In this paper, we investigate joint source precoding matrices and relay processing matrix design for multi-user multiple-input multiple-output~(MU-MIMO) non-regenerative relay networks in the presence of the direct source-destination~(S-D) links. We consider both capacity and mean-squared error~(MSE) criterions subject to the distributed power constraints, which are nonconvex and apparently have no simple solutions. Therefore, we propose an optimal source precoding matrix structure based on the point-to-point MIMO channel technique, and a new relay processing matrix structure under the modified power constraint at relay node, based on which, a nested iterative algorithm of jointly optimizing sources precoding and relay processing is established. We show that the capacity based optimal source precoding matrices share the same structure with the MSE based ones. So does the optimal relay processing matrix. Simulation results demonstrate that the proposed algorithm outperforms the existing results.
In this work, we provide a global framework analysis of a multi-hop relaying systems wherein the transmitter (TX) communicates with the receiver (RX) through a set of intermediary relays deployed either in series or in parallel. Regenerative based relaying scheme is assumed such as the repetition-coded decoded-and-forward (DF) wherein the decoding is threshold-based. To reflect a wide range of fading, we introduce the generalized $H$-function (also termed as Fox-$H$ function) distribution model which enables the modeling of radio-frequency (RF) fading like Weibull and Gamma, as well as the fre…
Relay selection is considered to enhance the secrecy of a dual-hop regenerative multi-relay system with an eavesdropper. Without assuming perfect decoding at the relays, the secrecy outage probability of a single relay system is obtained first. Secrecy outage of optimal, traditional and suboptimal relay selection schemes is then evaluated. To reduce the power consumption, partial relay selection schemes based only on either of the source-relay or relay-destination instantaneous channel state information (ICSI) are introduced. Its secrecy outage is evaluated and compared with the other schemes.…
We propose a greedy minimum mean squared error (MMSE)-based antenna selection algorithm for amplify-and-forward (AF) multiple-input multiple-output (MIMO) relay systems. Assuming equal-power allocation across the multi-stream data, we derive a closed form expression for the mean squared error (MSE) resulted from adding each additional antenna pair. Based on this result, we iteratively select the antenna-pairs at the relay nodes to minimize the MSE. Simulation results show that our algorithm greatly outperforms the existing schemes.
We consider a multiple-input multiple-output (MIMO) relaying boardcast channel in downlink cellular networks, where the base station and the relay stations are both equipped with multiple antennas, and each user terminal has only a single antenna. In practical scenarios, channel estimation is imperfect at the receivers. Aiming at maximizing the SINR at each user, we develop two robust linear beamforming schemes respectively for the single relay case and the multi-relay case. The two proposed schemes are based on sigular value decomposition (SVD), minimum mean square error (MMSE) and regularize…
In this paper, we consider a dual-hop Multiple Input Multiple Output (MIMO) wireless relay network in the presence of imperfect channel state information (CSI), in which a source-destination pair both equipped with multiple antennas communicates through a large number of half-duplex amplify-and-forward (AF) relay terminals. We investigate the performance of three linear beamforming schemes when the CSI of relay-to-destination (R-D) link is not perfect at the relay nodes. The three efficient linear beamforming schemes are based on the matched-filter (MF), zero-forcing (ZF) precoding and regular…
This paper deals with the problem of jointly designing the source precoder, the relaying matrices, and the destination equalizer in a multiple-relay amplify-and-forward (AF) cooperative multiple-input multiple-output (MIMO) wireless network, when partial channel-state information (CSI) is available. Specifically, the considered approaches are based on the knowledge of instantaneous CSI of the first-hop channel matrix, whereas only statistical CSI of the second-hop channels is assumed. In such a scenario, with respect to the case when instantaneous CSI of both the first- and second-hop MIMO cha…
