Measurements on current quantum processors are subject to hardware imperfections that lead to readout errors. These errors manifest themselves as a bias in quantum expectation values. Here, we propose a very simple method that forces the bias in the expectation value to appear as a multiplicative factor that can be measured directly and removed at the cost of an increase in the sampling complexity for the observable. The method assumes no specific form of the noise, but only requires that the noise is `weak' to avoid excessive sampling overhead. We provide bounds relating the error in the expectation value to the sample complexity.
Quantum computers are becoming increasingly accessible, and may soon outperform classical computers for useful tasks. However, qubit readout errors remain a significant hurdle to running quantum algorithms on current devices. We present a scheme to more efficiently mitigate these errors on quantum hardware and numerically show that our method consistently gives advantage over previous mitigation schemes. Our scheme removes biases in the readout errors allowing a general error model to be built with far fewer calibration measurements. Specifically, for reading out $n$-qubits we show a factor of…
Mitigating errors is a significant challenge for near term quantum computers. One of the most important sources of errors is related to the readout of the quantum state into a classical bit stream. A variety of techniques have been proposed to mitigate these errors with post-hoc corrections. We propose a complementary scheme to actively reduce readout errors on a shot-by-shot basis by encoding single qubits, immediately prior to readout, into multi-qubit states. The computational resources of our technique are independent of the circuit depth and fully compatible with current hardware error ra…
We introduce a correlated measurement noise model that can be efficiently described and characterized, and which admits effective noise-mitigation on the level of marginal probability distributions. Noise mitigation can be performed up to some error for which we derive upper bounds. Characterization of the model is done efficiently using Diagonal Detector Overlapping Tomography -- a generalization of the recently introduced Quantum Overlapping Tomography to the problem of reconstruction of readout noise with restricted locality. The procedure allows to characterize $k$-local measurement cross-…
False Positives Raised by Quantum Readout Error Mitigation
Beijing Academy of Quantum Information Sciences（北京量子信息科学研究院）；Institute of Physics, Chinese Academy of Sciences（中国科学院物理研究所）；University of Chinese Academy of Sciences（中国科学院大学）；State Key Laboratory of Precision and Intelligent Chemistry, University of Science and Technology of China（中国科学技术大学精密与智能化学重点实验室）；Institute of High Energy Physics, Chinese Academy of Sciences（中国科学院高能物理研究所）；Hefei National Laboratory（合肥国家实验室）
Quantum computing devices are inevitably subject to errors. To leverage quantum technologies for computational benefits in practical applications, quantum algorithms and protocols must be implemented reliably under noise and imperfections. Since noise and imperfections limit the size of quantum circuits that can be realized on a quantum device, developing quantum error mitigation techniques that do not require extra qubits and gates is of critical importance. In this work, we present a deep learning-based protocol for reducing readout errors on quantum hardware. Our technique is based on train…
We propose a simple scheme to reduce readout errors in experiments on quantum systems with finite number of measurement outcomes. Our method relies on performing classical post-processing which is preceded by Quantum Detector Tomography, i.e., the reconstruction of a Positive-Operator Valued Measure (POVM) describing the given quantum measurement device. If the measurement device is affected only by an invertible classical noise, it is possible to correct the outcome statistics of future experiments performed on the same device. To support the practical applicability of this scheme for near-te…
Readout errors are among the most dominant errors on current noisy intermediate-scale quantum devices. Recently, an efficient and scaleable method for mitigating such errors has been developed, based on classical bit-flip correction. In this talk, we compare the performance of this method for IBM's and Rigetti's quantum devices, demonstrating how the method improves the noisy measurements of observables obtained on the quantum hardware. Moreover, we examine the variance amplification to the data after applying of our mitigation procedure, which is common to all mitigation strategies. We derive…
Mitigation of Measurement-Induced State Transitions via a Fast-Load and Fast-Clear Readout
Academia Sinica（中央研究院）；National Central University（中央大学）；National Cheng Kung University（国立成功大学）；National Taiwan University（国立台湾大学）；National Changhua University of Education（国立彰化师范大学）；Center for Quantum Science and Engineering, National Taiwan University（国立台湾大学量子科学与工程中心）；Physics Division, National Center for Theoretical Sciences（国家理论科学中心物理组）
We present an error mitigation scheme which corrects readout errors on Noisy Intermediate-Scale Quantum (NISQ) computers [1,2]. After a short review of applying the method to one qubit, we proceed to discuss the case when correlations between different qubits occur. We demonstrate how the readout error can be mitigated in this case. By performing experiments on IBMQ hardware, we show that such correlations do not have a strong effect on the results, justifying to neglect them.
