Radial Density Profile and Stability of Capillary Discharge Plasma Waveguides of Lengths up to 40 Centimeters
M. Turner, A. J. Gonsalves, S. S. Bulvanov, C. Benedetti, N. A. Bobrova, V. A. Gasilov, P. V. Sasorov, G. Korn, K. Nakamura, J. van Tilborg, C. G. Geddes, C. B.… 展开作者
M. Turner, A. J. Gonsalves, S. S. Bulvanov, C. Benedetti, N. A. Bobrova, V. A. Gasilov, P. V. Sasorov, G. Korn, K. Nakamura, J. van Tilborg, C. G. Geddes, C. B. Schroeder, E. Esarey
We measured the parameter reproducibility and radial electron density profile of capillary discharge waveguides with diameters of 650 um to 2 mm and lengths of 9 to 40 cm. To our knowledge, 40 cm is the longest discharge capillary plasma waveguide to date. This length is important for >= 10 GeV electron energy gain in a single laser driven plasma wakefield acceleration (LPA) stage. Evaluation of waveguide parameter variations showed that their focusing strength was stable and reproducible to <0.2% and their average on-axis plasma electron density to <1%. These variations explain only a small fraction of LPA electron bunch variations observed in experiments to date. Measurements of laser pulse centroid oscillations revealed that the radial channel profile rises faster than parabolic and are in excellent agreement with magneto-hydro-dynamic simulation results. We show that the effects of non-parabolic contributions on Gaussian pulse propagation were negligible when the pulse was approximately matched to the channel. However, they affected pulse propagation for a non-matched configuration in which the waveguide was used as a plasma telescope to change the focused laser pulse spot size.
A new method able to transport charged particle beams along curved paths is presented. It is based on curved capillary-discharge waveguides in which the induced azimuthal magnetic field is used both to focus the beam and keep it close to the capillary axis. We show that such a solution is highly tunable, it allows to develop compact structures providing large deflecting angles and, unlike conventional solutions based on bending magnets, preserves the beam longitudinal phase space. The latter feature, in particular, is very promising when dealing with ultra-short bunches for which non-trivial m…
A method of creating plasma channels with controllable depth and transverse profile for the guiding of short, high power laser pulses for efficient electron acceleration is proposed. The plasma channel produced by the hydrogen-filled capillary discharge waveguide is modified by a ns-scale laser pulse, which heats the electrons near the capillary axis. This interaction creates a deeper plasma channel within the capillary discharge that evolves on a ns-time scale, allowing laser beams with smaller spot sizes than would otherwise be possible in the unmodified capillary discharge.
Magnetohydrodynamics (MHD) can be used to model capillary discharge waveguides in laser-wakefield accelerators. However, the predictive capability of MHD can suffer due to poor microscopic closure models. Here, we study the impact of electron heating and thermal conduction on capillary waveguide performance as part of an effort to understand and quantify uncertainties in modeling and designing next-generation plasma accelerators. To do so, we perform two-dimensional high-resolution MHD simulations using an argon-filled capillary discharge waveguide with three different electron transport coeff…
A technique to generate jets of pure Titanium plasma is presented. A Ti wire is exploded in an Alumina capillary sealed with 1atm. of air inside. The generated plasma emerges from the capillary (to a high-vacuum environment) by ripping a thin Ti foil that seals one of the capillary ends. The generated plasma jets have a velocity of up to $4.5\pm0.5mm/μs$, an electron temperature of $1.5\pm0.5eV$ and a ion density of $2.7\pm1\times10^{17}/cc$. The plasma source was designed for a capillary discharge extreme ultraviolet laser experiment, but might also be useful to other application such as a ta…
We study the effect of neutral atoms on the dynamics of a capillary discharge Z-pinch, in a regime for which a large soft-x-ray amplification has been demonstrated. We extended the commonly used one-fluid magneto-hydrodynamics (MHD) model by separating out the neutral atoms as a second fluid. Numerical calculations using this extended model yield new predictions for the dynamics of the pinch collapse, and better agreement with known measured data.
