We present fully analytical solutions for the deformation of a stretched soft substrate due to the static wetting of a large liquid droplet, and compare our solutions to recently published experiments (Xu et al, Soft Matter 2018). Following a Green's function approach, we extend the surface-stress regularized Flamant-Cerruti problem to account for uniaxial pre-strains of the substrate. Surface profiles, including the heights and opening angles of wetting ridges, are provided for linearized and finite kinematics. We fit experimental wetting ridge shapes as a function of applied strain using two free parameters, the surface Lame coefficients. In comparison with experiments, we find that observed opening angles are more accurately captured using finite kinematics, especially with increasing levels of applied pre-strain. These fits qualitatively agree with the results of Xu et al, but revise values of the surface elastic constants.
Anisotropically wetting substrates enable useful control of droplet behavior across a range of applications. Usually, these involve chemically or physically patterning the substrate surface, or applying gradients in properties like temperature or electrical field. Here, we show that a flat, stretched, uniform soft substrate also exhibits asymmetric wetting, both in terms of how droplets slide and in their static shape. Droplet dynamics are strongly affected by stretch: glycerol droplets on silicone substrates with a 23\% stretch slide 67\% faster in the direction parallel to the applied stretc…
Solid interfaces have intrinsic elasticity. However, in most experiments, this is obscured by bulk stresses. Through microscopic observations of the contact-line geometry of a partially wetting droplet on an anisotropically stretched substrate, we measure two surface-elastic constants that quantify the linear dependence of the surface stress of a soft polymer gel on its strain. With these two parameters, one can predict surface stresses for general deformations of the material in the linear-elastic limit.
We use computer simulations to study the relaxation of strongly deformed highly entangled polymer melts in the non-linear viscoelastic regime, focusing on anisotropic chain conformations after isochoric elongation. The Doi-Edwards tube model and its GLaMM extension, incorporating contour length fluctuation and convective constraint release, predict a retraction of the polymer chain extension in all directions, setting in immediately after deformation. This prediction has been challenged by experiment, simulation, and other theoretical studies, questioning the general validity of the tube conce…
Liquid droplets usually wet smooth and homogeneous substrates isotropically. Recent research works have revealed that droplets sit, slide and spread anisotropically on uniaxially stretched soft substrates, showing an enhanced wettability and contact line mobility along the stretching direction. This phenomenon arises from the anisotropic deformation of the substrate below the contact line. Here, we investigate how the stretching of soft substrates affects droplets drying. We observe that water droplet evaporates with an elongated non-circular contact line on the stretched substrates and switch…
When elastic solids are sheared, a nonlinear effect named after Poynting gives rise to normal stresses or changes in volume. We provide a novel relation between the Poynting effect and the microscopic Grüneisen parameter, which quantifies how stretching shifts vibrational modes. By applying this relation to random spring networks, a minimal model for, e.g., biopolymer gels and solid foams, we find that networks contract or develop tension because they vibrate faster when stretched. The amplitude of the Poynting effect is sensitive to the network's linear elastic moduli, which can be tuned via …
We introduce an anisotropic mean-field approach for the dynamics of semiflexible polymers under intermediate tension, the force range where a chain is partially extended but not in the asymptotic regime of a nearly straight contour. The theory is designed to exactly reproduce the lowest order equilibrium averages of a stretched polymer, and treats the full complexity of the problem: the resulting dynamics include the coupled effects of long-range hydrodynamic interactions, backbone stiffness, and large-scale polymer contour fluctuations. Validated by Brownian hydrodynamics simulations and comp…
In amorphous solids as in tissues, neighbor exchanges can relax local stresses and allow the material to flow. In this paper, we use an anisotropic vertex model to study T1 rearrangements in polygonal cellular networks. We consider two different physical realizations of the active anisotropic stresses: (i) anisotropic bond tension and (ii) anisotropic cell stress. Interestingly, the two types of active stress lead to patterns of relative orientation of T1 transitions and cell elongation that are different. Our work suggests that these two realizations of anisotropic active stresses can be obse…
We demonstrate a novel technique to fabricate mechanically tunable slippery surfaces using one dimensional (anisotropic) elastic wrinkles. Such wrinkles show tunable topography (amplitude) on the application of mechanical strain. Following Nepenthes pitcher plants, lubricating fluid infused solid surfaces show excellent slippery behavior for test liquid drops. Therefore combining the above two i.e. infusing suitable lubricating fluid on elastic wrinkles would enable us to fabricate mechanically tunable slippery surfaces. Completely stretched (flat) wrinkles have uniform coating of lubricating …
