Predicting plasticity in disordered solids from structural indicators
D. Richard, M. Ozawa, S. Patinet, E. Stanifer, B. Shang, S. A. Ridout, B. Xu, G. Zhang, P. K. Morse, J. -L. Barrat, L. Berthier, M. L. Falk, P. Guan, A. J. Liu,… 展开作者
D. Richard, M. Ozawa, S. Patinet, E. Stanifer, B. Shang, S. A. Ridout, B. Xu, G. Zhang, P. K. Morse, J. -L. Barrat, L. Berthier, M. L. Falk, P. Guan, A. J. Liu, K. Martens, S. Sastry, D. Vandembroucq, E. Lerner, M. L. Manning
Amorphous solids lack long-range order. Therefore identifying structural defects -- akin to dislocations in crystalline solids -- that carry plastic flow in these systems remains a daunting challenge. By comparing many different structural indicators in computational models of glasses, under a variety of conditions we carefully assess which of these indicators are able to robustly identify the structural defects responsible for plastic flow in amorphous solids. We further demonstrate that the density of defects changes as a function of material preparation and strain in a manner that is highly correlated with the macroscopic material response. Our work represents an important step towards predicting how and when an amorphous solid will fail from its microscopic structure.
We review in these notes the dynamics of extended condensed matter systesm, such as vortex lattices in type-II superconductors and charge density waves in anisotropic metals, driven over quenched disorder. We focus in particular on the case of strong disorder, where topological defects are generated in the driven lattice. In this case the repsonse is plastic and the depinning transition may become discontinuous and hysteretic.
The plastic flow of a foam results from bubble rearrangements. We study their occurrence in experiments where a foam is forced to flow in 2D: around an obstacle; through a narrow hole; or sheared between rotating disks. We describe their orientation and frequency using a topological matrix defined in the companion paper (Graner et al., preprint), which links them with continuous plasticity at large scale. We then suggest a phenomenological equation to predict the plastic strain rate: its orientation is determined from the foam's local elastic strain; and its rate is determined from the foam's …
Elastoplastic lattice models for the response of solids to deformation typically incorporate structure only implicitly via a local yield strain that is assigned to each site. However, the local yield strain can change in response to a nearby or even distant plastic event in the system. This interplay is key to understanding phenomena such as avalanches in which one plastic event can trigger another, leading to a cascade of events, but typically is neglected in elastoplastic models. To include the interplay one could calculate the local yield strain for a given particulate system and follow its…
In amorphous solids subject to shear or thermal excitation, so-called structural indicators have been developed that predict locations of future plasticity or particle rearrangements. An open question is whether similar tools can be used in dense active materials, but a challenge is that under most circumstances, active systems do not possess well-defined solid reference configurations. We develop a computational model for a dense active crowd attracted to a point of interest, which does permit a mechanically stable reference state in the limit of infinitely persistent motion. Previous work on…
We develop a new method to isolate localized defects from extended vibrational modes in disordered solids. This method augments particle interactions with an artificial potential that acts as a high-pass filter: it preserves small-scale structures while pushing extended vibrational modes to higher frequencies. The low-frequency modes that remain are "bare" defects; they are exponentially localized without the quadrupolar tails associated with elastic interactions. We demonstrate that these localized excitations are excellent predictors of plastic rearrangements in the solid. We characterize se…
Disordered packings of unbonded, semiflexible fibers represent a class of materials spanning contexts and scales. From twig-based bird nests to unwoven textiles, bulk mechanics of disparate systems emerge from the bending of constituent slender elements about impermanent contacts. In experimental and computational packings of wooden sticks, we identify prominent features of their response to cyclic oedometric compression: non-linear stiffness, transient plasticity, and eventually repeatable velocity-independent hysteresis. We trace these features to their micromechanic origins, identified in c…
Upon mechanical loading, granular materials yield and undergo plastic deformation. The nature of plastic deformation is essential for the development of the macroscopic constitutive models and the understanding of shear band formation. However, we still do not fully understand the microscopic nature of plastic deformation in disordered granular materials. Here we used synchrotron X-ray tomography technique to track the structural evolutions of three-dimensional granular materials under shear. We establish that highly distorted coplanar tetrahedra are the structural defects responsible for micr…
Plastic yield of amorphous solids occurs by power law distributed slip avalanches whose universality is still debated. Determination of the power law exponents from experiments and molecular dynamics simulations is hampered by limited statistical sampling. On the other hand, while existing elasto-plastic depinning models give precise exponent values, these models to date have been limited to a scalar approximation of plasticity which is difficult to reconcile with the statistical isotropy of amorphous materials. Here we introduce for the first time a fully tensorial mesoscale model for the ela…
