Making large overhangs in micrometer and nanometer-sized structures
英文摘要：
We describe two general procedures for fabricating microstructures with large overhangs and high aspect-ratio support pillars. The first method uses a static angled dry etch on micro- or nano-pillars to create an initial overhang, followed by wet etching for further erosion. The second method uses a time-dependent angled etch on a flat plane patterned with protective resin, to reduce the number of lithography steps needed to make these objects. The time-dependent dry etch is again followed by a wet etch. For the second method we derive a formula that provides the rate at which the attack angle must evolve, given a known etch rate within the target material, the depth of the desired overhang (undercut), and the instantaneous attack angle.
机构、总结、中文摘要均由AI分析而来，可能存在错误，请以论文正文为准。