We investigate an error mitigated tomographic approach to the quantum circuit cutting problem in the presence of gate and measurement noise. We explore two tomography specific error mitigation techniques; readout error mitigated conditional fragment tomography, which uses knowledge of readout errors on all cut and conditional qubit measurements in the tomography reconstruction procedure; and dominant eigenvalue truncation (DEVT), which aims to improve the performance of circuit cutting by performing truncation of the individual conditional tomography fragments used in the reconstruction. We fi…
Noise in existing quantum processors only enables an approximation to ideal quantum computation. However, these approximations can be vastly improved by error mitigation, for the computation of expectation values, as shown by small-scale experimental demonstrations. However, the practical scaling of these methods to larger system sizes remains unknown. Here, we demonstrate the utility of zero-noise extrapolation for relevant quantum circuits using up to 26 qubits, circuit depths of 60, and 1080 CNOT gates. We study the scaling of the method for canonical examples of product states and entangli…
Hardware-Efficient Error Mitigation and Shot-Efficient Sampling on IBM Quantum Hardware
Quantum Information and Computation Centre, Department of Physics and Department of Computer Science and Engineering, Indian Institute of Technology Jodhpur（印度焦特普尔理工学院）
Error mitigation has been one of the recently sought after methods to reduce the effects of noise when computation is performed on a noisy near-term quantum computer. Interest in simulating stochastic processes with quantum models gained popularity after being proven to require less memory than their classical counterparts. With previous work on quantum models focusing primarily on further compressing memory, this work branches out into the experimental scene; we aim to bridge the gap between theoretical quantum models and practical use with the inclusion of error mitigation methods. It is obs…
In this work, we study and improve two leading error mitigation techniques, namely Probabilistic Error Cancellation (PEC) and Zero-Noise Extrapolation (ZNE), for estimating the expectation value of local observables. For PEC, we introduce a new estimator that takes into account the light cone of the unitary circuit with respect to a target local observable. Given a fixed error tolerance, the sampling overhead for the new estimator can be several orders of magnitude smaller than the standard PEC estimators. For ZNE, we also use light-cone arguments to establish an error bound that closely captu…
The accumulation of noise in quantum computers is the dominant issue stymieing the push of quantum algorithms beyond their classical counterparts. We do not expect to be able to afford the overhead required for quantum error correction in the next decade, so in the meantime we must rely on low-cost, unscalable error mitigation techniques to bring quantum computing to its full potential. This paper presents a new error mitigation technique based on quantum phase estimation that can also reduce errors in expectation value estimation (e.g., for variational algorithms). The general idea is to appl…
Repetition-code-based readout error detection and correction across hardware platforms and generations
HUN-REN Wigner Research Centre for Physics（匈牙利科学院维格纳物理研究中心）；HUN-REN Alfréd Rényi Institute of Mathematics（匈牙利科学院阿尔弗雷德·雷尼数学研究所）；ELTE Eötvös Loránd University（罗兰大学）；Algorithmiq Ltd.（Algorithmiq有限公司）；Department of Physics, University of Helsinki（赫尔辛基大学物理系）
Near term quantum computers suffer from the presence of different noise sources. In order to mitigate for this effect and acquire results with significantly better accuracy, there is the urge of designing efficient error correction or error mitigation schemes. The cost of such techniques is usually high in terms of resource requirements, either in hardware or at the algorithmic level. In this work, we follow a pragmatic approach and we use repetition codes as scalable schemes with the potential to provide more accurate solutions to problems of interest in quantum chemistry and physics. We inve…
