It is usually expected that surface tension driven flow dominates at small scales. Evaporation from the meniscus of ethanol/methanol confined in a capillary induces Marangoni convection at the meniscus which has been investigated by previous researchers. However, Marangoni convection is unexpectedly absent at an evaporating water meniscus confined inside a small micro-channel which is reported in this work. The velocity near the water meniscus is studied using confocal micro-PIV. The water meniscus is formed at the end of a micro-channel filled with water keeping the meniscus exposed to atmosphere. The flow near the evaporating water meniscus is caused by combined effect of capillary flow to replenish water loss at the meniscus and buoyancy flow caused by evaporation induced temperature gradient. Unidirectional capillary flow dominates for small capillary size where as circulating buoyancy convection dominates in larger capillary size. The reported unexpected behavior of flow at the evaporating water meniscus will be helpful to understand the inter-facial phenomena in future studies.
Small water droplets or particles located at an oil meniscus typically climb the meniscus due to unbalanced capillary forces. Here, we introduce a size-dependent reversal of this meniscus-climbing behavior, where upon cooling of the underlying substrate, droplets of different sizes concurrently ascend and descend the meniscus. We show that microscopic Marangoni convection cells within the oil meniscus are responsible for this phenomenon. While dynamics of relatively larger water microdroplets are still dominated by unbalanced capillary forces and hence ascend the meniscus, smaller droplets are…
The stationary single vortex Marangoni convection in an axially symmetrical sessile drop of capillary size is considered. The detailed description of the fluid flows is presented for a wide range of contact angles, which takes into account the boundary conditions and the mass balance equation, without explicitly solving the Navier--Stokes equations. The analytical approach developed is compared with the results of numerical simulations and demonstrated to describe reasonably well the single-vortex Marangoni flows. This indicates the substantial role of the boundary conditions in the problem.
Recent developments in fabrication techniques enabled the production of nano- and angstrom-scale conduits. While scientists are able to conduct experimental studies to demonstrate extreme evaporation rates from these capillaries, theoretical modeling of evaporation from a few nanometers or sub-nanometer meniscus interfaces, where adsorbed film, transition film and intrinsic region are intertwined, is absent in the literature. Using the computational setup constructed to identify the detailed profile of a nano-scale evaporating interface, we discovered the existence of lateral momentum transpor…
For a small sessile or pendant droplet it is generally assumed that gravity does not play any role once the Bond number is small. This is even assumed for evaporating binary sessile or pendant droplets, in which convective flows can be driven due to selective evaporation of one component and the resulting concentration and thus surface tension differences at the air-liquid interface. However, recent studies have shown that in such droplets gravity indeed can play a role and that natural convection can be the dominant driving mechanism for the flow inside evaporating binary droplets (Edwards et…
Evaporating salty droplets are ubiquitous in nature, in our home and in the laboratory. Interestingly, the transport processes in such apparently simple systems differ strongly from evaporating "freshwater" droplets since convection is partly inverted due to Marangoni stresses. Such an effect has crucial consequences to the salt crystallization process and to the deposits left behind. In this work we show unprecedented measurements that, not only confirm clearly the patterns of the flow inversion, but also elucidate their impact on the distribution of non-volatile solutes. Contrary to what has…
The deposition of particles on a surface by an evaporating sessile droplet is important for phenomena as diverse as printing, thin-film deposition and self-assembly. The shape of the final deposit depends on the flows within the droplet during evaporation. These flows are typically determined at the onset of the process by the intrinsic physical, chemical and geometrical properties of the droplet and its environment. Here, we demonstrate deterministic emergence and real-time control of Marangoni flows within the evaporating droplet by an external point-source of vapor. By varying the source lo…
Phase segregation triggered by selective evaporation can emerge in multicomponent systems, leading to complex physiochemical hydrodynamics. Recently, Li et al. (Phys. Rev. Lett., vol. 120, 2018, 224501) and Kim & Stone (J. Fluid Mech., vol. 850, 2018, pp. 769-783) reported a segregative behavior (i.e., demixing) in an evaporating binary droplet. In this work, by means of experiments and theoretical analysis, we investigate the flow dynamics after the occurrence of the phase segregation. As example, we take the 1,2-hexanediol-water binary droplet system. First, we experimentally reveal the over…
We study unsteady internal flows in a sessile droplet of capillary size evaporating in constant contact line mode on a heated substrate. Three-dimensional simulations of internal flows in evaporating droplets of ethanol and silicone oil have been carried out. For describing the Marangoni flows we find it necessary to account for the diffusion of vapor in air, the thermal conduction in all three phases and thermal radiation. The equations have been solved numerically by finite element method using ANSYS Fluent. As a result of the simulations, the nonstationary behavior of Bénard-Marangoni (BM) …
Several dynamical stages of the Marangoni convection of an evaporating sessile drop are obtained. We jointly take into account the hydrodynamics of an evaporating sessile drop, effects of the thermal conduction in the drop and the diffusion of vapor in air. The stages are characterized by different number of vortices in the drop and the spatial location of vortices. During the early stage the array of vortices arises near a surface of the drop and induces a non-monotonic spatial distribution of the temperature over the drop surface. The number of near-surface vortices in the drop is controlled…
