We study heating of motional modes of a single ion and of extended ion crystals trapped in a linear radio frequency (rf) Paul trap with a precision of $Δ\dot{\bar{n}} \approx 0.2 $ phonons s$^{-1}$. Single-ion axial and radial heating rates are consistent and electric field noise has been stable over the course of four years. At a secular frequency of $ω_\mathrm{sec}=2π\times620$ kHz, we measure $\dot{\bar{n}} = 0.56(6)$ phonons s$^{-1}$ per ion for the center-of-mass (com) mode of linear chains of up to eleven ions and observe no significant heating of the out-of-phase (oop) modes. By displacing the ions away from the nodal line, inducing excess micromotion, rf noise heats the com mode quadratically as a function of radial displacement $r$ by $\dot{\bar{n}}(r)/ r^2 = 0.89(4)$ phonons s$^{-1}$ $μ$m$^{-2}$ per ion, while the oop modes are protected from rf-noise induced heating in linear chains. By changing the quality factor of the resonant rf circuit from $Q=542$ to $Q=204$, we observe an increase of rf noise by a factor of up to 3. We show that the rf-noise induced heating of motional modes of extended crystals also depends on the symmetry of the crystal and of the mode itself. As an example, we consider several 2D and 3D crystal configurations. Heating rates of up to 500 phonons s$^{-1}$ are observed for individual modes, giving rise to a total kinetic energy increase and thus a fractional time dilation shift of up to $-0.3\times 10^{-18}$ s$^{-1}$ of the total system. In addition, we detail on how the excitation probability of the individual ions is reduced and decoherence is increased due to the Debye-Waller effect.
We present measurements of the motional heating rate of a trapped ion at different trap frequencies and temperatures between $\sim$0.6 and 1.5 MHz and $\sim$4 and 295 K. Additionally, we examine the possible effect of adsorbed surface contaminants with boiling points below $\sim$105$^{\circ}$C by measuring the ion heating rate before and after locally baking our ion trap chip under ultrahigh vacuum conditions. We compare the heating rates presented here to those calculated from available electric-field noise models. We can tightly constrain a subset of these models based on their expected freq…
We have measured motional heating rates of trapped atomic ions, a factor that can influence multi-ion quantum logic gate fidelities. Two simplified techniques were developed for this purpose: one relies on Raman sideband detection implemented with a single laser source, while the second is even simpler and is based on time-resolved fluorescence detection during Doppler recooling. We applied these methods to determine heating rates in a microfrabricated surface-electrode trap made of gold on fused quartz, which traps ions 40 microns above its surface. Heating rates obtained from the two techniq…
We present measurements of trapped-ion motional-state heating rates in niobium and gold surface-electrode ion traps over a range of trap-electrode temperatures from approximately 4 K to room temperature (295 K) in a single apparatus. Using the sideband-ratio technique after resolved-sideband cooling of single ions to the motional ground state, we find low-temperature heating rates more than two orders of magnitude below the room-temperature values and approximately equal to the lowest measured heating rates in similarly-sized cryogenic traps. We find similar behavior in the two very different …
Microfabricated Paul ion traps show tremendous promise for large-scale quantum information processing. However, motional heating of ions can have a detrimental effect on the fidelity of quantum logic operations in miniaturized, scalable designs. In many experiments, contributions to ion heating due to technical voltage noise present on the static (DC) and radio frequency (RF) electrodes can be overlooked. We present a reliable method for determining the extent to which motional heating is dominated by residual voltage noise on the DC or RF electrodes. Also, we demonstrate that stray DC electri…
Electric field noise is a major source of motional heating in trapped ion quantum computation. While the influence of trap electrode geometries on electric field noise has been studied in patch potential and surface adsorbate models, only smooth surfaces are accounted for by current theory. The effects of roughness, a ubiquitous feature of surface electrodes, are poorly understood. We investigate its impact on electric field noise by deriving a rough-surface Green's function and evaluating its effects on adsorbate-surface binding energies. At cryogenic temperatures, heating rate contributions …
The problem of high-speed transport for cold atoms with minimal heating has received considerable attention in theory and experiment. Much theoretical work has focused on solutions of general problems, often assuming a harmonic trapping potential or a 1D geometry. However in the case of optical conveyor belts these assumptions are not always valid. Here we present experimental and numerical studies of the effects of various motional parameters on heating and retention of atoms transported in an optical conveyor. Our numerical model is specialized to the geometry of a moving optical lattice and…
We report on measurements of photon induced heating of silica nanospheres levitated in vacuum by a thermal light source formed by a superluminescent diode. Heating of the nanospheres motion along the three trap axes was measured as a function of gas pressure and for two particle sizes. Heating rates were also compared with the much lower reheating of the same sphere when levitated by a laser. We find the measured trap heating rates are dominated by the much larger heating rates expected from the recoil of thermal photons.