We show that quasi localized low-frequency modes in the vibrational spectrum can be used to construct soft spots, or regions vulnerable to rearrangement, which serve as a universal tool for the identification of flow defects in solids. We show that soft spots not only encode spatial information, via their location, but also directional information, via directors for particles within each soft spot. Single crystals with isolated dislocations exhibit low-frequency phonon modes that localize at the core, and their polarization pattern predicts the motion of atoms during elementary dislocation gli…
A mesoscopic model of amorphous plasticity is discussed in the context of depinning models. After embedding in a d + 1 dimensional space, where the accumulated plastic strain lives along the additional dimension, the gradual plastic deformation of amorphous media can be regarded as the motion of an elastic manifold in a disordered landscape. While the associated depinning transition leads to scaling properties, the quadrupolar Eshelby interactions at play in amorphous plasticity induce specific additional features like shear-banding and weak ergodicity breakdown. The latters are shown to be co…
Structural heterogeneity of amorphous solids present difficult challenges that stymie the prediction of plastic events, which are intimately connected to their mechanical behavior. Based on a perturbation analysis of the potential energy landscape, we derive the atomic nonaffinity as an indicator with intrinsic orientation, which quantifies the contribution of an individual atom to the total nonaffine modulus of the system. We find that the atomic nonaffinity can efficiently characterize the locations of the shear transformation zones, with a predicative capacity comparable to the best indicat…
All solids yield under sufficiently high mechanical loads. Below yield, the mechanical responses of all disordered solids are nearly alike, but above yield every different disordered solid responds in its own way. Brittle systems can shatter without warning, like ordinary window glass, or exhibit strain localization prior to fracture, like metallic or polymeric glasses. Ductile systems, e.g. foams like shaving cream or emulsions like mayonnaise, can flow indefinitely with no strain localization. While there are empirical strategies for tuning the degree of strain localization, there is no fram…
Much of the progress achieved in understanding plasticity and failure in amorphous solids had been achieved using experiments and simulations in which the materials were loaded using strain control. There is paucity of results under stress control. Here we present a new method that was carefully geared to allow loading under stress control either at $T=0$ or at any other temperature, using Monte-Carlo techniques. The method is applied to a model perfect crystalline solid, to a crystalline solid contaminated with topological defects, and to a generic glass. The highest yield stress belongs to t…
A wide range of materials can exist in microscopically disordered solid forms, referred to as amorphous solids or glasses. Such materials -- oxide glasses and metallic glasses, to polymer glasses, and soft solids such as colloidal glasses, emulsions and granular packings -- are useful as structural materials in a variety of contexts. Their deformation and flow behaviour is relevant for many others. Apart from fundamental questions associated with the formation of these solids, comprehending their mechanical behaviour is thus of interest, and of significance for their use as materials. In parti…
Disordered and amorphous materials often retain memories of perturbations they have experienced since preparation. Studying such memories is a gateway to understanding this challenging class of systems, yet it often requires the ability to measure local structural changes in response to external drives. Here we show that dissipation is a generic macroscopic indicator for the memory of the largest perturbation. Through experiments in crumpled sheets under cyclic drive, we show that dissipation transiently increases when first surpassing the largest perturbation due to irreversible structural ch…
Plasticity in soft amorphous materials typically involves collective deformation patterns that emerge upon intense shearing. The microscopic basis of amorphous plasticity has been commonly established through the notion of "Eshelby"-type events, localized abrupt rearrangements that induce flow in the surrounding material via non-local elastic-type interactions. This universal mechanism in flowing disordered solids has been proposed despite their diversity in terms of scales, microscopic constituents, or interactions. However, we argue that the presence of frictional interactions in granular so…
We consider disordered solids in which the microscopic elements can deform plastically in response to stresses on them. We show that by driving the system periodically, this plasticity can be exploited to train in desired elastic properties, both in the global moduli and in local "allosteric" interactions. Periodic driving can couple an applied "source" strain to a target strain over a path in the energy landscape. This coupling allows control of the system's response even at large strains well into the nonlinear regime, where it can be difficult to achieve control simply by design.