The evaporation of multi-component droplets is relevant to various applications but challenging to study due to the complex physicochemical dynamics. Recently, Li (2018) reported evaporation-triggered segregation in 1,2-hexanediol-water binary droplets. In this present work, we added 0.5 wt% silicone oil into the 1,2-hexanediol-water binary solution. This minute silicone oil concentration dramatically modifies the evaporation process as it triggers an early extraction of the 1,2-hexanediol from the mixture. Surprisingly, we observe that the segregation of 1,2-hexanediol forms plumes, rising up…
Temperature distributions and the corresponding vortex structures in an evaporating sessile droplet are obtained by performing detailed numerical calculations. A Marangoni convection induced by thermal conduction processes in the drop and the substrate is demonstrated to be able to result not only in a single vortex, but also in two or three vortices, depending on the ratio of substrate to fluid thermal conductivities, on the substrate thickness and the contact angle. The "phase diagrams" containing information on the number, orientation and spatial location of the vortices for quasistationary…
The transport and aggregation of particles in suspensions is an important process in many physicochemical and industrial processes. In this work, we study the transport of particles in an evaporating binary droplet. Surprisingly, the accumulation of particles occurs not only at the contact line (due to the coffee-stain effect) or at the solid substrate (due to sedimentation), but also at a particular radial position near the liquid-air interface, forming a "ring", which we term as the Marangoni ring. The formation of this ring is primarily attributed to the solutal Marangoni flow triggered by …
Fluid dynamics video of an evaporating sessile drop of capillary size is presented. The corresponding simulation represents the description taking into account jointly time dependent hydrodynamics, vapor diffusion and thermal conduction in an evaporating sessile drop. The fluid convection in the drop is driven by Marangoni forces associated with the temperature dependence of the surface tension. For the first time the evolution of the vortex structure in the drop during an evaporation process is obtained.
The Greek aperitif Ouzo is not only famous for its specific anise-flavored taste, but also for its ability to turn from a transparent miscible liquid to a milky-white colored emulsion when water is added. Recently, it has been shown that this so-called Ouzo effect, i.e. the spontaneous emulsification of oil microdroplets, can also be triggered by the preferential evaporation of ethanol in an evaporating sessile Ouzo drop, leading to an amazingly rich drying process with multiple phase transitions [H. Tan et al., Proc. Natl. Acad. Sci. USA 113(31) (2016) 8642]. Due to the enhanced evaporation n…
Motived by recent ground-based and microgravity experiments investigating the interfacial dynamics of a volatile liquid (FC-72, $Pr=12.34$) contained in a heated cylindrical cell, we numerically study the thermocapillary-driven flow in such an evaporating liquid layer. Particular attention is given to the prediction of the transition of the axisymmetric flow to fully three-dimensional patterns when the applied temperature increases. The numerical simulations rely on an improved one-sided model of evaporation by including heat and mass transfer through the gas phase via the heat transfer Biot n…
The evaporation of a drop from a liquid subphase is investigated. The two liquids are immiscible, and the contact angles between them are given by the Neumann construction. The evaporation of the drop gives rise to flows in both liquids, which are coupled by the continuity of velocity and shear-stress conditions. We derive self-similar solutions to the velocity fields in both liquids close to the three-phase contact line, where the drop geometry can be approximated by a wedge. We focus on the case where Marangoni stresses are negligible, for which the flow field consists of three contributions…
The shape of deposits obtained from drying drops containing colloidal particles matters for technologies such as inkjet printing, microelectronics and bioassay manufacturing. In this work, the formation of deposits during the drying of nanoliter drops containing colloidal particles is investigated experimentally with microscopy and profilometry, and theoretically with an inhouse finite-element code. The system studied involves aqueous drops containing titania nanoparticles evaporating on a glass substrate. Deposit shapes from spotted drops at different pH values are measured using a laser prof…
Theoretical description and numerical simulation of an evaporating sessile drop are developed. We jointly take into account the hydrodynamics of an evaporating sessile drop, effects of the thermal conduction in the drop and the diffusion of vapor in air. A shape of the rotationally symmetric drop is determined within the quasistationary approximation. Nonstationary effects in the diffusion of the vapor are also taken into account. Simulation results agree well with the data of evaporation rate measurements for the toluene drop. Marangoni forces associated with the temperature dependence of the…
A theoretical framework is established to model the evaporation from continuously fed droplets, promising tools in the thermal management of high heat flux electronics. Using the framework, a comprehensive model is developed for a hemispherical water droplet resting on a heated flat substrate incorporating all of the relevant transport mechanisms: buoyant and thermocapillary convection inside the droplet and diffusive and convective transport of vapor in the gas domain. At the interface, mass, momentum, and thermal coupling of the phases are also made accounting for all pertinent physical aspe…
Droplet evaporation of multicomponent droplets is essential for various physiochemical applications, e.g. in inkjet printing, spray cooling and microfabrication. In this work, we observe and study phase segregation of an evaporating sessile binary droplet, consisting of a mixture of water and a surfactant-like liquid (1,2-hexanediol). The phase segregation (i.e., demixing) leads to a reduced water evaporation rate of the droplet and eventually the evaporation process ceases due to shielding of the water by the non-volatile 1,2-hexanediol. Visualizations of the flow field by particle image velo…