We investigate a multi-pair two-way decode-andforward relaying aided massive multiple-input multiple-output antenna system under Rician fading channels, in which multiple pairs of users exchange information through a relay station having multiple antennas. Imperfect channel state information is considered in the context of maximum-ratio processing. Closedform expressions are derived for approximating the sum spectral efficiency (SE) of the system. Moreover, we obtain the powerscaling laws at the users and the relay station to satisfy a certain SE requirement in three typical scenarios. Finally…
In this letter, a novel linear transmission strategy to design the linear precoding matrix~(PM) at base station~(BS) and the beamforming matrix~(BM) at relay station~(RS) for multiple-input multiple-output~(MIMO) relaying broadcast channels with direct channel (DC) is proposed, in which a linear PM is designed at BS based on DC, and the RS utilizes the PM, the backward channel and the forward channel to design the linear BM. We then give a quite tight lower bound of the achievable sum-rate of the network with the proposed strategy to measure the performance. The sum-rates achieved by the propo…
Maximizing the minimum rate for a full-duplex multiple-input multiple-output (MIMO) wireless network encompassing two sources and a two-way (TW) relay operating in a two hop manner is investigated. To improve the overall performance, using a zero-forcing approach at the relay to suppress the residual self-interference arising from full-duplex (FD) operation, the underlying max-min problem is cast as an optimization problem which is non-convex. To circumvent this issue, semidefinite relaxation technique is employed, leading to upper and lower bound solutions for the optimization problem. Numeri…
In this paper, multi-stream transmission in interference networks aided by multiple amplify-and-forward (AF) relays in the presence of direct links is considered. The objective is to minimize the sum power of transmitters and relays by beamforming optimization under the stream signal-to-interference-plus-noise-ratio (SINR) constraints. For transmit beamforming optimization, the problem is a well-known non-convex quadratically constrained quadratic program (QCQP) that is NP-hard to solve. After semi-definite relaxation (SDR), the problem can be optimally solved via alternating direction method …
In this paper, we consider the amplify-and-forward relay networks in mmWave systems and propose a hybrid precoder/combiner design approach. The phase-only RF precoding/combining matrices are first designed to support multi-stream transmission, where we compensate the phase for the eigenmodes of the channel. Then, the baseband precoders/combiners are performed to achieve the maximum mutual information. Based on the data processing inequality for the mutual information, we first jointly design the baseband source and relay nodes to maximize the mutual information before the destination baseband …
In this paper, we analyze the asymptotic rate for a multi-carrier (MC) full-duplex (FD) massive multiple input multiple output (mMIMO) decode and forward (DF) relay system which serves multiple MC single-antenna half-duplex (HD) nodes. We take into account the impact of hardware distortions resulting in residual self-interference (SI) and inter-carrier leakage (ICL) as well as the impact of imperfect channel state information (CSI). We derive the asymptotic rate expression of our system employed with maximum ratio transmitting (MRT)/ maximum ratio combining (MRC) strategy when the number of th…
Most of the indoor coverage issues arise from network deployments that are usually planned for outdoor scenarios. Moreover, the ever-growing number of devices with different Radio Access Technologies (RATs), expected for new 5G scenarios and to maintain compatibility with older cellular standards (mostly 3G/4G), worsen this situation thus calling for novel bandwidth-efficient, low-latency and cost-effective solutions for indoor coverage. To solve this problem, Centralized Radio Access Network (C-RAN) architectures have been proposed to provide dense and controlled coverage inside buildings. Ho…
In this letter, we address the optimal source and relay matrices design for the multiple-input multiple-output~(MIMO) relaying broadcast channels~(BC) with direct links~(DLs) based on weighted sum-rate criterion.This problem is nonlinear nonconvex and its optimal solution remains open. To develop an efficient way to solve this problem,we first set up an equivalent problem, and solve it by decoupling it into two tractable subproblems. Finally, we propose a general linear iterative design algorithm based on alternative optimization. This iterative design algorithm is convergent since the solutio…