Motivated by the readout scheme in interferometric gravitational-wave detectors, we consider the device which measures the expectation value of the photon annihilation and creation operators for output optical field from the main interferometer. As the result, the eight-port homodyne detection is rediscovered as such a device. We evaluate the noise spectral density in this measurement. We also briefly discuss on the application of our results to the readout scheme of gravitational-wave detectors. We call this measurement scheme to measure these expectation values as "double balanced homodyne d…
We use quantum detector tomography to characterize the qubit readout in terms of measurement POVMs on IBM Quantum Computers IBM Q 5 Tenerife and IBM Q 5 Yorktown. Our results suggest that the characterized detector model deviates from the ideal projectors by a few percent. Further improvement on this characterization can be made by adopting two- or more-qubit detector models instead of independent single-qubit detectors for all the qubits in one device. An unexpected behavior was seen in the physical qubit labelled as qubit 3 of IBM Q 5 Tenerife, which can be a consequence of detector crosstal…
Readout errors are a significant source of noise for near term intermediate scale quantum computers. Mismeasuring a qubit as a 1 when it should be 0 occurs much less often than mismeasuring a qubit as a 0 when it should have been 1. We make the simple observation that one can improve the readout fidelity of quantum computers by applying targeted X gates prior to performing a measurement. These X gates are placed so that the expected number of qubits in the 1 state is minimized. Classical post processing can undo the effect of the X gates so that the expectation value of any observable is uncha…
In the noisy intermediate-scale quantum (NISQ) era, quantum error mitigation will be a necessary tool to extract useful performance out of quantum devices. However, there is a big gap between the noise models often assumed by error mitigation techniques and the actual noise on quantum devices. As a consequence, there arises a gap between the theoretical expectations of the techniques and their everyday performance. Cloud users of quantum devices in particular, who often take the devices as they are, feel this gap the most. How should they parametrize their uncertainty in the usefulness of thes…
We present a scheme to neutralize the dephasing effect induced by classical noise on a qubit. The scheme builds upon the key idea that this kind of noise can be recorded by a classical device during the qubit evolution, and that its effect can be undone by a suitable control sequence that is conditioned on the measurement result. We specifically demonstrate this scheme on a nitrogen-vacancy (NV) center that strongly couples to current noise in a nearby conductor. By conditioning the readout observable on a measurement of the current, we recover the full qubit coherence and its intrinsic cohere…
Variational Quantum Algorithms (VQAs) are a promising application for near-term quantum processors, however the quality of their results is greatly limited by noise. For this reason, various error mitigation techniques have emerged to deal with noise that can be applied to these algorithms. Recent work introduced a technique for mitigating expectation values against correlated measurement errors that can be applied to measurements of 10s of qubits. We apply these techniques to VQAs and demonstrate its effectiveness in improving estimates to the cost function. Moreover, we use the data resultin…
Single-photon detectors are ubiquitous and integral components of photonic quantum cryptography, communication, and computation. Many applications, however, require not only detecting the presence of any photons, but distinguishing the number present with a single shot. Here, we implement a single-shot, high-fidelity photon number-resolving detector of up to 15 microwave photons in a cavity-qubit circuit QED platform. This detector functions by measuring a series of generalized parity operators which make up the bits in the binary decomposition of the photon number. Our protocol consists of su…
Several techniques have been recently introduced to mitigate errors in near-term quantum computers without the overhead required by quantum error correcting codes. While most of the focus has been on gate errors, measurement errors are significantly larger than gate errors on some platforms. A widely used {\it transition matrix error mitigation} (TMEM) technique uses measured transition probabilities between initial and final classical states to correct subsequently measured data. However from a rigorous perspective, the noisy measurement should be calibrated with perfectly prepared initial st…