Stress propagation in nonlinear media is crucial in cell biology, where molecular motors exert anisotropic force dipoles on the fibrous cytoskeleton. While the force dipoles can be either contractile or expansile, a medium made of fibers which buckle under compression rectifies these stresses towards a biologically crucial contraction. A general understanding of this rectification phenomenon as a function of the medium's elasticity is however lacking. Here we use theoretical continuum elasticity to show that rectification is actually a very general effect in nonlinear materials subjected to an…
Some relationships, fundamental to the resolution of interface wave problems, are presented. These equations allow for the derivation of explicit secular equations for problems involving waves localized near the plane boundary of anisotropic elastic half-spaces, such as Rayleigh, Sholte, or Stoneley waves. They are obtained rapidly, without recourse to the Stroh formalism. As an application, the problems of Stoneley wave propagation and of interface stability for misaligned predeformed incompressible half-spaces are treated. The upper and lower half-spaces are made of the same material, subjec…
Residual stresses in a thin film deposited on a substrate results in a curvature of the system, which can be measured using the well known Stoney equation. Isotropic elasticity of the substrate along with infinitesimal strains and rotations are two important assumptions used in the derivation of the Stoney equation. However, the transverse deflection in the substrate contributes significantly to the extensional strain in its plane, leading to non-linearity in its deformation. Moreover, Silicon wafers are predominantly used as substrate materials to measure the curvature of the system. In this …
An elastic membrane with embedded nematic molecules is considered as a model of anisotropic fluid membrane with internal ordering. By considering the geometric coupling between director field and membrane curvature, the nematic texture is shown to induce anisotropic stresses additional to Canham-Helfrich elasticity. Building upon differential geometry, analytical expressions are found for the membrane stress and torque induced by splaying, twisting and bending of the nematic director as described by the Frank energy of liquid crystals. The forces induced by prototypical nematic textures are vi…
A macroscopic elastic description of stresses in static, preloaded granular media is derived systematically from the microscopic elasticity of individual inter-grain contacts. The assumed preloaded state and friction at contacts ensure that the network of inter-grain contacts is not altered by small perturbations. The texture of this network, set by the preparation of the system, is encoded in second and fourth order fabric tensors. A small perturbation generates both normal and tangential inter-grain forces, the latter causing grains to reorient. This reorientation response and the incrementa…
Hard sphere colloidal particles are a basic model system for general research into phase behavior, ordering and out-equilibrium glass transitions. Experimentally it has been shown that oscillatory shearing of a monodisperse hard sphere glass, produces two different crystal orientations; a Face Centered Cubic (FCC) crystal with the close packed direction parallel to shear at high strains and an FCC crystal with the close packed direction perpendicular to shear at low strains. Here, using Brownian dynamics simulations of hard sphere particles, we have examined high volume fraction shear-induced …
A mesoscopic model for shear plasticity of amorphous materials in two dimensions is introduced, and studied through numerical simulations in order to elucidate the macroscopic (large scale) mechanical behavior. Plastic deformation is assumed to occur through a series of local reorganizations. Using a discretization of the mechanical fields on a discrete lattice, local reorganizations are modeled as local slip events. Local yield stresses are randomly distributed in space and invariant in time. Each plastic slip event induces a long-ranged elastic stress redistribution. Rate and thermal effects…
Phosphorene, a newly fabricated two-dimensional (2D) nanomaterial, have exhibited promising application prospect in biology. Nonetheless, the wetting and diffusive properties of bio-fluids on phosphorene are still elusive. In this study, using molecular dynamics (MD) simulations, we investigated the structural and dynamic properties of water on pristine and strained phosphorene. The MD simulations illustrated that the diffusion of water molecules on the phosphorene surface is anisotropic, while strain-enhanced diffusion is clearly present which arises from strain-induced smooth of the energy l…
Molecular dynamic simulation enables one to correlate the evolution of the micro-structure with anisotropic stress when a material is subject to strain. The anisotropic stress due to a constant strain-rate load in a cross-linked polymer is primarily dependent on the mean-square bond length and mean-square bond angle. Excluded volume interactions due to chain stacking and spatial distribution also has a bearing on the stress response. The bond length distribution along the chain is not uniform. Rather, the bond lengths at the end of the chains are larger and uniformly decrease towards the middl…
Biological cells in soft materials can be modeled as anisotropic force contraction dipoles. The corresponding elastic interaction potentials are long-ranged ($\sim 1/r^3$ with distance $r$) and depend sensitively on elastic constants, geometry and cellular orientations. On elastic substrates, the elastic interaction is similar to that of electric quadrupoles in two dimensions and for dense systems leads to aggregation with herringbone order on a cellular scale. Free and clamped surfaces of samples of finite size introduce attractive and repulsive corrections, respectively, which vary on the ma…
