited by other incoherent mechanisms.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。