In this paper we study on a massive MIMO relay system with linear precoding under the conditions of imperfect channel state information at the transmitter (CSIT) and per-user channel transmit correlation. In our system the source-relay channels are massive multiple-input multiple-output (MIMO) ones and the relay-destination channels are massive multiple-input single-output (MISO) ones. Large random matrix theory (RMT) is used to derive a deterministic equivalent of the signal-to-interference-plus-noise ratio (SINR) at each user in massive MIMO amplify-forward and decode-forward (M-MIMO-ADF) re…
In this paper, we consider a dual-hop Multiple Input Multiple Output (MIMO) wireless multi-relay network, in which a source-destination pair both equipped with multiple antennas communicates through multiple half-duplex amplify-and-forward (AF) relay terminals which are also with multiple antennas. Since perfect channel state information (CSI) is difficult to obtain in practical multi-relay network, we consider imperfect CSI for all channels. We focus on maximizing the signal-to-interference-plus-noise ratio (SINR) at the destination. We propose a novel robust linear beamforming at the relays,…
We present a novel approach to maximizing the transmission rate in a MIMO relay system, where all nodes are equipped with multiple antennas and the relay is self-sustained by harvesting energy. We formulate an optimization problem and use dual-characterization to derive a closed-form solution for the optimal power splitting ratio and precoding design. We propose an efficient primal-dual algorithm to jointly optimize the power allocation at source and relay for transmission and the power splitting at relay for energy harvesting, and show that using non-uniform power splitting is optimal. Numeri…
This paper investigates wireless information and power transfer in a full-duplex MIMO relay channel where the self-sustained relay harvests energy from both source transmit signal and self-interference signal to decode and forward source information to a destination. We present a novel technique to jointly optimize power splitting at the relay and precoding design (power allocation) for both the source and relay transmissions. We formulate a new convex optimization problem, establish the dual problem via closed-form optimal primal solutions, and design an efficient primal-dual algorithm to max…
Unmanned aerial vehicles provide new opportunities for performance improvements in future wireless communications systems. For example, they can act as relays that extend the range of a communication link and improve the capacity. Unlike conventional relays that are deployed at fixed locations, UAVs can change their positions to optimize the capacity or range on demand. In this paper, we consider using a swarm of UAVs as amplify-and-forward MIMO relays to provide connectivity between an obstructed multi-antenna equipped source and destination. We start by optimizing UAV placement for the singl…
In this work, we consider the design of hybrid analog-digital (HAD) multi-carrier MIMO-OFDM two-way relaying systems, where the relay station is equipped with a HAD amplify-and-forward architecture and every mobile station is equipped with a fully-digital beamforming architecture. We propose a sub-optimal solution by reformulating the original non-convex problem as a constrained Tucker2 decomposition with the objective of minimizing the sum Euclidean-norm between the HAD amplification matrices and their fully-digital counterparts. For the fully-digital amplification matrix design, we use a Fro…
In this paper, we study a massive multiple-input multiple-output (mMIMO) relay network where multiple source-destination pairs exchange information through a common relay equipped with a massive antenna array. The source users perform simultaneous wireless information and power transfer (SWIPT) and the power-splitting (PS) scheme is used at the relay to first harvest energy from the received signals, and then, to transmit the decoded signals using the harvested energy. Relay performs maximum ratio combining/maximum ratio transmission (MRC/MRT) beam-forming on the received signal. Under the thr…
While the combination of multi-antenna and relaying techniques has been extensively studied for Long Term Evolution Advanced (LTE-A) and Internet of Things (IoT) applications, it is expected to still play an important role in 5th Generation (5G) networks. However, the expected benefits of these technologies cannot be achieved without a proper system design. In this paper, we consider the problem of jointly optimizing terminal precoders/decoders and relay forwarding matrices on the basis of the sum mean square error (MSE) criterion in multiple-input multiple-output (MIMO) two-way relay systems,…