The deformation of disordered solids relies on swift and localised rearrangements of particles. The inspection of soft vibrational modes can help predict the locations of these rearrangements, while the strain that they actually redistribute mediates collective effects. Here, we study soft modes and strain redistribution in a two-dimensional continuous mesoscopic model based on a Ginzburg-Landau free energy for perfect solids, supplemented with a plastic disorder potential that accounts for shear softening and rearrangements. Regardless of the disorder strength, our numerical simulations show …
University of Milan（米兰大学）；University of Greifswald（格赖夫斯瓦尔德大学）；University of Amsterdam（阿姆斯特丹大学）；DEVCOM Army Research Laboratory（德文康姆陆军研究实验室）；Indian Institute of Science Education and Research Pune（印度科学教育与研究学院浦那分校）
Collagen forms the structural scaffold of connective tissues in all mammals. Tissues are remarkably resistant against mechanical deformations because collagen molecules hierarchically self-assemble in fibrous networks that stiffen with increasing strain. Nevertheless, collagen networks do fracture when tissues are overloaded or subject to pathological conditions such as aneurysms. Prior studies of the role of collagen in tissue fracture have mainly focused on tendons, which contain highly aligned bundles of collagen. By contrast, little is known about fracture of the orientationally more disor…
Disordered mechanical systems can deform along a network of pathways that branch and recombine at special configurations called bifurcation points. Multiple pathways are accessible from these bifurcation points; consequently, computer-aided design algorithms have been sought to achieve a specific structure of pathways at bifurcations by rationally designing the geometry and material properties of these systems. Here, we explore an alternative physical training framework in which the topology of folding pathways in a disordered sheet is changed in a desired manner due to changes in crease stiff…
Various disordered dense systems such as foams, gels, emulsions and colloidal suspensions, exhibit a jamming transition from a liquid state (they flow) to a solid state below a yield stress. Their structure, thoroughly studied with powerful means of 3D characterization, exhibits some analogy with that of glasses which led to call them soft glassy materials. However, despite its importance for geophysical and industrial applications, their rheological behavior, and its microscopic origin, is still poorly known, in particular because of its nonlinear nature. Here we show from two original experi…
The deformation and flow of disordered solids, such as metallic glasses and concentrated emulsions, involves swift localized rearrangements of particles that induce a long-range deformation field. To describe these heterogeneous processes, elastoplastic models handle the material as a collection of 'mesoscopic' blocks alternating between an elastic behavior and plastic relaxation, when they are too loaded. Plastic relaxation events redistribute stresses in the system in a very anisotropic way. We review not only the physical insight provided by these models into practical issues such as strain…
We describe the shear flow of a disordered granular material in the presence of grain fracture using the shear-transformation-zone (STZ) theory of amorphous plasticity adapted to systems with a hard-core inter-particle interaction. To this end, we develop the equations of motion for this system within a statistical-thermodynamic framework analogous to that used in the analysis of molecular glasses. For hard-core systems, the amount of internal, configurational disorder is characterized by the compactivity $X = \partial V / \partial S_C$, where $V$ and $S_C$ are respectively the volume and conf…