Electric noise from metallic surfaces is a major obstacle towards quantum applications with trapped ions due to motional heating of the ions. Here, we discuss how the same noise source can also lead to pure dephasing of motional quantum states. The mechanism is particularly relevant at small ion-surface distances, thus imposing a new constraint on trap miniaturization. By means of a free induction decay experiment, we measure the dephasing time of the motion of a single ion trapped 50~$μ$m above a Cu-Al surface. From the dephasing times we extract the integrated noise below the secular frequen…
We employ spin-dependent optical dipole forces to characterize the transverse center-of-mass (COM) motional mode of a two-dimensional Wigner crystal of hundreds of $^9$Be$^+$. By comparing the measured spin dephasing produced by the spin-dependent force with the predictions of a semiclassical dephasing model, we obtain absolute mode temperatures in excellent agreement with both the Doppler laser cooling limit and measurements obtained from a previously published technique (B. C. Sawyer et al. Phys. Rev. Lett. \textbf{108}, 213003 (2012)). Furthermore, the structure of the dephasing histograms …
Anomalous motional heating is a major obstacle to scalable quantum information processing with trapped ions. While the source of this heating is not yet understood, several previous studies suggest that surface contaminants may be largely responsible. We demonstrate an improvement by a factor of four in the room-temperature heating rate of a niobium surface electrode trap by in situ plasma cleaning of the trap surface. This surface treatment was performed with a simple homebuilt coil assembly and commercially-available matching network and is considerably gentler than other treatments, such as…
In order to realize the full potential of ion trap quantum computers, an improved understanding is required of the motional heating that trapped ions experience. Experimental studies of the temperature-, frequency-, and ion--electrode distance-dependence of the electric field noise responsible for motional heating, as well as the noise before and after ion bombardment cleaning of trap electrodes, suggest that fluctuations of adsorbate dipoles are a likely source of so-called `anomalous heating,' or motional heating of the trapped ions at a rate much higher than the Johnson noise limit. Previou…
We demonstrate resolved sideband laser cooling of a single 40Ca+ ion in a macroscopic linear radio frequency trap with a radial diagonal electrode spacing of 7 mm and an rf drive frequency of just 3.7 MHz. For an oscillation frequency of 585 kHz along the rf-field-free axis, a ground state population of 99+-1% has been achieved, corresponding to a temperature of only 6 microkelvin. For several oscillation frequencies in the range 285 - 585 kHz, heating rates below one motional quantum per second have been measured at room temperature. The lowest measured heating power is about an order of magn…
Electric-field noise from the surfaces of ion-trap electrodes couples to the ion's charge causing heating of the ion's motional modes. This heating limits the fidelity of quantum gates implemented in quantum information processing experiments. The exact mechanism that gives rise to electric-field noise from surfaces is not well-understood and remains an active area of research. In this work, we detail experiments intended to measure ion motional heating rates with exchangeable surfaces positioned in close proximity to the ion, as a sensor to electric-field noise. We have prepared samples with …
Single, rf-trapped ions find various applications ranging from metrology to quantum computation. High-resolution interrogation of an extremely weak transition under best observation conditions requires an ion almost at rest. To avoid line-broadening effects such as the second order Doppler effect or rf heating in the absence of laser cooling, excess micromotion has to be eliminated as far as possible. In this work the motional state of a confined three-level ion is probed, taking advantage of the high sensitivity of observed dark resonances to the trapped ion's velocity. Excess micromotion is …
We demonstrate ground-state cooling of a trapped ion using radio-frequency (RF) radiation. This is a powerful tool for the implementation of quantum operations, where RF or microwave radiation instead of lasers is used for motional quantum state engineering. We measure a mean phonon number of $\overline{n} = 0.13(4)$ after sideband cooling, corresponding to a ground-state occupation probability of 88(7)\%. After preparing in the vibrational ground state, we demonstrate motional state engineering by driving Rabi oscillations between the n=0 and n=1 Fock states. We also use the ability to ground…
Motional heating of ions in micro-fabricated traps is a challenge hindering experimental realization of large-scale quantum processing devices. Recently a series of measurements of the heating rates in surface-electrode ion traps characterized their frequency, distance, and temperature dependencies, but our understanding of the microscopic origin of this noise is still vague. In this work we develop a theoretical model for the electric field noise which is associated with a random distribution of adsorbed atoms on the trap electrode surface. By using first principle calculations of the fluctua…