Plasma properties inside a hydrogen-filled capillary discharge waveguide were modeled with dissipative magnetohydrodynamic simulations to enable analysis of capillaries of circular and square cross-sections implying that square capillaries can be used to guide circularly-symmetric laser beams. When the quasistationary stage of the discharge is reached, the plasma and temperature in the vicinity of the capillary axis has almost the same profile for both the circular and square capillaries. The effect of cross-section on the electron beam focusing properties were studied using the simulation-der…
A method for the asymmetric focusing of electron bunches, based on the active plasma lensing technique is proposed. This method takes advantage of the strong inhomogeneous magnetic field generated inside the capillary discharge plasma to focus the ultrarelativistic electrons. The plasma and magnetic field parameters inside the capillary discharge are described theoretically and modeled with dissipative magnetohydrodynamic computer simulations enabling analysis of the capillaries of rectangle cross-sections. Large aspect ratio rectangular capillaries might be used to transport electron beams wi…
The results from a series of experiments are presented whose purpose is to explore different schemes which may lead to the formation of pure metal plasmas in a capillary discharge with parameters appropriate for X ray lasing. The experiments were performed in ceramic wall capillary discharges at currents of up to 120 kA, with an available ID of between 3 and 8 mm and with lengths from 60 to 100 mm. Initial plasma conditions in the capillary exploit transient hollow cathode effects in a preionizing discharge. A laser focussed onto the back surface of the cathode initiates both beam activity in …
In the past few years collisionally pumped extreme ultraviolet (XUV) lasers utilizing a capillary discharge were demonstrated. An intense current pulse is applied to a gas filled capillary, inducing magnetic collapse (Z-pinch) and formation of a highly ionized plasma column. Usually, a small current pulse (pre-pulse) is applied to the gas in order to pre-ionize it prior to the onset of the main current pulse. In this paper we investigate the effects of the pre-pulse on a capillary discharge Ne-like Ar XUV laser (46.9nm). The importance of the pre-pulse in achieving suitable initial conditions …
One of the most robust methods, demonstrated up to date, of accelerating electron beams by laser-plasma sources is the utilization of plasma channels generated by the capillary discharges. These channels, i.e., plasma columns with a minimum density along the laser pulse propagation axis, may optically guide short laser pulses, thereby increasing the acceleration length, leading to a more efficient electron acceleration. Although the spatial structure of the installation is simple in principle, there may be some important effects caused by the open ends of the capillary, by the supplying channe…
The excitation of plasma waves over a length of up to 8 centimeters is, for the first time, demon- strated using laser guiding of intense laser pulses through hydrogen filled glass capillary tubes. The plasma waves are diagnosed by spectral analysis of the transmitted laser radiation. The dependence of the spectral redshift, measured as a function of filling pressure, capillary tube length and incident laser energy, is in excellent agreement with simulation results. The longitudinal accelerating field inferred from the simulations is in the range 1 -10 GV/m.
X-ray lasers based on transitions in highly charged \textit{Ni}-like ions generating in the "water window" wavelength range can be pumped by compact laboratory discharge sources. This makes them promising candidates for use as compact coherent X-ray sources in laboratory applications including biological imaging and investigations of carbon containing materials. In this paper, the results of numerical simulations of the plasma dynamics and kinetics in an X-ray laser based on transitions in \textit{Ni}-like xenon ions are reported. The laser active medium is created by an extended low-inductive…
Atmospheric pressure capillary dielectric barrier oxygen discharge plasma jet is developed to generate non-thermal plasma using unipolar positive pulse power supply. Both optical and electrical techniques are used to investigate the characteristics of the produced plasma as function of applied voltage and gas flow rate. Analytical results obtained from the optical emission spectroscopic data reveal the gas temperature, rotational temperature, excitation temperature and electron density. Gas temperature and rotational temperature are found to decrease with increasing oxygen flow rate but increa…
We present a space and time resolved interferometric plasma diagnostic for use on plasmas where neutral-bound electron contribution to the refractive index cannot be neglected. By recording simultaneously the plasma optical index at 532 and 1064 nm, we are able to extract independently the neutral and free electron density profiles. We report a phase resolution of 30 mrad, corresponding to a maximum resolution on the order of $4\times10^{23}~\mathrm{m}^{-3}$ for the electron density, and of $10^{24} ~ \mathrm{m}^{-3}$ for the neutral density. The interferometer is demonstrated on centimeter-sc…
We investigate experimentally the plasma dynamics of a centimeter-scale, laser filamentation-guided spark discharge. Using electrical and optical diagnostics to study monopolar discharges with varying current pulses we show that plasma decay is dominated by free electron recombination if the current decay time is shorter than the recombination characteristic time. In the opposite case, the plasma electron density closely follows the current evolution. We demonstrate that this criterion holds true in the case of damped AC sparks, and that alternative current is the best option to achieve a long…
Betatron x-ray emission in laser-plasma accelerators is a promising compact source that may be an alternative to conventional x-ray sources, based on large scale machines. In addition to its potential as a source, precise measurements of betatron emission can reveal crucial information about relativistic laser-plasma interaction. We show that the emission length and the position of the x-ray emission can be obtained by placing an aperture mask close to the source, and by measuring the beam profile of the betatron x-ray radiation far from the aperture mask. The position of the x-ray emission gi…
Packed bed plasma reactors (PBPRs) inherently have complex geometries where the volume between the electrodes is filled with dielectric/catalytic pellets to form an array of voids and cavities. This design generates multiple length scales i.e. the dimension of the plasma region (of the order of centimeters), of the dielectric/catalytic pellets (of the order of millimeters) and of the void between the dielectrics (or cavities) and/or surface pores that can reach micrometer dimensions. The plasma is formed as an array of connected or segmented microdischarges. The understanding of plasma propaga…
A new gas puff imaging (GPI) diagnostic has been developed on the HL-2A tokamak to study two-dimensional plasma edge turbulence in poloidal vs. radial plane. During a discharge, neutral helium or deuterium gas is puffed at the edge of the plasma through a rectangular multi-capillary nozzle to generate a gas cloud on the observing plane. Then a specially designed telescope and a high-speed camera are used to observe and photograph the emission from the neutral gas cloud. The brightness and contrast in the 2-D poloidal vs. radial frames reveal the structures and movements of the turbulence. The …
The paper presents the results of numerical PIC-simulation of accelerated and drive bunches dynamics in a dielectric waveguide filled with radially inhomogeneous plasma. The wakefield was excited by the electron bunch in a quartz (permittivity 3.75) dielectric tube with outer and inner diameters of 1.2 mm and 1.0 mm, respectively, which was nested into a cylindrical metallic waveguide. The drive bunch characteristics were chosen to be: 5 GeV for electron energy, 3 nC for the charge, 0.2 mm - the bunch length, 0.9 mm - the bunch diameter. The accelerated bunch had the same parameters, except fo…