Atomic ions, confined in radio-frequency Paul ion traps, are a promising candidate to host a future quantum information processor. In this letter, we demonstrate a method to couple two motional modes of a single trapped ion, where the coupling mechanism is based on applying electric fields rather than coupling the ion's motion to a light field. This reduces the design constraints on the experimental apparatus considerably. As an application of this mechanism, we cool a motional mode close to its ground state without accessing it optically. As a next step, we apply this technique to measure the…
We investigate anomalous ion-motional heating, a limitation to multi-qubit quantum-logic gate fidelity in trapped-ion systems, as a function of ion-electrode separation. Using a multi-zone surface-electrode trap in which ions can be held at five discrete distances from the metal electrodes, we measure power-law dependencies of the electric-field noise experienced by the ion on the ion-electrode distance $d$. We find a scaling of approximately $d^{-4}$ regardless of whether the electrodes are at room temperature or cryogenic temperature, despite the fact that the heating rates are approximately…
We report on the first detailed study of motional heating in a cryogenic Penning trap using a single antiproton. Employing the continuous Stern-Gerlach effect we observe cyclotron quantum transition rates of 6(1) quanta/h and an electric field noise spectral density below $7.5(3.4)\times 10^{-20}\,\text{V}^{2}\text{m}^{-2} \text{Hz}^{-1}$, which corresponds to a scaled noise spectral density below $8.8(4.0)\times 10^{-12}\,\text{V}^{2}\text{m}^{-2}$, results which are more than two orders of magnitude smaller than those reported by other ion trap experiments.
We describe an ex-situ surface-cleaning procedure that is shown to reduce motional heating from ion-trap electrodes. This precleaning treatment, to be implemented immediately before the final assembly and vacuum processing of ion traps, removes surface contaminants remaining after the electrode-fabrication process. We incorporate a multi-angle ion-bombardment treatment intended to clean the electrode surfaces and interelectrode gaps of microfabricated traps. This procedure helps to minimize redeposition in the gaps between electrodes that can cause electrical shorts. We report heating rates in…
We investigate the motional dynamics of single and multiple ions during transport between and separation into spatially distinct locations in a multi-zone linear Paul trap. A single 9Be+ ion in a 2 MHz harmonic well located in one zone was laser-cooled to near its ground state of motion and transported 370 micrometers by moving the well to another zone. This was accomplished in 8 microseconds, corresponding to 16 periods of oscillation. Starting from a state with n=0.1 quanta, during transport the ion was excited to a displaced coherent state with n=1.6 quanta but on completion was returned cl…
For the past two and a half decades, anomalous heating of trapped ions from nearby electrode surfaces has continued to demonstrate unexpected results. Caused by electric-field noise, this heating of the ions' motional modes remains an obstacle for scalable quantum computation with trapped ions. One of the anomalous features of this electric-field noise is the reported nonmonotonic behavior in the heating rate when a trap is incrementally cleaned by ion bombardment. Motivated by this result, the present work reports on a surface analysis of a sample ion-trap electrode treated similarly with inc…
We describe a framework for calculating the frequency shift and uncertainty of trapped-ion optical atomic clocks caused by background-gas collisions, and apply this framework to an $^{27}$Al$^+$ clock to enable a total fractional systematic uncertainty below $10^{-18}$. For this clock, with 38(19) nPa of room temperature H$_2$ background gas, we find that collisional heating generates a non-thermal distribution of motional states with a mean time-dilation shift of order $10^{-16}$ at the end of a 150 ms probe, which is not detected by sideband thermometry energy measurements. However, the cont…
The decoherence of trapped-ion quantum gates due to heating of their motional modes is a fundamental science and engineering problem. This heating is attributed to electric-field noise arising from the trap-electrode surfaces. In this work, we investigate the source of this noise by focusing on the diffusion of carbon-containing adsorbates on the surface of Au(110). We show by density functional theory, based on detailed scanning probe microscopy, how the carbon adatom diffusion on the gold surface changes the energy landscape, and how the adatom dipole moment varies with the diffusive motion.…
We present a new type of compact and all-glass based vapour cell integrating hollow-core photonic crystal fibres. The absence of metals, as in a traditional vacuum chamber and the much more compact geometry allows for fast and homogeneous heating. As a consequence we can fill the fibres on much faster timescales, ranging from minutes to hours. Additionally the all-glass design ensures optical access along the fibre. This allows live monitoring of the diffusion of rubidium atoms inside the hollow-core by measuring the frequency-dependent fluorescence from the atoms. The atomic density is numeri…
